Improper routing of the power seat switch wiring will allow the wiring to be contacted and potentially damaged by the seat cushion spring ends when the seat is occupied. This could abrade or puncture the wiring and cause an electrical short which could in turn result in a fire. Correction: Power seat switch wiring will be rerouted and damaged wiring will be replaced.
Transport Canada27. März 19911991055Modelljahre 1988–1989Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The composite construction front brake rotors on these vehicles may corrode, weaken and fracture, resulting in a reduction of braking performance. Such a fracture would result in loss of braking at the corresponding front wheel which could in turn result in increased stopping distance and a possible crash. Correction: Front brake rotors will be replaced.
Transport Canada7. Dez. 19901990193Modelljahre 1986–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
On vehicles equipped with a driver side supplemental air bag, the centre post threads of the air bag module may have been damaged during assembly. In a deployment level collision, the centre post housing may separate from the air bag adapter causing the air bag not to inflate properly. In addition, hot combustion gases would flow directly through the air bag rather than through the normal filtering and cooling devices, presenting the possibility of burn injury to vehicle occupants. Correction: Air bag modules will be inspected and replaced if necessary.
Transport Canada21. Nov. 19901990182Modelljahre 1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Bei Fahrzeugen mit EFI oder CFI kann sich die Federring-Schnellkupplung der Kraftstoffleitung, die die Kraftstoffzufuhr- und Rücklaufleitungen mit den EFI-Kraftstoffverteilern bzw. den CFI-Drosselklappengehäusen verbindet, sowie andere Kraftstoffleitungsanschlüsse nahe der Armaturenbrettverkleidung bei einigen Fahrzeugen während des Fahrzeugbetriebs lösen. Tritt dies auf, kommt es zu einem Kraftstoffverlust, wodurch die Gefahr eines Fahrzeugbrands besteht.
Korrektur: Bei betroffenen Fahrzeugen werden Haltklammern für die Kupplungen installiert.
Hinweis: Escort-Fahrzeuge sind mit EFI und CFI ausgestattet. Lynx-Fahrzeuge sind nur mit CFI ausgestattet.
EFI – Elektronische Kraftstoffeinspritzung
CFI – Zentrale Kraftstoffeinspritzung
The steering column lower shaft may not be properly attached to the steering shaft insulator flange. If the shaft were to separate, total loss of steering control would occur without prior warning, resulting in a possible vehicle crash. Correction: Vehicles will be inspected and, if necessary, the steering shaft assembly will be replaced.
Transport Canada6. Nov. 19861986124Modelljahre 1987Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Steering shaft assemblies contain lower shafts of insufficient length for proper attachment to the shaft insulator flange. Consequence of defect: Shaft could separate, resulting in total loss of steering control and a possible accident.
Vehicle description: Passenger vehicles originally sold or currently registered in connecticut, delaware, district of columbia, illinois, indiana, iowa, kansas, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, nebraska, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, virginia, west virgnia, and wisconsin. The rear lower subframe mount plate nut can experience stress corrosion cracking if subjected to long term exposure to road salts. This can result in fracture and loss of the structural integrity of the subframe mount attachment. Detachment of the body mounts at the rear corners of the subframe, which supports the engine and transmission, allows the rear corners of the subframe to drop.
Compliance testing indicates that these vehicles may be releasing carbon monoxide (co) emissions which exceed the requirements of c.M.V.S.S. 1103 - exhaust emissions. Correction: Catalytic converter will be replaced on affected vehicles.
Transport Canada27. Feb. 19951995038Modelljahre 1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Note: Superseded by 95038. These vehicles may not comply with c.M.V.S.S 1103 - exhaust emissions. Catalysts may be releasing emissions in excess of the standard. Correction: Exhaust system catalysts will be replaced on affected vehicles.
Transport Canada16. Feb. 19951995027Modelljahre 1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
On certain vehicles with 3.0 Litre and 3.8 Litre engines, the body mounts on the rear corners of the subframe which supports the engine and transmission may become detached due to corrosion of the rear lower mount retaining plates, allowing the rear corners of the subframe to drop. Should this occur, steering could become very difficult, thereby adversely affecting vehicle control. Correction: modified lower body mounts and attaching bolts will be installed on affected vehicles.
Transport Canada30. Dez. 19921992166Modelljahre 1986–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Seat belt buckles on these vehicles may experience conditions whereby the buckle may not unlatch when the release button is depressed or may not latch, or in some cases, may latch partially but not sufficiently to provide occupant restraint in the event of a collision. Note: Only end-release buckles on "rigid" mountings are susceptible to this malfunction. Correction: Factory installed end-release seat belt buckles will be replaced with redesigned buckles.
