Due to improper plastic manufacturing of the blow-by heater, irregularities may occur in the insulator of the positive temperature coefficient (PTC) heater element, and over time the PTC heater element may short-circuit, but it is not reliably protected by the fuse. As a result, the PTC heater element may overheat abnormally, melting the outer casing, illuminating the engine warning light, and, in the worst case, leading to a fire.
Due to insufficient design evaluation of the operating circuit for the electric auxiliary coolant pump used to cool the turbocharger, metallic substances may form on the circuit board when the temperature and pressure inside the pump rise. As a result, the circuit may short-circuit, the plug connector may scorch, and in the worst case, a fire may occur.
Some engines are fitted with an additional water pump for the turbo charger. In some circumstances a crack may develop which then leads to melting of the plug connections and the housing. Further heat development may then lead to scorch damage. In exceptional cases such overheating can lead to smouldering of the water pump. If smouldering occurs an engine compartment fire and vehicle fire cannot be excluded.
DVSA · United KingdomApr 27, 2012R/2012/049View details →
On certain passenger vehicles equipped with 8-cylinder engines, a circular retention clip at the quick-release coupling along the fuel supply line was inadvertently not installed.
NHTSA · United StatesJun 23, 200404V303000Model years 2004View details →
In the adjustment units of the intake-side and exhaust-side variable valve timing systems, the bolts may break due to insufficient bolt strength. As a result, the system may not operate properly, the engine warning light may illuminate, and the engine may run poorly. In the worst case, the engine may stop while the vehicle is being driven.
On affected vehicles overtime the aluminium screws can loosen or break on the adjustable variable camshaft timing (VANOS) units potentially resulting in engine emergency mode being activated.
DVSA · United KingdomMay 1, 2024R/2024/191Model years 2010View details →
고압 연료 펌프의 설계 결함으로 내부 롤러의 마모에 의해 쇳가루가 발생하고, 발생된 쇳가루가 연료 공급라인(유량 제어 밸브 및 인젝터)을 막을 수 있으며, 이런 경우 경고등이 점등되고 시동이 꺼질 수 있는 가능성에 따른 리콜
<*대상차량별 생산일자>
BMW 320d: 2011.11.15 ~ 2014.09.17
BMW 320d: 2011.09.14 ~ 2011.09.14
BMW 320d ED: 2015.03.26 ~ 2015.03.26
BMW 325d: 2013.12.18 ~ 2013.12.18
BMW 520d: 2014.01.07 ~ 2014.01.07
BMW 520d: 2010.08.24 ~ 2012.11.28
BMW 520d xDrive: 2016.07.28 ~ 2016.07.28
BMW 530d xDrive: 2013.04.05 ~ 2013.04.05
BMW 640d xDrive Gran Coupe: 2015.03.24 ~ 2016.01.29
BMW 640d xDrive Gran Coupe: 2015.02.03 ~ 2015.02.03
BMW Gran Turismo 30d xDrive: 2013.09.25 ~ 2016.02.19
BMW Gran Turismo EfficientDynamics Edition: 2012.11.22 ~ 2012.12.11
BMW GT 20d: 2012.12.18 ~ 2013.05.17
BMW X3 xDrive20d: 2013.01.05 ~ 2013.01.05
BMW X5 xDrive30d: 2017.02.06 ~ 2017.02.12
BMW X6 xDrive30d: 2014.10.10 ~ 2014.10.10
MOLIT · South KoreaNov 5, 20214101Model years 2010Shown in the original Korean · translation pendingView details →
고압 연료 펌프의 설계 결함으로 내부 롤러의 마모에 의해 쇳가루가 발생하고, 발생된 쇳가루가 연료 공급라인(유량 제어 밸브 및 인젝터)을 막을 수 있으며, 이로 인해 경고등이 점등되고 극히 드문 경우 시동이 꺼질 수 있는 가능성에 따른 리콜 <*대상차량별 생산일자>
BMW 1 Series Sport: 2012.11.21~2013.09.04
BMW 220d Coupe: 2014.01.10~2014.04.01
BMW 320d: 2011.11.11~2015.06.25
BMW 320d: 2010.06.25~2011.06.08
