Free to read · free account to contributeSuccessor to Anticars (2000)

Mazda MPV

1988–2016 · 3 generations · 25 documented defects · 4 markets
Generations
Model year
MPV II · 1999–2006
RecallCriticalInteriorNADo not drive until repaired

Air bags:Frontal:Passenger side:Inflator module

Mazda North American Operations (Mazda) is recalling certain 2003-2008 Mazda6, 2004-2005 MPV, 2004 RX-8, and 2006-2007 Mazdaspeed6 vehicles. These vehicles had their passenger frontal air bag inflators previously replaced under a prior recall using inflators of the same design. The inflators may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, temperature and temperature cycling.

NHTSA · United StatesOct 31, 201919V781000Model years 2004–2005View details →
MPV II · 1999–2006
RecallCriticalInteriorNADo not drive until repaired

Air bags:Frontal:Passenger side:Inflator module

Mazda North America Operations (Mazda) is recalling certain 2005-2006 Mazda MPV vehicles sold, or ever registered, in the states of Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin, and Wyoming. On July 9, 2019 this recall was expanded to include certain 2005-2009 RX-8 vehicles that were previously recalled under 17V-011 but have not yet been repaired. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may explode due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.

NHTSA · United StatesJun 15, 201818V404000Model years 2005–2006View details →
MPV II · 1999–2006
RecallCriticalInteriorNADo not drive until repaired

Air bags:Frontal:Passenger side:Inflator module

Mazda North America Operations (Mazda) is recalling certain 2003-2008 Mazda6, 2006-2007 Mazdaspeed6 and 2004 MPV vehicles nationwide. Mazda is also recalling 2005-2006 MPV vehicles in Alabama, Arizona, Arkansas, California, Delaware, the District of Columbia, Florida, Georgia, Hawaii, Illinois, Indiana, Kansas, Kentucky, Louisiana, Maryland, Mississippi, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, South Carolina, Tennessee, Texas, Virginia, West Virginia, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands. On July 9, 2019 this recall was expanded to include certain 2004-2011 RX-8 vehicles that were previously recalled under 16V-354 but have not yet been repaired. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules, and used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these passenger air bag inflators may explode due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.

NHTSA · United StatesJun 15, 201818V402000Model years 2004–2006View details →
MPV II · 1999–2006
RecallCriticalInteriorNA

Airbag

Note: The recall for the 2005-2008 RX-8 models has been superseded by recall <a href="http://wwwapps.tc.gc.ca/Saf-Sec-Sur/7/VRDB-BDRV/search-recherche/detail.aspx?lang=eng&&rn=2018038">2018038 (Mazda Recall 2018A)</a>, and the recall for the 2005-2006 MPV models has been superseded by recall <a href="http://wwwapps.tc.gc.ca/Saf-Sec-Sur/7/VRDB-BDRV/search-recherche/detail.aspx?lang=eng&&rn=2018578">2018578 (Mazda Recall 2618F)</a>. On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, could eventually degrade the propellant contained in the passenger frontal airbag inflator. This could cause the airbag to deploy with more force than normal. As a result, if the vehicle were involved in a collision that warrants airbag deployment, fragments could be propelled toward vehicle occupants, and the airbag assembly could be damaged, preventing proper function. These issues could increase the risk of injury. Correction: Dealers will replace the passenger frontal airbag inflator. Additional note: Canadian climate results in the propellant degrading slowly. The recall is being conducted as a precaution to address future risk, and is expected to replace airbag inflators before their function would be affected.

Transport CanadaJan 10, 20172017011Model years 2005–2006View details →
MPV II · 1999–2006
RecallCriticalInteriorNA

Airbag

Note: The recall for the 2004 RX-8 model has been superseded by <a href="http://wwwapps.tc.gc.ca/Saf-Sec-Sur/7/VRDB-BDRV/search-recherche/detail.aspx?lang=eng&&rn=2018038">recall 2018-038 (Mazda Recall 2018A)</a>, and the recall for the 2004 MPV model has been superseded by recall <a href="http://wwwapps.tc.gc.ca/Saf-Sec-Sur/7/VRDB-BDRV/search-recherche/detail.aspx?lang=eng&&rn=2018578">2018578 (Mazda Recall 2618F)</a>. On certain vehicles, long-term exposure to high absolute humidity and temperature, combined with high temperature cycling, could eventually degrade the propellant contained in the passenger frontal airbag. This could cause the airbag to deploy with more force than normal. As a result, if the vehicle were involved in a collision that warrants airbag deployment, fragments could be propelled toward vehicle occupants, and the airbag assembly could be damaged, preventing proper function. These issues could increase the risk of injury. Correction: Dealers will replace the airbag inflator. Additional note: Canadian climate results in the propellant degrading slowly. The recall is being conducted as a precaution to address future risk, and is expected to replace airbag inflators before their function would be affected.

Transport CanadaMay 26, 20162016259Model years 2004View details →
MPV II · 1999–2006
RecallCriticalInteriorNA

Airbag

On certain vehicles, the front passenger-side airbag was improperly wired and may not provide adequate protection in the event of a crash. Correction: Dealer will install a short wiring harness kit.

