Citroen C3 DS3 Driver and Passenger Airbag (Takata)
On affected vehicles the chemicals in the Takata airbags may deteriorate over time which may cause the inflator to rupture and lead to serious injury.
🔔 Kostenloses Konto anlegen und Benachrichtigungen zu Citroën DS3 (alle generationen) erhalten
On affected vehicles the chemicals in the Takata airbags may deteriorate over time which may cause the inflator to rupture and lead to serious injury.
On affected vehicles the chemicals in the Takata airbags may deteriorate over time which may cause the inflator to rupture and lead to serious injury.
運転席用または助手席用のエアバッグのインフレータ(膨張装置)において、ガス発生剤の吸湿防止が不適切であった場合、高い湿度の環境下で温度変化を繰り返すと、ガス発生剤が劣化することがある。そのため、エアバッグ展開時にインフレータ容器が破損するおそれがある。
運転席用または助手席用のエアバッグのインフレータ(膨張装置)において、ガス発生剤の吸湿防止が不適切であった場合、高い湿度の環境下で温度変化を繰り返すと、ガス発生剤が劣化することがある。そのため、エアバッグ展開時にインフレータ容器が破損するおそれがある。
運転席用または助手席用のエアバッグのインフレータ(膨張装置)において、ガス発生剤の吸湿防止が不適切であった場合、高い湿度の環境下で温度変化を繰り返すと、ガス発生剤が劣化することがある。そのため、エアバッグ展開時にインフレータ容器が破損するおそれがある。
It has been established that the high pressure fuel rail pipes on the engine have not been torqued to the correct specification. This can result in poor sealing of the rail which can cause as fuel leak onto the engine. If the vaporised fuel comes into contact with a hot engine component there can be a risk of an engine bay fire.
It is possible that the left hand wheel bolts may not have been torqued to the correct specification. This could lead to noise or vibration from the wheels and if not rectified it could result in wheel detachment and loss of control of the vehicle.
On affected vehicles the drivers airbag nay not be of conformity. This non-conformity could lead to poor deployment of the airbag in the event of a collision.
The fuel tank mounting bolts may have been incorrectly torqued this may cause the mountings to become loose which can lead to stress on the fuel pipes and subsequently a fuel leak.
The front right hand drive-shaft may fail.
タイミングベルトにおいて、特定の燃料や添加剤の影響によるエンジンオイルの変質のため、エンジンオイルに浸された構造のタイミングベルトの劣化が進行しているものがある。そのため、タイミングベルトの表面が剥離してブレーキバキュームポンプが破損し、ブレーキ倍力装置の機能が低下する。
On the affected vehicles the operation of the brake vacuum pump may be affected by material detaching from the timing belt caused by the ageing of the engine oil.
On the affected vehicles the operation of the brake vacuum pump may be affected by material detaching from the timing belt caused by the ageing of the engine oil.
The operation of the brake vacuum pump may be affected due to material detaching from the timing belt.
The brake vacuum pump may be affected by material detaching from the timing belt.
Front air bag igniters may not deploy correctly.
Possible non-conformity in the fuel tank manufacturing process could result in fuel seepage
The calibration of the engine management software could result in emissions of NOx which do not comply with the regulatory limits.
An engine component may not be to specification which could result in loss of engine performance. This may lead to the engine stalling and potentially causing an engine failure. In very unlikely circumstances the vehicle speed may increase without warning but will stop on its own after a few seconds.
Due to a deviation in the production process certain suspension and steering fixings may not have been tightened to the correct torque.
横滑り防止装置(ESP)において、ブレーキ液の圧力を制御する液圧調整器(ESPブロック)の製造が不適切なため、電子制御によるブレーキ液の圧力調整が行われないことがある。そのため、アンチロックブレーキシステム(ABS)及びESP機能が作動せず、最悪の場合、急制動時または、旋回時等に走行安定性を損なうおそれがある。
A component in the gearbox actuator may not be to the correct specification which may affect gear selection.
In the event of emergency braking or during an ESP regulation phase (e.g. avoiding manoeuvre) the hydraulic block may not prevent the locking of a wheel which could affect control of the vehicle.
An oil leak could develop at the turbocharger lubrication union retaining bolt due to a non-conformity of this part.
It is possible that the front subframe and suspension wishbones mounting bolts may not have been torqued to the correct specification. This could result in the mounting bolt working loose and falling from the vehicle plus the possibility of the insecurity of the subframe or the front suspension wishbone. This can cause an issue with the handling or even loss of control of the vehicle.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).