The normal lockup function of the automatic (passive) belt reel can cause the belt motor winch assembly to lockup such that the passive belt system will not deploy/function or gets stuck at various points along the track causing the kinking or breaking of its cable or detachment of the tongue.
Die Hochspannungsleitung von der Zündspule kann sich von ihrer werksseitigen Position in Richtung des Kraftstoffeinspritzventil-Schlauchs #4a bewegen. Dadurch kann der Schlauch durch Ozon geschädigt werden und möglicherweise Kraftstoff austreten. Solche Undichtigkeiten könnten einen Brand im Motorraum verursachen.
Korrektur: Beide Hochspannungszündkabel der Bänke „a“ und „b“ werden ersetzt. Der Kraftstoffschlauch #4 wird auf Anzeichen von Rissen/Aufplatzen untersucht und bei Bedarf ersetzt.
Das Hochspannungskabel von der Zündspule kann sich vom Fertigungsort aus näher an den Kraftstoffinjektor-Schlauch Nr. 4a verlagern. Dadurch können der äußere und der innere Injektorschlauch durch Ozonalterung reißen oder aufplatzen.
Note: 1978-90 models excessive fuel vapour pressure can occur such that a weakening of the fuel tank structure can result in fuel leaks. In the presence of an ignition source, a vehicle fire could result. Correction: Dealers will install a revised fuel purge system which eliminates excessive vapour pressure build-up.
Transport Canada27. Juli 19901990114Modelljahre 1983–1991Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Xj-s 1982-90 xj12/vanden plas 1980-90 dirt ingress may cause the electronically controlled valves in the cruise control actuator to malfunction. If this occurs, the cruise control will fail to disengage under normal operating conditions resulting in possible loss of driver control. Correction: Cruise control actuator operation will be checked and an additional vacuum dump will be installed.
Transport Canada21. Feb. 19901990034Modelljahre 1982–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Possible fuel leakage from the engine fuel injection system, particularly in the area of the hose/clip fittings. Consequence of defect: The presence of an ignition source, with fuel leakage, could result in an engine compartment fire or the destruction of ignition distributor cap.
NHTSA · USA3. Juli 198585V087000Modelljahre 1980–1985Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Due to misalignment of fuel rail halves and effects of temperature change on the connections, there is the possibility of fuel leakage at the fuel rail joints. Fuel leakage could present the potential for fire. Vin - xj12 - 310613 to 365261 xjs - 104146 to 111980
Transport Canada20. Dez. 19831983118Modelljahre 1980–1982Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Fuel leakage may develop at the two main fuel rail connections. Deterioration at these two connections has been traced to a combination of misalignment of the two rail halves and the effect of temperature changes.
Certain vehicles could be subject to a fuel leakage in the engine compartment due to the possibility of deterioration in the integrity of the high pressure fuel hose connections.
V.I.N. Xj12 - 310613 to 431598 xjs - 104146 to 125224 a potential exists for leakage from the fuel delivery system which could result in engine compartment fires.
Transport Canada3. Juli 19851985080Modelljahre 1980–1985Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The supplier of the fuel cut-off inertia switch made unauthorized changes to the switch contacts. Under certain conditions a high electrical resistance and open circuit may result, preventing current flow to the fuel pump.
Transport Canada22. März 19821982030Modelljahre 1981–1982Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Certain vehicles may be fitted with an unauthorized fuel pump electrical inertia switch. This switch has a tin coating added to the contacts that create the potential for a high electrical resistance. This could cause overheating and possible distortion of the plastic mounting around the fixed contact. This could result in inability to start the vehicle since there is a flow of current to the fuel pump.
NHTSA · USA9. März 198282V022000Modelljahre 1982Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).