In the driver-side SRS airbag inflator, the igniter (gas-generant propellant) that ignites the gas-generating agent is improper, so in some cases the gas-generating agent does not burn during a collision. As a result, the airbag may not deploy properly.
On four-wheeled vehicles, some wheel bolts used to attach the wheels to the running gear have been heat-treated improperly. If the vehicle continues to be used in this condition, the bolts may break and, in the worst case, the wheel may come off.
In vehicles equipped with an in-cabin air conditioning system (air conditioner), if the vehicle is operated at high engine speeds while the refrigerant is insufficient, the air conditioner's compressor may seize and, in the worst case, may lead to a fire.
Due to improper welding between the side frame and the front lower cross member, some welds lack sufficient strength. If the vehicle continues to be used as is, vibration during driving may cause these welds to peel apart, shifting the position of the front lower cross member. In the worst case, the rear end of the lower arm supporting the front wheel could come out, potentially rendering the vehicle unable to drive.
The fuel pump cover may have been improperly cast, leaving the inner surface of the pump cover rough and burred in some units. As a result, these burrs may break loose due to vibration and become caught between the impeller that pressurizes and delivers the fuel and the pump cover. This may cause the fuel pump to stop operating, resulting in the engine stopping.
Due to improper welding between the side frame and the front lower cross member, some welds lack sufficient strength. If the vehicle continues to be used as is, vibration during driving may cause the affected welds to separate, shifting the position of the front lower cross member. In the worst case, the rear end of the lower arm supporting the front wheel may come out, rendering the vehicle unable to drive.
The integrated control unit (ICU: Integrated Control Unit) that controls the key interlock mechanism (the mechanism that prevents the key from being removed unless the AT select lever is in the P position) has an improper circuit design. As a result, when the ignition is turned off, the circuit is affected by induced electromotive voltage from the fuel pump, which can delay the start of operation of the key interlock solenoid. Therefore, if the key is removed quickly while the AT select lever is not in the P position, the key may come out, and if the parking brake has not been applied, the vehicle may start to move while parked.
Due to an improper manufacturing process for the open stays attached to top-hinged tailgates, cleaning fluid remaining inside the damper case of some of these open stays causes the O-rings to swell, reducing damping force and causing the tailgate to open faster. This may result in the tailgate striking part of the body. Alternatively, the backdoor may swing up and down due to the rebound from the rapid opening, and if use continues in this state, in the worst case the open stay mounting section may break and the backdoor may descend.
MLIT · JapanApr 16, 20041110710Model years 1999–2000Shown in the original Japanese · translation pendingView details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).