Vehicle description: Passenger cars. The seat belt buckle tongue may not fully eject from the buckle assembly when the release button is pushed slowly. This condition could also result in a partial latch of the tongue in the buckle.
On vehicles equipped with a driver side supplemental air bag, the centre post threads of the air bag module may have been damaged during assembly. In a deployment level collision, the centre post housing may separate from the air bag adapter causing the air bag not to inflate properly. In addition, hot combustion gases would flow directly through the air bag rather than through the normal filtering and cooling devices, presenting the possibility of burn injury to vehicle occupants. Correction: Air bag modules will be inspected and replaced if necessary.
Transport Canada21. Nov. 19901990182Modelljahre 1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Die Ford Motor Company (Ford) ruft bestimmte Modelljahre 2009-2012 Ford Flex, 2008 und 2010-2012 Ford Taurus, 2008-2009 Ford Taurus X, 2008 Mercury Sable, 2009 und 2011 Lincoln MKS Fahrzeuge zurück. Der Frontairbag des Fahrers kann im Falle eines Hochgeschwindigkeitsunfalls während des Auslösens der zweiten Stufe unsachgemäß aufpumpen. Daher entsprechen diese Fahrzeuge nicht den Anforderungen des Federal Motor Vehicle Safety Standard (FMVSS) Nr. 208, "Insassencrashschutz".
Vehicle description: Certain sport utility vehicles, pickup trucks, and passenger vehicles fail to comply with the requirements of fmvss 225, "child restraint anchorage systems." the affected expedition/navigator owner guides do not identify the locations of seating positions equipped with tether anchorages, and do not provide instructions for securing child seats to these tether anchorages. The f150 sc owner guides do not provide the procedure for securing child seats to the tether anchorages. The taurus/sable owner guides do not identify the center rear seating position as having latch compatible lower anchorages.
Vehicle description: Passenger vehicles. The child safety seat anchor latch (iso-fix anchor) fasteners do not have adequate residual torque. The anchors are secured to the floor pan with a reinforcement plate that has two studs that extend upward through the floor pan and the iso-fix anchor. The sealer on the floor pan could cause a soft joint and, even if the nuts are properly torqued, road vibrations could cause the nut to work its way completely off the stud.
NHTSA · USA24. Aug. 200000V240000Modelljahre 2001Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Fahrzeugbeschreibung: Personenkraftwagen. Der Gurtaufroller des Sicherheitsgurts kann einen fehlerhaft ausgeformten Bolzen im umschaltbaren ELR/ALR-Mechanismus aufweisen. Unter bestimmten Umständen könnte der Umschaltmechanismus funktionsunfähig werden, wodurch sich das Gurtband nicht aus dem Aufroller herausziehen lässt. Ebenso ist möglich, dass eine Fehlfunktion des Mechanismus verhindert, dass der Gurt in den ALR-Modus geschaltet werden kann. Der ELR-Mechanismus ist von diesem Zustand nicht betroffen.
These vehicles may have a front seat belt buckle attaching stud that may have been improperly heat treated. This heat treating may have resulted in cracks developing in the stud. If the stud is cracked, there is the potential for less than the intended level of occupant restraint in the event of a vehicle crash. Correction: Seat belt buckle mounting bracket and stud assembly will be replaced on affected vehicles.
Transport Canada28. Aug. 19981998173Modelljahre 1998–1999Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Vehicle description: Passenger vehicles equipped with manual seat tracks. The front seat belt buckle attaching stud may have been improperly heat treated. This heat treatment may have resulted in cracks developing in the stud.
NHTSA · USA25. Aug. 199898V198000Modelljahre 1998–1999Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Seat belt buckles on these vehicles may experience conditions whereby the buckle may not unlatch when the release button is depressed or may not latch, or in some cases, may latch partially but not sufficiently to provide occupant restraint in the event of a collision. Note: Only end-release buckles on "rigid" mountings are susceptible to this malfunction. Correction: Factory installed end-release seat belt buckles will be replaced with redesigned buckles.
Transport Canada29. Sept. 19921992120Modelljahre 1989–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The rigid mounted safety belt buckles are defective in three ways. First, a fastened safety belt buckle will not unlatch when the release button is depressed. This results from interference between the buckle ejector finger and the buckle tongue window. The second defect is the safety belt buckle may not latch. The third possible defect is that the tongue may be retained by the buckle, but it may not be latched sufficiently to provide occupant protection.
NHTSA · USA17. Aug. 199292V113000Modelljahre 1989–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The power seat switch wiring is routed over rather than under the front seat support brace, allowing damage by seat cushion spring ends when seat is occupied.
NHTSA · USA4. März 199191V036000Modelljahre 1988–1989Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The right quarter windows may contain glass which was improperly tempered. This glass may yield pieces larger than the maximum allowed by fmvss 205, glazing material. Consequence of defect: In case of an accident these large pieces of glass may seriously injure the occupants of the car.
NHTSA · USA10. März 198686V039000Modelljahre 1986Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).