Affected vehicles may have a touch condition between a fixing screw and push nut to the Instrument Panel (IP) wiring harness. If the vehicleâs wiring is damaged different warning messages may appear depending on which wire is affected. These could include warnings for the airbag system eCall stability control or driver assistance features such as Lane Keeping Aid or Pre-Collision Assist. The airbags will not deploy by accident but if an airbag warning is ignored the airbags may not work correctly in a crash. In some cases the vehicle could lose power while driving and display a âStop safely nowâ message. If this happens braking and steering will still work so the driver can safely bring the vehicle to a stop. Damaged wiring could also cause a short circuit which may increase the risk of fire.
DVSA · United KingdomSep 18, 2026R/2026/355Model years 2024–2026View details →
On affected vehicles the high voltage battery may have some cells that could potentially develop a short circuit leading to a Stop Safely Now message and possible loss of motive power or battery thermal venting.
DVSA · United KingdomNov 4, 2025R/2025/527Model years 2019–2026View details →
Certain Kuga S-Max and Galaxy vehicles equipped with a 2.5L HEV/PHEV Engine may not have the remedy for Safety Recall 23S27 installed correctly but were recorded as having received the repair successfully. Because the correct software update may not have been installed on these vehicles the underlying condition specified in Safety Recall 23S27 potential under hood fire may still exist.
DVSA · United KingdomJul 7, 2025R/2025/243Model years 2021–2022View details →
On affected vehicles the remedy software for a previous recall which was needed to mitigate a potential fire risk may not have been installed correctly.
DVSA · United KingdomMay 9, 2025R/2025/163Model years 2019–2023View details →
A small number of vehicles on which the fuel injectors may crack and leak. In the event of an injector failing this may result in fuel accumulating on the top of the engine. The accumulation of fuel could become the catalyst for a fire due to the proximity to the exhaust system and lack of an escape route for the leaking fuel.
DVSA · United KingdomMar 26, 2024R/2024/141Model years 2022–2023View details →
Under certain operating conditions an oil and/or fuel vapour leak in the presence of an ignition source may result in an engine compartment or vehicle fire localized melting or smoke.
DVSA · United KingdomJul 19, 2022R/2022/231Model years 2020–2022View details →
The clutch pressure plate may break while the vehicle is in motion. This may lead to a malfunction of the transmission and to increased risk of the engine catching fire.
EU Safety GateNov 29, 2019A12/1883/19Model years 2009–2013View details →
A number of vehicles fitted with a 1.0 1.5 or 1.6 Ecoboost engine and 6-speed manual transmission could suffer clutch pressure plate fracture. This results in clutch smell reduced vehicle speed and performance. In the unlikely event of clutch pressure plate fracture a noise (thud / bang) could be heard from the vicinity of the transmission in extreme cases resulting in clutch / transmission fragments being released and striking under hood components creating a risk of smoke and fire from the under hood area.
DVSA · United KingdomFeb 22, 2019R/2018/351Model years 2016–2018View details →
Affected vehicles fitted with a 1.0 1.5 or 1.6 Ecoboost engine and 6-speed manual transmission could suffer clutch pressure plate fracture. This results in clutch smell reduced vehicle speed and performance. In the unlikely event of clutch pressure plate fracture a noise (thud / bang) could be heard from the vicinity of the transmission in extreme cases resulting in clutch / transmission fragments being released and striking under hood components creating a risk of smoke and fire from the under hood area.
DVSA · United KingdomJul 16, 2018R/2018/082Model years 2013–2016View details →
PCM(엔진 및 변속기를 제어하는 컴퓨터)이 엔진의 과열 상태를 적절히 감지하지 못할 수 있으며 이로인하여 엔진의 손상 및 오일 누유가 발생하면 화재가 발생할 수 있는 가능성이 발견됨에 따른 리콜
<*대상차량별 생산일자>
Mondeo(2015~2016년식): 2015.01.21~2015.09.28
Kuga(2016년식): 2015.09.21~2015.09.26
MOLIT · South KoreaJun 7, 20182769Model years 2015Shown in the original Korean · translation pendingView details →
Localized overheating of the engine cylinder head may cause the cylinder head to crack.This may cause a pressurized oil leak which in extreme circumstances could result in a fire in the engine compartment.
DVSA · United KingdomJan 8, 2018R/2018/008Model years 2010–2014View details →
The airbag initiator may be defective and may prevent the side airbag(s) and/or knee airbag deploying in the event of an accident. In a collision the airbags not deploying could put the occupants at further risk.
DVSA · United KingdomSep 4, 2017R/2017/241Model years 2016View details →
In the event of a colision which deploys the front seat belt retractor pre-tensioner there is a possibility that the insulation material on the inner face of lower 'B' pillar trim could be subjected to a concentrated heat source that could ignite the insulation material resulting in fire.
DVSA · United KingdomAug 30, 2017R/2017/238Model years 2012–2014View details →
Het isolatiemateriaal aan de binnenzijde van de bekleding onderaan de 'B'-stijl wordt bij een botsing als de gordelspanner wordt geactiveerd blootgesteldaan een geconcentreerde hittebron.
rdwAug 29, 2017MGP170448Model years 2013Shown in the original Dutch · translation pendingView details →
null In the event of a vehicle impact which deploys the front seat belt pre-tensioner, insulation material in the internal door pillar trim could ignite during the activation of the gas generator and the winding up of the seat belt.
EU Safety GateAug 23, 2017A12/1161/17Model years 2012–2013View details →
null The heated washer jets fitted to some vehicles may have elements which are not correctly sealed. The poor sealing could lead to corrosion due to water ingress and subsequent overheating of the jets which could lead to a fire.
EU Safety GateJun 29, 2017A12/0889/17Model years 2010View details →
The heated washer jets fitted to some Kuga vehicles may have jet heating elements that are not correctly sealed. There is a possibility that poor sealing could lead to corrosion due to water ingress and subsequent overheating of the jets. An overheating jet element will damage the nozzle housing and may cause local heat/fire damage to the cowl grille accompanied by smoke and burning smell.
DVSA · United KingdomJun 5, 2017R/2017/107Model years 2010View details →
The heated washer jets may have jet heating elements which are not correctly sealed. There is a possibility that poor sealing could lead to corrosion due to water ingress and subsequent overheating of the jets. An overheating jet element will damage the nozzle housing and may cause local heat/fire damage to the cowl grille accompanied by smoke and burning smell.
DVSA · United KingdomNov 18, 2016R/2016/067Model years 2008–2010View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).