This file gathers the known defects of the BMW 7 Series E32, written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.
39 owners in the United States reported problems with the engine and cooling of this car to NHTSA (model years 1987–1993), typically at around 67,000 miles. Most often named: cooling system (46%), cooling system:radiator assembly (28%), engine:gasoline (18%). Reported consequences: 1 crash, 3 fires, 2 injuries.
✓ Mecafile analysis of official data1987–1993View details →
12 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 1988–1993), typically at around 113,000 miles. Most often named: wiring:front underhood (42%), wiring:fuses and circuit breakers (25%), ignition:module (17%). Reported consequences: 5 fires, 1 injury.
✓ Mecafile analysis of official data1988–1993View details →
11 owners in the United States reported problems with the accelerator and cruise control of this car to NHTSA (model years 1988–1993). Most often named: accelerator pedal (18%). Reported consequences: 8 crashes, 2 injuries.
✓ Mecafile analysis of official data1988–1993View details →
On certain vehicles, failure of a cooling system component such as thermostat, water pump or fan belt can result in a significant increase in coolant temperature and system pressure. Increased system pressure could result the formation of a crack or separation of a seam in the heater core end piece which would cause hot coolant to be expelled from the heater core. This hot fluid could contact car occupants resulting in possible personal injury and/or fogging of the interior window surfaces. Correction: Radiator cap will be replaced with a new design cap in order to avoid buildup of excessive pressure in the cooling system.
Transport CanadaOct 14, 19981998197Model years 1988–1993View details →
Vehicle description: Passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, can result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.
NHTSA · United StatesAug 4, 199898V178000Model years 1988–1993View details →
On certain 318IC, 318IS, 318TI, 325I, 325IC, 325IS, 525I, 525IT, 530I, 530IT, 540I, 740I, 740IL, 840CI and M3, the cruise control and throttle cable are attached to the same throttle valve actuating lever at the throttle housing. It is possible that the plastic bushing on either cable could break causing the outer cable housing to separate from the bushing. Throttle pedal application without cruise control engagement could cause the outer tube to catch on the edge of the broken bushing resulting in the throttle valve remaining partially open. If this were to occur, the car might not decelerate as expected and a crash could occut. Correction: A spring clip will be installed on the outer tube of each cable to prevent dislodgment from the bushing.
Transport CanadaOct 9, 19971997173Model years 1993View details →
NHTSA · manufacturer bulletin39561Model years 1993View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0).