Free to read · free account to contributeSuccessor to Anticars (2000)

Ford Festiva I

1986–1990 · 4 documented defects · 5 markets

This file gathers the known defects of the Ford Festiva I, written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.

Owners often report problems with seat belts on this car (86 complaints), but no one has explained the cause yet. Do you know it?Write it up
Owners often report problems with electrical system on this car (16 complaints), but no one has explained the cause yet. Do you know it?Write it up

Most serious reported defects

See all (4) →
m
CriticalElectricalNA

Electrical system: problems reported by owners

16 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 1988–1991). Most often named: ignition:switch (69%). Reported consequences: 9 fires.

✓ Mecafile analysis of official data1988–1991View details →
m
CriticalInteriorNA

Rear safety belt (US safety investigation)

NHTSA, the US road safety agency, opened a preliminary evaluation (PE89139) into this problem on 6 July 1989 for 1989 models; it was closed on 31 October 1989 without a recall.

✓ Mecafile analysis of official data1989View details →
m
CriticalInteriorNA

Seat separation (US safety investigation)

NHTSA, the US road safety agency, opened a preliminary evaluation (PE90083) into this problem on 25 May 1990 for 1989 models; it was closed on 27 September 1990 without a recall.

✓ Mecafile analysis of official data1989View details →

Latest official recalls

See all (4) →
RecallCriticalElectricalJP

Miscellaneous (Electrical Equipment)

The ignition switch may have excessive grease applied to its internal contacts. The heat from the arc discharge generated when the switch is operated can carbonize the grease, causing it to accumulate between the movable and fixed contacts and reducing the insulation inside the switch. If use continues in this condition, the contacts may become conductive, causing the switch to overheat and emit smoke. In the worst case, this could lead to a fire.

MLIT · JapanOct 16, 20151136430Model years 1989–1991Auto-translated · original: JapaneseView details →
RecallModerateInteriorNA

Seat belts:Front:Buckle assembly

The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press." if a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.

NHTSA · United StatesJun 27, 199595V103011Model years 1988–1991View details →
RecallCriticalInteriorNA

Seats And Restraints

DEFECT: THE (Takata) ABS PLASTIC FRONT SEAT BELT RELEASE BUTTONS ON THESE VEHICLES MAY BREAK ALLOWING PLASTIC PIECES TO FALL INTO THE BUCKLE ASSEMBLY. IF THIS SHOULD HAPPEN, A NO LATCH, FALSE LATCH OR FAILURE TO UNLATCH CONDITION COULD OCCUR CREATING THE RISK OF PERSONAL INJURY IN THE EVENT OF A CRASH OR SUDDEN STOP. CORRECTION: FRONT SEAT BELT BUCKLES WILL BE REPAIRED OR REPLACED AS NECESSARY.

Transport CanadaJun 13, 19951995106Model years 1989–1991View details →

Latest service bulletins

No service bulletin found for this model.

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).