Nissan has identified that the fuel rail pressure sensor of some vehicles may have not been correctly tightened to the fuel rail of the engine and may loosen gradually due to heat and vibration of the engine. If left undetected and the vehicle continues to be driven in this condition in extreme cases fuel leakage may occur.
The engine ignition coil may not be to the correct specification. The internal electrical components of the coil may short circuit resulting in an engine misfire. In the worst case this short circuit may cause a fuse inside the Power Distribution Module (IPDM) to fail stopping power to the ignition relay. In this condition the engine may stall and prevent the customer from being able to restart the engine.
On affected models with a push start ignition switch the switch may remain in the pressed position and not return after switching the engine on. If the vehicle continues to be driven in this condition the emergency engine stop function may operate and cause the engine to unintentionally stop.
DVSA · Vereinigtes Königreich4. Aug. 2015R/2015/133Modelljahre 2013–2015Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
null The push engine start switch may remain in the pressed position and not return after switching the engine on. If the vehicle continues to be driven in this condition, the emergency engine stop function may operate and cause the engine to stop unexpectedly.
Safety Gate · EU30. Juni 2015A12/0850/15Modelljahre 2013–2015Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
It has been identified that it is possible that the contacts in engine control module (ECM) and ignition relay situationed in the Intelligent Power Distribution Module (IPDM) may become contaminated with silicon oxide due to the evaporating of the silicon from within the units. In extreme cases this could result in the stalling of the engine and the failure to restart the engine.
Aufgrund einer unsachgemäßen Befestigung des Kraftstofftanks an der Karosserie konzentrieren sich Spannungen an den oberen Eckbereichen. Wenn sich der Tank durch Wärmeeinflüsse wiederholt ausdehnt und zusammenzieht, kann es an diesen Stellen zu Rissen kommen. Wird das Fahrzeug in diesem Zustand weiterbenutzt, schreiten die Risse fort und können im schlimmsten Fall den Tank durchdringen, sodass bei vollem Tank Kraftstoff austreten kann.
Bei einigen Motordrehzahlsensoren ist die Harzvergussmasse im Inneren nicht ordnungsgemäß eingefüllt. Durch die Wärme des Motors kann sich daher die Lötstelle der Leiterplatte verformen, wodurch es zu einem Kurzschluss kommt und kein korrektes Signal gesendet wird. Dies kann dazu führen, dass der Motor nicht gestartet werden kann oder dass er während der Fahrt stehen bleibt und sich nicht wieder starten lässt.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).