Free to read · free account to contributeSuccessor to Anticars (2000)

Honda Stepwgn I (RF1/2)

1996–2001 · 1 documented defects · 1 markets

This file gathers the known defects of the Honda Stepwgn I (RF1/2), written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.

Most serious reported defects

See all (1) →
m
ModerateInteriorJP

Boarding Device: Defects Reported by Owners

Japan's Ministry of Land, Infrastructure, Transport and Tourism (MLIT) "Automobile Defect Information Hotline" has received five owner reports concerning the "occupant equipment" (乗車装置) of this car (first registration 1997–2000). Mileage in most cases was around 85,000 km.

✓ Mecafile analysis of official data1997–2000Auto-translated · original: JapaneseView details →

Latest official recalls

See all (5) →
RecallCriticalInteriorJP

Airbag

In the driver-side airbag inflator (gas generator), moisture protection is inadequate, so the gas-generating agent may absorb moisture. Therefore, if the gas-generating agent repeatedly absorbs moisture and dries out during use, the airbag may not deploy normally when it is activated.

MLIT · JapanJan 23, 20201146460Model years 1996–1999Auto-translated · original: JapaneseView details →
RecallCriticalBrakesJP

Main Pedal/Lever

On vehicles equipped with a driving assistance device for manually operating the brake pedal, the welds between the brake link plate and shaft, which transmit the operating force, may have insufficient strength. As a result, if the brake arm is pushed further while the vehicle is stopped, excessive force may be applied to the welded portion, causing cracks. If the vehicle continues to be used in this condition, the cracks may grow and, in the worst case, the weld may break, causing the brakes to stop working.

MLIT · JapanJul 10, 20081121460Model years 1999–2000Auto-translated · original: JapaneseView details →
RecallModerateEngineJP

Starting device

The grease applied to the contacts inside the ignition switch has an inappropriate composition. As a result, when the ignition switch is turned off slowly, the arc discharge time at the contacts increases. When the contact temperature rises, the grease hardens, and if this operation is repeated, cuprous oxide forms on the contacts, causing poor electrical continuity at the contact section. Therefore, vibration during driving may cause poor contact continuity, which may stop the engine and make it impossible to restart. In addition, the contacts may overheat locally and the solder on the back side of the contacts may melt. In the worst case, molten solder may fall onto the driver's feet and cause burns.

MLIT · JapanJun 14, 20061116810Model years 1995–1997Auto-translated · original: JapaneseView details →

Latest service bulletins

No service bulletin found for this model.

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).