In some ignition switches, too much grease was applied to certain contact points. For a vehicle used under these conditions, this can cause the grease to carbonize, and therefore an increased risk of fire.
EU Safety Gate · RappelConso · FranceDec 15, 2022a12/00507/22Model years 1989–2002Auto-translated · original: FrenchView details →
null Over the time, the contact points inside the ignition switch may become carbonized and become conductive to electricity. As a result the ignition switch could overheat, leading to the risk of a fire.
EU Safety GateOct 6, 2016A12/1298/16Model years 1986–1999View details →
On certain vehicles, a defect in the ignition switch could cause an electrical short to develop over time. This could result in smoke and/or fire, increasing the risk of injury and/or damage to property. Correction: Dealers will replace the ignition switch.
Transport CanadaOct 19, 20152015489Model years 1990–1996View details →
Mazda North American Operations (Mazda) is recalling certain model year 1989-1998 MPV, 1990-1995 323, 1990-1998 Protege, 1992-1993 MX-3, 1993-1995 929, 1993-1997 MX-6, and 1993-1998 626 vehicles. In the affected vehicles, grease applied to the contact points inside the ignition switch may become conductive and overheat.
NHTSA · United StatesOct 19, 201515V674000Model years 1990–1998View details →
The ignition switch may have excessive grease applied to its internal contacts. The heat from the arc discharge generated when the switch is operated can carbonize the grease, causing it to accumulate between the movable and fixed contacts and reducing the insulation inside the switch. If use continues in this condition, the contacts may become conductive, causing the switch to overheat and emit smoke. In the worst case, this could lead to a fire.
On certain vehicles, if operated at low speeds in a hot and humid environment with the window open, air conditioner running and audio on, condensed water on the A/C duct surface may drop and enter into the audio unit, causing a short circuit. If the short circuit occurs at one specific set of terminals, the rear right speaker can overheat and possibly catch fire. Correction: Dealers will affix aluminum tape over the audio unit to prevent water from entering .
Transport CanadaOct 23, 20002000234Model years 1999View details →
Vehicle description: Passenger vehicles equipped with a particular factory installed audio unit. If the vehicle is operated at low speed in a hot and humid environment with the window open, air conditioner running, and audio on, condensed water on the a/c duct surface could drop and enter into the audio unit, causing a short circuit.
NHTSA · United StatesOct 5, 200000V301000Model years 1999View details →
The airbags in these vehicles may inflate as the result of the tie down hooks striking a curb or pavement. Unnecessary airbag deployment may result in personal injury and a possible vehicle crash without prior warning. Correction: Tie down hooks will be replaced with a modified version which will significantly reduce the likelihood of unnecessary airbag deployment.
Transport CanadaJan 17, 19961996014Model years 1995View details →
THE (Takata) ABS PLASTIC FRONT SEAT BELT RELEASE BUTTONS ON THESE VEHICLES MAY BREAK ALLOWING PLASTIC PIECES TO FALL INTO THE BUCKLE ASSEMBLY. IF THIS SHOULD HAPPEN, A NO LATCH, FALSE LATCH OR FAILURE TO UNLATCH CONDITION COULD OCCUR CREATING THE RISK OF PERSONAL INJURY IN THE EVENT OF A CRASH OR SUDDEN STOP. CORRECTION: FRONT SEAT BELT BUCKLES WILL BE REPAIRED OR REPLACED AS NECESSARY.
Transport CanadaMay 24, 19951995085Model years 1988–1989View details →
In certain high salt areas, the idler arm is exposed to road salt which causes the dust seal to deteriorate resulting in idler arm pin corrosion. This causes the pin to freeze and break. Consequence of defect: A broken idler arm pin could result in loss of steering control and may cause an accident.
NHTSA · United StatesSep 4, 198585V108000Model years 1980–1983View details →
In the brake booster, the strength of the vacuum pump sprocket is insufficient, so the teeth of some sprockets wear abnormally. If use continues as is, the vacuum pump chain may ride up onto the teeth of the sprocket and become caught between it and the chain guide, locking the rotation of the rear cam sprocket. In the worst case, the chain may break, or the rear cam sprocket bolt may fracture, causing the brake booster to stop operating and the brakes to become less effective.
On certain vehicles, the left brake hoses may have been damaged during vehicle assembly. If the vehicles are operated in this condition, brake fluid may leak. This could result in degraded brake performance. Correction: Vehicles will be inspected and, if necessary, left rear brake hoses will be replaced.
Transport CanadaFeb 7, 20012001046Model years 2000–2001View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).