Transport Canada29. Sept. 19921992120Modelljahre 1989–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Note: Vehicles equipped with 3.8 litre engines. These vehicles may not comply with c.M.V.S.S 1105 - evaporative emissions. Correction: Purge valve and hose assembly will be replaced on affected vehicles.
Transport Canada21. Aug. 19921992099Modelljahre 1988–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The rigid mounted safety belt buckles are defective in three ways. First, a fastened safety belt buckle will not unlatch when the release button is depressed. This results from interference between the buckle ejector finger and the buckle tongue window. The second defect is the safety belt buckle may not latch. The third possible defect is that the tongue may be retained by the buckle, but it may not be latched sufficiently to provide occupant protection.
NHTSA · USA17. Aug. 199292V113000Modelljahre 1989–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Hinweis: Betroffen sind auch einige mittelschwere und schwere Lkw. Diese Fahrzeuge erfüllen möglicherweise nicht die Anforderungen von C.M.V.S.S. 108 – Beleuchtung. Das Steuermodul für das Tagfahrlicht kann fehlerhaft arbeiten, wodurch sich die Tagfahrleuchten abschwächen, flackern oder ausgehen können oder in einigen Fällen nach dem Ausschalten der Zündung eingeschaltet bleiben. Korrektur: Das Steuermodul für das Tagfahrlicht wird bei betroffenen Fahrzeugen ersetzt.
Transport Canada30. Juni 19921992077Modelljahre 1990Automatisch übersetzt · Original: EnglischDetails ansehen →
Note: Station wagon vehicles only. Young children left unattended in the vehicle could lock themselves in the footwell area of the rear-facing third seat (or the underfloor storage compartment in station wagons not equipped with the optional third seat). Once the compartment is closed, it cannot be opened from the inside, and there is the danger of air deprivation, excessive body heat and panic response to a child who may have closed himself or herself in the compartment. Correction: A modified latch will be installed which does not have a self-latching feature and allows the compartment cover to be pushed open from the inside.
Transport Canada20. Mai 19921992060Modelljahre 1986–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Children can accidentally lock themselves in the footwell area of the rear-facing third seat, or in the storage compartment in station wagons not equipped with an optional third seat. Once the compartment is closed it cannot be opened from the inside.
NHTSA · USA11. Mai 199292V065000Modelljahre 1986–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The power seat switch wiring is routed over rather than under the front seat support brace, allowing damage by seat cushion spring ends when seat is occupied.
NHTSA · USA4. März 199191V036000Modelljahre 1988–1989Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
This recall supersedes recall 90-27 for vehicles in the maritimes. The throttle may stick in an open position due to linkage binding caused by corrosion. This would cause the engine to run at higher than idle speed when the throttle is released and could adversely affect driver control resulting in a possible crash. Correction: A stainless steel sleeve, which will be placed over the hub on the throttle body assembly, and a secondary throttle lever to fit the sleeve, along with other mounting parts, will be installed on affected vehicles.
Transport Canada11. Feb. 19911991021Modelljahre 1986–1989Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Ranger/bronco ii - 2.9 litre engines taurus/sable - 3.0 litre engines note: Vehicles located in newfoundland, nova scotia, new brunswick and prince edward island. The throttle may stick in an open position due to linkage binding caused by corrosion. This would cause the engine to run at higher than idle speed when the throttle is released and could adversely affect driver control resulting in a possible crash. Correction: On vehicles with 2.9 litre engines, dealers will clean, modify and lubricate the hub pin and lever bushings with a marine-type anti-seize grease. Additionally, on vehicles with 3.0 litre engines, the hub pin lever assembly will be replaced. Note: This recall has been superseded by recall no. 91021.
Transport Canada9. Feb. 19901990027Modelljahre 1986–1989Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
An incorrect transistor in the autolamp headlamp control system module may malfunction and cause the headlamps to turn off while the vehicle is being driven. This could cause impaired driver vision and a possible vehicle crash. Correction: Autolamp light sensor module will be replaced on affected vehicles.
Transport Canada26. Okt. 19891989150Modelljahre 1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Diese Fahrzeuge entsprechen möglicherweise nicht der C.M.V.S.S. 1103 – Abgasemissionen. Die zentrale Kraftstoffeinspritzung (cfi) kann unter bestimmten Betriebsbedingungen fett laufen. Abhilfe: Es werden verbesserte cfi-Kraftstoffeinspritzdüsen eingebaut und die Leerlaufdrehzahl wird angepasst.
Transport Canada13. Juli 19891989099Modelljahre 1986–1987Automatisch übersetzt · Original: EnglischDetails ansehen →
These vehicles do not comply with c.M.V.S.S. 108 - lighting. Vehicles were equipped with clear front side marker lamps and clear bulbs instead of amber bulbs. Correction: Clear front side marker lamp bulbs will be replaced with amber bulbs.
Transport Canada12. Dez. 19881988169Modelljahre 1989Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).