Frei lesbar · kostenloses Konto zum MitmachenNachfolger von Anticars (2000)

Chevrolet Camaro (third generation)

1981–1992 · 24 dokumentierte Mängel · 1 Märkte
Modelljahr
RückrufKritischMotorJP

燃料タンク

燃料タンクの給油管接合部に溶接不良のものがあるため、燃料を一杯に給油した場合、 当該給油管接合部から燃料が漏れ、最悪の場合、火災に至るおそれがある。

MLIT · Japan1. Sept. 19941205330Modelljahre 1990–1991Im Original (Japanisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischMotorNA

Kraftstoffsystem

Diese Fahrzeuge könnten Risse oder "Pinholes" (feine Lecklöcher) an der Lötverbindung des Tankeinfüllstutzens aufweisen. Dies könnte zu Kraftstoffgeruch oder Kraftstoffaustritt führen. Bei Vorhandensein einer Zündquelle könnte ein Kraftstoffaustritt aufgrund dieses Zustands einen Fahrzeugbrand verursachen. Korrektur: Kraftstofftanks an betroffenen Fahrzeugen werden auf Undichtigkeiten geprüft und bei Bedarf ersetzt.

Transport Canada21. Apr. 19941994078Modelljahre 1991Automatisch übersetzt · Original: EnglischDetails ansehen →
RückrufKritischMotorNA

Fuel System

Note: Vehicles equipped with 5.0 litre and 5.7 litre engines. Vehicles may have fuel return hoses which could break at either or both crimped couplings. If a coupling were to separate, fuel leakage and a possible engine compartment fire could result. Correction: A properly crimped fuel return hose will be installed on all involved vehicles.

Transport Canada11. Juni 19901990084Modelljahre 1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischMotorNA

Fuel System

Note: Vehicles equipped with 2.8.L v6 engines. The fuel feed hoses may pull out of the crimped coupling at the engine end of the hose assembly. This could result in fuel leakage and an engine compartment fire. Correction: A redesigned fuel feed hose will be installed on all involved vehicles.

Transport Canada6. Juni 19901990081Modelljahre 1988–1989Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischBremsenNA

Rückruf

Due to undersized grinding at the time of manufacture, the rear brake centre flex hoses could separate from the end fittings when subjected to the pull force required by cmvss 106-74. Tensile strangth test. Such a separation would result in loss of brake fluid and a partial loss of braking action. Should this happen while the vehicle is in motion, at a time when minimum stopping distances are required, a vehicle crash could occur without prior warning.

Transport Canada31. Aug. 19841984098Modelljahre 1984Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischInnenraumNA

Seat belts:Front:Anchorage

The involved vehicles do not conform to federal motor vehicle safety standard no. 210, "seat belt assembly anchorages". The non-compliance exists because the rear seat belt anchorages may pull through the underbody of the vehicle if enough force is applied.

NHTSA · USA21. Sept. 198282V089000Modelljahre 1982Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischMotorNA

Fuel system, gasoline:Storage:Tank assembly

Fuel tank ventilator valve in the fuel system may produce a loud and persistent "whistle" during venting of the tank. If the fuel filler cap is removed while this condition exists and the tank is more than 3/4 full, gasoline may be forced out of the filler neck onto bystanders.

NHTSA · USA29. Juli 198282V076000Modelljahre 1982Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischMotorNA

Fuel System

On certain Trans Am and Camaro Z28 vehicles with crossfire fuel injection engines, the fuel tank ventilator valve may produce a loud and persistant whistle during tank venting. If the fuel filler cap is removed while this condition exists and the tank is 3/4 full,gasoline may be forced out of the filler neck,creating the risk of fire.

Transport Canada22. Juli 19821982061Modelljahre 1982Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seats:Front assembly:Recliner

The front seat upper hinge cover screws are too long, and interfere with the seat back inertia lock. This prevents the seat back from locking properly.

NHTSA · USA3. Mai 199191V074000Modelljahre 1991Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seats And Restraints

These vehicles may not comply with c.M.V.S.S. 209 - seat belt assemblies. - seat belt latch plates may not engage or may do so only after wiggling and/or forcing the latch plate. Correction: Vehicles will be inspected and suspect retractor side safety belt assemblies (which include latch plates) will be replaced if necessary.

