Due to insufficient durability, the Exhaust Gas Recirculation (EGR) cooler may develop an internal coolant leak which could create smouldering deposits inside the EGR cooler and the intake manifold.This may result in localised thermal damage in the intake system, which might lead to engine power reduction and to increased risk of fire.
Safety Gate · EU30. März 2021A12/00444/21Modelljahre 2015–2018Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
It is possible that during the manufacturing process the wall thickness of the high pressure supply pipe may have been reduced. If the driving conditions of the vehicle cause fuel pressure fluctuations this could cause cracking and result in a fuel leak. Also due to gasket fatigue and prolonged usage the high pressure fuel pump check valve may be come loose and leak.
There is a possibility that excessive residual stress remains on the check valve of the fuel pump during the assembly process. If the vehicle is driven with the residual stress the check valve may leak fuel.
DVSA · Vereinigtes Königreich11. Juli 2002R/2002/099Modelljahre 2000–2001Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Affected vehicles have a 2.0 litre turbocharged diesel engine. There is a possibility that the bolts on the exhaust-side of the turbocharger assembly may not have been correctly tightened during manufacture.
There is a possibility that the bolts on the exhaust-side of the turbocharger assembly may not have been correctly tightened due to defective tightening equipment. The bolts could loosen over time, causing insufficient sealing of the turbocharger and could allow exhaust gas leakage from the turbocharger.
Is het voertuig uitgerust met een afneembare trekhaak van het merk Toyota, Lexus of Brink, dan bestaat de kans dat deze in een uitzonderlijk geval, als gevolg van veelvuldig en zwaar gebruik, kan afbreken.
rdw19. März 2013MGP120373Modelljahre 2003–2008Im Original (Niederländisch) angezeigt · Übersetzung ausstehendDetails ansehen →
It has been identified that on affected vehicles condensation resulting from cold-weather use of the heater or other causes may form on the worn surface of a component within the throttle pedal assembly known as the friction device. If this occurs there is a possibility that in the worst case the accelerator pedal may return slowly or does not return to the engine idle position.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).