Frei lesbar · kostenloses Konto zum MitmachenNachfolger von Anticars (2000)

DodgeDodge Lancer

1984–1989 · 1 generationen · 3 dokumentierte Mängel · 1 Märkte
Generationen
Modelljahr
MarktAlleNA
RückrufKritischMotorNA

Engine and engine cooling:Engine

The engine valve cover gasket may dislocate and allow an engine oil leak at the gasket.

NHTSA · USA27. Dez. 198989V237000Modelljahre 1989Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischMotorNA

Engine

On vehicles with 2.2 litre or 2.5 litre efi(non-turbo) engine, the valve cover gasket may leak oil creating the potential for an engine compartment fire. Correction: Valve cover gasket will be replaced with a revised cover and rtv sealant applied in place of the gasket.

Transport Canada20. Dez. 19891989178Modelljahre 1989–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischMotorNA

Fuel system, gasoline

Fuel leakage may occur in low ambient temperature operation at connections of an engine compartment fuel supply hose to the pressure regulator and to the fuel rail.

NHTSA · USA1. Juli 198888V105000Modelljahre 1985–1987Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischMotorNA

Fuel System

On certain vehicles equipped with a 2.2 Litre turbo engine, an inadequately tightened fuel hose clamp at the fuel system pressure regulator could result in fuel leakage and provide the potential for an engine compartment fire.

Transport Canada5. Feb. 19851985021Modelljahre 1985Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischMotorNA

Fuel system, gasoline:Delivery:Hoses, lines/piping, and fittings

An engine compartment fuel hose routed to the fuel system pressure regulator may have an inadequately tightened hose clamp. Consequence of defect: The fuel hose could leak and result in an engine compartment fire.

NHTSA · USA1. Jan. 198585V010000Modelljahre 1985Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seats And Restraints

On vehicles with power adjusted bucket seats, the driver's seat frame may fail at one of its four attachments. This can result in fore/aft or lateral movement of the seat. This could cause loss of vehicle control and a possible vehicle crash. Correction: The driver's seat frame will be replaced with a strengthened version. Also, the power adjuster crossmember will be reinforced.

Transport Canada13. Juli 19891989096Modelljahre 1985Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelBremsenNA

Parking brake

Parking brake mechanism component may disengage.

NHTSA · USA20. März 198989V038000Modelljahre 1987Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seats

Drivers seat frame may experience fatigue failure at one (front/outboard) of its four attachments.

NHTSA · USA31. Jan. 198989V011000Modelljahre 1985Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelMotorNA

Emissions

These vehicles do not comply with c.M.V.S.S. 1103 - exhaust emissions. Plugged choke vacuum delay valve. Note: Vehicles equipped with 2.2 litre carbureted engines.

Transport Canada6. Jan. 19871987001Modelljahre 1985–1986Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelElektrikNA

Electrical system:12v/24v/48v battery

Battery cap vents may be partially or completely blocked with plastic flashing. Consequence of defect: A build up of internal gas pressure could occur which could result in case rupture, particularly during post charging. Should a person be in the vicinity of the battery when the case ruptures, they may be injured by the released gases and/or acid.

NHTSA · USA10. Apr. 198686V053000Modelljahre 1986Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seat belts:Front

Required front center seat belt assembly was omitted. Vehicles are not in compliance with the requirements of federal motor vehicle safety standard 209, seat belt assemblies.

NHTSA · USA23. Dez. 198484V163000Modelljahre 1985Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →

Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0).