Transport Canada29. Apr. 19911991069Modelljahre 1991Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seat belts:Front:Anchorage

The metal latchplates may not engage the buckle assemblies, causing a "no latch" condition. Movement of the seat occupant in this condition could cause latchplate release from the buckle.

NHTSA · USA22. Apr. 199191V067000Modelljahre 1991Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelBremsenNA

Brakes

On certain vehicles, the parking brake system may contain a non-functional parking brake adjuster. This may result in a gradual loss of parking brake effectiveness as the rear disc pads wear. As a result, the parking brake may not hold the vehicle on a steep incline. If the vehicle is parked with the transmission in neutral or a forward gear, the vehicle may roll away and result in personal injury or property damage. Correction: A new parking brake adjuster will be installed.

Transport Canada17. Apr. 19911991063Modelljahre 1982–1986Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelBremsenNA

Parking brake:Conventional

Parking brake adjuster fails to operate and do not work after brake pad wear.

NHTSA · USA11. Apr. 199191V055000Modelljahre 1982–1986Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelKarosserieNA

Visibility:Windshield

Poor bond adhesion between the windshield glass and the mounting, which could allow the windshield to separate from the vehicle during a collision. This fails to conform with fmvss 212.

NHTSA · USA19. Feb. 199191V031000Modelljahre 1991Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seats And Restraints

On certain vehicles, the seat belt buckle assemblies may not latch or release due to fracture of the red push button. This would prevent a person from using his or her seat belt thereby increasing the risk of injury in the event of a sudden stop or collision. Correction: Seat belt buckles will be inspected and defective assemblies will be replaced.

Transport Canada19. Juni 19901990091Modelljahre 1984–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seat belts:Front:Buckle assembly

Plastic components of seat belt buckle assemblies do not contain an ultra violet stabilizer, and exposure to direct sunlight and elevated interior temperatures could weaken the plastic components.

NHTSA · USA14. Mai 199090V105000Modelljahre 1984–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seat belts

Webbing on the buckle portion of the rear lap/shoulder belts may be too long.

NHTSA · USA13. Dez. 198888V191000Modelljahre 1989Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seats And Restraints

Note: Camaro convertibles only vehicles may have been produced with rear inboard seat belts that are too long. In the event of a vehicle crash, this condition could increase the risk of injury to occupants in the rear seat positions. Correction: Both rear inboard seat belts will be replaced on involved vehicles.

Transport Canada10. Nov. 19881988155Modelljahre 1989Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelMotorNA

Emissions

These vehicles do not comply with c.M.V.S.S. 1105 - evaporative emissions.

Transport Canada17. Okt. 19881988145Modelljahre 1985Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelMotorNA

Emissions

Certain vehicles may not comply with the requirements of CMVSS 1105 - Evaporative Emissions.

Transport Canada9. März 19881988030Modelljahre 1984Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelElektrikNA

Außenbeleuchtung:Scheinwerfer:Schalter

Der Push-Pull-Lichtschalter kann elektrische Kontakte aufweisen, die einen intermittierenden Scheinwerferstromkreis zulassen, wodurch die Scheinwerfer flackern oder plötzlich ausfallen können. Folgen des Defekts: Ein plötzlicher Ausfall der Scheinwerfer bei starkem Wetter oder bei Fahrten in der Nacht kann die Sicht des Fahrers einschränken, was ohne vorherige Warnung zu einem Fahrzeugunfall führen könnte.

NHTSA · USA19. Sept. 198686V131000Modelljahre 1986Automatisch übersetzt · Original: EnglischDetails ansehen →
RückrufMittelElektrikNA

Lights And Instruments

On certain vehicles, the push-pull headlight switch may have been manufactured with electrical contacts which allow an intermittent headlight circuit. An intermittent circuit could cause the headlights to suddenly go out. Under severe weather or nighttime driving conditions, driver visibility could be reduced, possibly resulting in a vehicle crash.

Transport Canada6. Mai 19861986051Modelljahre 1986Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Ältere →

Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).