燃料ポンプ
燃料ポンプのリターンパイプ取付部の強度が不足しているため、使用過程において亀裂が発生することがある。そのため、そのまま使用を続けると、亀裂が進行して燃料が漏れるおそれがある。
🔔 Kostenloses Konto anlegen und Benachrichtigungen zu Citroën C2 erhalten
燃料ポンプのリターンパイプ取付部の強度が不足しているため、使用過程において亀裂が発生することがある。そのため、そのまま使用を続けると、亀裂が進行して燃料が漏れるおそれがある。
This concern relates to right hand drive vehicles only. There may cases of the brake linkage lever being defectively assembled which may result in a loss of braking efficiency.
Een nabewerking van de traverse van de wielophanging linksachter is niet uitgevoerd. Als gevolg kunnen er barsten in ontstaan en het onderdeel breken.
It has been identified that the position of the exterior lighting control ring may not be detected by the lighting management system and the lights may switch off without warning.
ボディ電装品制御ユニットの前照灯スイッチの位置を識別するプログラムが不適切なため、前照灯スイッチの操作位置を正しく認識できないことがある。そのため、前照灯スイッチがOFFの時に前照灯が点灯する、又は前照灯スイッチがONの時に前照灯が消灯するおそれがある。
It has been identified that due to incorrect positioning of the exterior lighting control ring by the lighting management system the lights may switch off unexpectedly.
The parking brake may fail due to the cable not being manufactured to specification.
制動灯スイッチ内部の接点の電気負荷に対する容量が不足しているため、ブレーキの繰り返し操作により接点が消耗し、制動灯が点灯しなくなり、シフトレバーがパーキング位置から動かなくなる、または再始動できないおそれがある。
An incorrect engine relay unit may have been fitted. This ECU could deteriorate and cause operating faults and perhaps failure of certain equipment
Following a manufacturing issue the rear sear cushion fixings may become damaged and the cushion may not stay in place
ABS(アンチロックブレーキシステム)コントロールユニットの電気回路が不適切なため、バッテリーの電圧が非常に低い状況において、当該ユニットが車速を正確に演算することができないことがある。そのため、制動時にABSが誤作動し、最悪の場合、制動距離が伸びるおそれがある。
If the battery voltage is abnormally low the antilock braking system electronic control unit may not perform to specification which in rare cases may cause a reduction in braking efficiency.
It has been identified that the accelerator pedal can return too slowly. This can have an effect on the driving of the vehicle
In the exceptional event of a spring breaking there could be a risk of the spring making contact with the vehicle tyre.
Contact at full suspension travel may occur between the left hand rear splash shield and the brake hose. This may result in wearing of the hose after a period of time.
The tightening torque for the front suspension wishbone mounting bolts has proved insufficient. This can lead to loosening represented by abnormal noise
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).