This file gathers the known defects of the Chevrolet Malibu V, written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.
1,119 owners in the United States reported problems with the brakes of this car to NHTSA (model years 1997–2002), typically at around 42,000 miles. Most often named: foundation components:disc:rotor (34%), antilock/traction control/electronic limited slip (32%), foundation components:disc (23%). Reported consequences: 51 crashes, 35 injuries, 4 deaths.
✓ Mecafile analysis of official data1997–2002View details →
290 owners in the United States reported problems with the steering of this car to NHTSA (model years 1997–2002), typically at around 89,000 miles. Most often named: rack and pinion (21%). Reported consequences: 29 crashes, 18 injuries, 2 deaths.
✓ Mecafile analysis of official data1997–2002View details →
NHTSA, the US road safety agency, opened an engineering analysis (EA03021) into this problem on 4 November 2003 for 1999 models; it was closed on 19 October 2004 without a recall.
This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The key fob (if applicable), should also be removed from the key ring. General Motors LLC (GM) notified the agency on July 3, 2014, that they are recalling 5,877,718 model year 2000-2005 Chevrolet Impala and Monte Carlo, 1997-2003 Chevrolet Malibu, 2004-2005 Malibu Classic, 1999-2004 Oldsmobile Alero, 1998-2002 Oldsmobile Intrigue, 1999-2005 Pontiac Grand Am and 2004-2008 Pontiac Grand Prix vehicles. In these models, the weight on the key ring and/or road conditions or some other jarring event may cause the ignition switch to move out of the run position, turning off the engine.
NHTSA · United StatesJul 3, 201414V400000Model years 1997–2002View details →
Certain passenger vehicles have lower pinion bearings in the power rack and pinion assembly in which the retainer tabs were not crimped properly. These retainers could fail and permit the ball bearings to escape.
NHTSA · United StatesDec 11, 200303V527000Model years 1997–1998View details →
Certain passenger vehicles have hazard warning switches that may experience solder joint cracking caused by rapid temperature transitions and the soldering process. If solder joint cracking occurs and results in an open circuit, the turn signals/hazard lamps become intermittent or inoperative.
NHTSA · United StatesAug 28, 200303V327000Model years 2000–2001View details →
Subject regarding field action 02015 regarding vehicles which fail to conform to federal motor vehicle safety standard 108, lamps, reflective devices and associated equipment due to left low beam headlamp not meeting certain photometric performance requirements. *tt
NHTSA · manufacturer bulletin636696Model years 2002View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0).