Ball joint: ball joint excessively worn (frequent MOT failure)
9.2% of MOT tests of this car in Great Britain failed on this point (59 of 644 tests in 2025): 4.0 times as often as cars of the same age.
🔔 Create a free account to get email alerts about Daihatsu Cuore (all generations)
Everything about the Daihatsu Cuore, all generations together: defects, recalls, service bulletins and discussions. Pick a generation to narrow it down.
9.2% of MOT tests of this car in Great Britain failed on this point (59 of 644 tests in 2025): 4.0 times as often as cars of the same age.
5.7% of MOT tests of this car in Great Britain failed on this point (37 of 644 tests in 2025): 2.6 times as often as cars of the same age.
Japan's Ministry of Land, Infrastructure, Transport and Tourism (MLIT) "Automobile Defect Information Hotline" has received 12 owner reports concerning the "frame and body" of this vehicle (first registration 2007–2018). Mileage in most reports is around 48,000 km. Among the reports, 1 describes a fire or smoke.
In 5% of the APK inspections of this car in the Netherlands this defect was found (124 out of 2,490 inspections in the past 12 months): 54.8 times as often as for cars of the same age.
Bij 12% van de APK-keuringen van deze auto in Nederland werd dit gebrek vastgesteld (288 van 2.490 keuringen in de afgelopen 12 maanden): 2,6 keer zo vaak als bij auto's van dezelfde leeftijd.
In the front seats, the mounting bolts were not tightened properly, so some of these bolts may loosen due to vibration during driving. As a result, abnormal noise may occur from the mounting area, and if use continues as is, the bolts may fall out. In the worst case, the seat could move in a collision, and the occupant protection performance it is meant to provide may not be achieved.
In the fuel pump impeller (resin impeller), improper molding conditions can result in low resin density, causing the impeller to swell and deform when exposed to fuel. As a result, the impeller may come into contact with the pump case, causing the fuel pump to malfunction and, in the worst case, potentially leading to engine stall while driving.
For replacement front seat belt retractors, some units were assembled with defective force limiter mechanisms that were manufactured improperly. Therefore, in the event of a collision or similar situation, the force limiter may not function correctly, causing the seat belt to be pulled out, and there is a risk that the occupant protection performance required by regulations may not be met.
Defects and discussions are filed under a generation: pick one above to add yours.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).