Steering:Hydraulic power assist:Hose, piping, and connections
The power steering gear inlet hose on these vehicles can fracture, causing power steering fluid to spray from hose into the engine compartment.
🔔 Kostenloses Konto anlegen und Benachrichtigungen zu Chevrolet Corvette (C4) erhalten
The power steering gear inlet hose on these vehicles can fracture, causing power steering fluid to spray from hose into the engine compartment.
The power steering inlet hose may fracture causing power steering fluid to spray out of the hose and, in the presence of an ignition source, an engine compartment fire could result. Correction: Power steering gear inlet hose will be replaced on involved vehicles.
Under certain vehicle operations and occupant usage conditions, the safety belts can lockup or jam in the safety belt retractor.
The fuel feed and return lines on these vehicles were built with the incorrect line end flare configuration. If these lines are left uncorrected the line ends could crack, causing a fuel leak and a risk of an engine compartment fire. Correction: New fuel lines with the correct end flare configuration will be installed on affected vehicles.
Fuel feed and return line connectors have incorrect line end flare configurations.
On vehicles with 17" wheels, the weld attaching the wheel centre to the rim may be missing. Depending on conditions, the weld centre could separate from the rim or rotate within the rim. This could result in partial loss of steering control and brakes, loss of tire air pressure and sudden change in vehicle direction, possibly resulting in a crash without prior warning. Correction: Wheels will be inspected and those with missing welds will be replaced.
Missing weld that attaches wheel center to the rim could allow wheel center to separate from the rim.
燃料蒸発ガス抑止装置に使用されているゴム製ホースが材質不良のため、このままの状 態で使用を続けると、当該ホースにひび割れが発生し、最悪の場合、燃料蒸発ガスが大気 中に放出されるおそれがある。
These vehicles may not comply with c.M.V.S.S. 1105 - evaporative emissions. Two (2) suspect evaporative emission hoses may deteriorate, crack and leak. Correction: Suspect evaporative emission hoses will be replaced with improved hoses which will be secured with hose clamps.
Note: Owner self inspection - repair only if problem occurs. The seat belt may lock-up or jam in the retractor. If this occurs, vehicle occupants will be unable to use the seat belt. Thus, in the event of a vehicle crash, unbelted occupants will be more at risk of injury. Correction: Vehicles will be inspected and any retractor side belts locking up or jammed will be replaced.
Rear wheel tie rod assembly may fatigue and could fracture at the inboard bearing due to high inner joint rocking torque.
The rear wheel tie rod assembly may fatigue and fracture at the inboard bearing due to high inner-joint rocking torque. A fracture in this assembly could result in loss of vehicle control and a crash without prior warning
Certain severe and unusual braking conditions may cause damage to the brake master cylinder centre valve. If sufficient damage accumulates, loss of front brakes may occur with accompanying increased pedal travel and reduced braking ability. A reduction of braking ability at a time when minimum stopping distance is required could result in a vehicle crash without prior warning. Correction: Dealers will install a brake master cylinder piston kit on all involved vehicles.
Severe and unusual braking conditions may cause damage to the brake master cylinder center valve. Consequence of defect: If sufficient damage occurs, loss of front brakes may occur with increased pedal travel and reduced braking ability. The reduction of braking ability at a time when minimum stopping distance is required could result in a vehicle crash without prior warning.
On certain vehicles, the push-pull headlight switch may have been manufactured with electrical contacts which allow an intermittent headlight circuit. An intermittent circuit could cause the headlights to suddenly go out. Under severe weather or nighttime driving conditions, driver visibility could be reduced, possibly resulting in a vehicle crash.
Der Zug-Drück-Lichtschalter kann elektrische Kontakte aufweisen, die einen intermittierenden Scheinwerferstromkreis zulassen, wodurch die Scheinwerfer flackern oder plötzlich ausgehen können. Folge des Defekts: Ein plötzlicher Ausfall der Scheinwerfer bei starkem Wetter oder bei Fahrten in der Nacht könnte die Sicht des Fahrers einschränken, was ohne vorherige Warnung zu einem Fahrzeugunfall führen könnte. Hinweis: Siehe auch NHTSA-Kampagnennummer 86V131000.
Cars may lose the wire snap rings that hold the differential cross shaft in position in the rear axle differential case assembly, allowing the shaft to move. Consequence of defect: The cross shaft movement could cause the shaft to contact the carrier or pinion teeth, possibly locking up the rear wheels and result in a crash without prior warning.
Corrosion and deterioration of an electronic component within the mass air flow sensor results in a low signal voltage to the electronic control module reducing fuel delivery. This causes stalling at engine idle or a no-start condition.
The cruise control vacuum solenoid valves may malfunction at any- time the engine is running with the cruise control engaged, resulting in unexpected engine acceleration.
The cruise control vacuum solenoid valves may malfunction at any time the engine is running and the cruise control is engaged and cause unexpected engine acceleration. Consequence of defect: Loss of accelerator control could result in a vehicle crash without prior warning.
The insulation of the battery cable, because of its position, rubs against some of the engine wiring components. Once the insulation is worn through, the battery could rapidly discharge.
The insulation of the positive battery cable may rub against the engine wiring harness bracket or ground stud. If the insulation wears through, it could result in rapid battery discharge and loss of headlights. Sudden loss of headlights under severe weather or night driving conditions could result in vehicle crash without prior warning.
Attaching bolts were mistakenly coated with a slippery material during production. This material will act as a lubricant and bolts may loosen and eventually fall off.
The front brake caliper bracket to steering knuckle attaching bolts may loosen and fall out. The front brake caliper may then become partially detached from the knuckle assembly and may cause the wheel to lock. Should this occur while the vehicle is in motion, it could result in loss of control and vehicle crash without prior warning.
Certain Camaro, Firebird, Monte Carlo and Grand Prix equipped with a 5.0L engine, and 5.7L Corvettes. High ignition coil temperatures combined with the stress of higher voltage may break down the coating of the high output ignition coil secondary windings. Declining ignition voltage may lead to engine misfire, hesitation sags or no re-start. Depending on road condition, this could result in a significant safety hazard. Correction: High output ignition coil will be replace, spark plug gap will be revised and a spark plug gap revision label will be installed.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).