Transport CanadaFeb 19, 20042004067Model years 2004View details →
MPV II · 1999–2006
RecallCriticalInteriorNA

Airbag

On certain vehicle, the airbag warning labels on the sun visors are English only. This does not comply with the requirements of CMVSS 208. Correction: Mazda will mail owners corrected replacement labels and installation instructions.

Transport CanadaJul 29, 20032003178Model years 2002–2003View details →
MPV II · 1999–2006
RecallCriticalInteriorNA

Airbag

On certain vehicles, the diffuser may come off the inflator for the passenger air bag during deployment due to improper welding. Under these conditions, expanded gas cannot be supplied to the bag and may not deploy during a frontal crash. Correction: Dealers will replace the passenger side airbag with a correct one.

Transport CanadaAug 2, 20022002145Model years 2001View details →
MPV II · 1999–2006
RecallCriticalInteriorJP

エアーバッグ

助手席用エアバッグにおいて、インフレータ(膨張装置)内のディフューザー(放散装 置)とガスジェネレータボディー(ガス発生器)の接合部の溶接が不適切なものがあるた め、エアバッグが作動した際、当該接合部が剥がれてディフューザーが外れ、膨張ガスを バッグに供給できずに当該エアバッグが展開せず、前面衝突時に乗員に過度の傷害を与え るおそれがある。

MLIT · JapanAug 1, 20021108610Model years 2000Shown in the original Japanese · translation pendingView details →
MPV I · 1988–1999
RecallCriticalInteriorNA

Seats And Restraints

THE (Takata) ABS PLASTIC FRONT SEAT BELT RELEASE BUTTONS ON THESE VEHICLES MAY BREAK ALLOWING PLASTIC PIECES TO FALL INTO THE BUCKLE ASSEMBLY. IF THIS SHOULD HAPPEN, A NO LATCH, FALSE LATCH OR FAILURE TO UNLATCH CONDITION COULD OCCUR CREATING THE RISK OF PERSONAL INJURY IN THE EVENT OF A CRASH OR SUDDEN STOP. CORRECTION: FRONT SEAT BELT BUCKLES WILL BE REPAIRED OR REPLACED AS NECESSARY.

Transport CanadaMay 24, 19951995085Model years 1989–1991View details →
MPV II · 1999–2006
RecallModerateInteriorJP

その他(乗車装置)

助手席に昇降シートを搭載した車両において、昇降シートの折畳式フットレストのヒンジ端部が露出しているため、フットレストを使用せずにシートの下降操作をした場合、当該ヒンジ端部に足等が接触し、最悪の場合、足等を負傷するおそれがある。

MLIT · JapanNov 25, 20102104010Model years 2000–2002Shown in the original Japanese · translation pendingView details →
MPV II · 1999–2006
RecallModerateInteriorNA

Air bags:Frontal

As a result of an ncap test, certain minivans fail to comply with the requirements of federal motor vehicle safety standard no. 208, "occupant crash protection." the front passenger seat air bag was not correctly wiring.

NHTSA · United StatesFeb 17, 200404V073000Model years 2004View details →
MPV II · 1999–2006
RecallModerateInteriorNA

Air bags:Frontal

On certain passenger vehicles, some of the passenger air bag modules were not properly welded and may not deploy in a collision.

NHTSA · United StatesAug 5, 200202V196001Model years 2001View details →
MPV II · 1999–2006
RecallModerateInteriorJP

(ファン)ベルト

原動機において、発電機等の補機駆動用ベルトの張力を維持するベルトテンショナーの 取付軸部のカシメが不充分なものがあるため、当該ベルトテンショナーが取付部から脱落 することがあり、補機駆動用ベルトが外れて発電機及びパワーステアリング用油圧ポンプ が作動しなくなり、充電警告灯が点灯するとともに、ハンドル操作力が増大するおそれが ある。

MLIT · JapanDec 20, 20012101980Model years 2000–2001Shown in the original Japanese · translation pendingView details →
MPV I · 1988–1999
RecallModerateInteriorNA

Seat belts:Front:Buckle assembly

The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press." if a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.

NHTSA · United StatesMay 24, 199595V103005Model years 1989–1991View details →
MPV I · 1988–1999
RecallModerateInteriorNA

Seats And Restraints

These vehicles do not comply with c.M.V.S.S 209 - seat belt assemblies. The centre seat belt attachment hardware brackets for the third seat may not withstand the required tensile load of 6000 lbs or 26.7 kn. Correction: Centre seat belt assembly with bracket will be replaced on affected vehicles.

Transport CanadaNov 24, 19891989158Model years 1989View details →
MPV I · 1988–1999
RecallModerateInteriorNA

Seat belts:Front:Anchorage

The center safety belt attachment hardware brackets for the third seat may not withstand the specified tensile load.

NHTSA · United StatesNov 7, 198989V194000Model years 1989View details →
MPV II · 1999–2006
RecallMinorInteriorNA

Equipment:Other:Labels

Certain minivans fail to comply with the requirements of federal motor vehicle safety standard no. 208, "occupant crash protection." some of these vehicles were produced with air bag warning labels intended for the canadian market. Thus, the labels contain warnings in both english and french. As a result, the area of the english warning is only 16 square centimeters, as opposed to the 30 square centimeters required by the standard.

NHTSA · United StatesMar 9, 200404V109000Model years 2003–2004View details →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).