BMW 320d ED: 2011.11.08~2015.03.27
BMW 320d Gran Turismo: 2013.04.02~2015.05.20
BMW 320d Touring: 2013.01.23~2015.02.03
BMW 320d xDrive: 2012.11.21~2014.12.16
BMW 320d xDrive Gran Turismo: 2013.08.07
BMW 320d xDrive Touring: 2013.09.27~2014.01.21
BMW 420d Coupe: 2013.06.28~2014.06.06
BMW 420d Gran Coupe: 2014.05.15~2014.11.07
BMW 420d xDrive Gran Coupe: 2014.03.28~2014.12.12
BMW 435d xDrive Gran Coupe: 2016.01.29
BMW 435d xDrive Gran Coupe: 2017.03.27~2019.02.20
BMW 520d: 2013.07.11~2014.06.23
BMW 520d: 2010.07.14~2013.05.14
BMW 520d xDrive: 2013.07.17~2014.06.28
BMW 530d xDrive: 2013.07.13~2016.07.28
BMW 535d: 2011.09.30~2012.10.11
BMW 640d xDrive Gran Coupe: 2013.04.12~2015.01.13
BMW 640d xDrive Gran Coupe: 2015.04.20~2018.03.27
BMW 730d xDrive: 2013.07.25~2014.07.11
BMW 730Ld: 2012.12.06~2014.12.05
BMW 740d xDrive: 2014.10.14~2015.03.25
BMW Gran Turismo 30d: 2013.09.30~2013.11.11
BMW Gran Turismo 30d xDrive: 2013.07.16~2017.01.27
BMW Gran Turismo EfficientDynamics Edition: 2013.07.19~2017.02.01
BMW GT 20d: 2012.07.27~2013.06.24
BMW GT 30d: 2012.07.05~2013.02.18
BMW GT 30d xDrive: 2012.07.18~2013.01.25
BMW X1 xDrive20d: 2012.07.25~2015.04.21
BMW X3 xDrive20d: 2010.11.24~2014.02.23
BMW X3 xDrive30d: 2011.11.11~2017.02.20
BMW X4 xDrive30d: 2014.04.08~2014.06.25
BMW X5 xDrive30d: 2013.07.29~2018.06.28
BMW X5 xDrive40d: 2014.01.23~2018.06.25
BMW X6 xDrive30d: 2014.08.05~2019.05.16
BMW X6 xDrive40d: 2015.06.08~2019.05.15
MOLIT · South KoreaAug 27, 20213994Model years 2010Shown in the original Korean · translation pendingView details →
The screws retaining the variable camshaft timing (VANOS) housing may loosen and under certain circumstances the heads may break off. This can lead to the VANOS leaking oil internally and adversely affect the valve timing adjustment. If found to deviating from targeted data the engine emergency mode will be activated. This will be indicated by a distinct change in engine running. The orange engine management warning lamp and a check message; On vehicles with N51/N52 engines this will appear at ignition recycle on N55 engine it will display immediately.
DVSA · United KingdomJul 28, 2014R/2014/068Model years 2009–2010View details →
On certain vehicles equipped with v8 engines, in conditions of below freezing temperatures combined with low humidity, it is possible for electrostatic discharge to occur at the fuel rails. If this were to occur, the engine electronic control unit (ecu) could be affected so that engine stalling could result.
NHTSA · United StatesOct 12, 200707V479000Model years 2006–2007View details →
Due to a hardware fault within the digital engine electronic control unit the possibility exists that the unit could fail completely resulting in loss of engine power.
DVSA · United KingdomJul 14, 2004R/2004/131Model years 2004View details →
On certain vehicles equipped with an 8-cylinder engine, the circular retention clip at the quick-release coupling along the fuel supply line was inadvertently omitted. As a result, it is possible that in a severe frontal crash, the quick-release coupling could separate. If this happens, a small amount of fuel could leak and potentially ignite. Correction: Dealers will install a circular retention clip.
Transport CanadaJun 11, 20042004196Model years 2004View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).