Verkohltes Fett kann sich zwischen den Kontaktpunkten im Zündschalter ansammeln, was die Isolierungsleistung im Inneren des Schalters verringert. In diesem Zustand kann der Schalter Wärme erzeugen, was Rauch und im schlimmsten Fall zu einem Brand führt.
Im Zündschalter kann es vorkommen, dass den Kontakten im Schalter eine übermäßige Menge Fett aufgetragen wurde. Durch die Hitze des Lichtbogens, der beim Betätigen des Schalters entsteht, verkohlt das Fett und lagert sich zwischen dem beweglichen und dem festen Kontakt ab, wodurch die Isolationsfähigkeit im Inneren des Schalters abnimmt. Wird der Schalter in diesem Zustand weiter benutzt, kann es zu einer Durchschaltung zwischen den Kontakten kommen. Der Schalter kann sich dann erhitzen und Rauch entwickeln; im schlimmsten Fall besteht die Gefahr eines Brandes.
DIE (Takata) ABS-PLASTIK-GURTLÖSER VORNE BEI DIESEN FAHRZEUGEN KÖNNEN BRECHEN, SODASS PLASTIKTEILE IN DIE SCHNALLE FALLEN. FALLS DIES EINTRITT, KANN ES ZU EINEM ZUSTAND OHNE VERSCHLUSS, FALSCHER VERRIEGELUNG ODER NICHT ZUM LÖSEN KOMMEN, WAS BEI EINEM UNFALL ODER EINEM PLÖTZLICHEN ANHALTEN DAS RISIKO EINER PERSONENVERLETZUNG DARSTELLT. KORREKTUR: DIE VORDEREN GURTSCHNALLEN WERDEN BEI BEDARF REPARIERT ODER ERSETZT.
Transport Canada24. Mai 19951995085Modelljahre 1988–1990Automatisch übersetzt · Original: EnglischDetails ansehen →
The fuel tank straps may not be properly tightened and may rub against the fuel tank. This could cause the tank's protective coating to wear through resulting in surface damage and eventual tank perforation and fuel leakage. Correction: Rubber insulator will be placed between the tank straps and the tank and the tank straps will be properly tightened. Also, a new protective coating will be applied where required. V.I.N. Range: Jm1gd3120j1500014 to jm1gd2210j1537936
Transport Canada8. Dez. 19871987133Modelljahre 1988Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press." if a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.
NHTSA · USA24. Mai 199595V103005Modelljahre 1988–1989Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
At ambient temperatures below -18 degrees celsius, frost may accumulate within the throttle body under conditions of extended constant speed operation. This could result in a heavy accelerator pedal and cause uneven throttle valve return. Correction: The single stage engine coolant thermostat will be replaced with a dual stage thermostat equipped with a subvalve to increase the temperature within the throttle body. V.I.N. Range: Jm1gd3120j1500014 to jm1gd2226j1573252.
Transport Canada18. Feb. 19881988021Modelljahre 1988Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Transportation by rail could cause the rear brake shoe web to come off the wheel cylinder piston groove. This condition will cause damage to the wheel cylinder dust boot and may cause dust and water intrusion into the wheel cylinder resulting in piston corrosion. This would inhibit rear brake effectiveness. Correction: Vehicles will be inspected and wheel cylinder dust boot will be replaced where required. All involved vehicles will have lubricant applied to the wheel cylinder piston groove. V.I.N. Range: Jm1gd3120j1500014 to jm1gd2218j1541323
Transport Canada16. Dez. 19871987138Modelljahre 1988Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).