Free to read · free account to contributeSuccessor to Anticars (2000)

Mazda MX-6

1987–1997 · 2 generations · 8 documented defects · 2 markets
Generations
Model year
MX-6 II · 1991–1997
MX-6 I · 1987–1997MX-6 II · 1991–1997
RecallCriticalEngineUK

Fire may occur

Carbonised grease may accumulate between the contact points in the ignition switch reducing the insulation performance inside the switch. In this condition the switch may generate heat resulting in smoke and in the worst case a fire.

DVSA · United KingdomSep 30, 2016R/2016/210Model years 1989–1998View details →
MX-6 II · 1991–1997
MX-6 II · 1991–1997
RecallCriticalElectricalNA

Electrical system:Ignition:Switch

Mazda North American Operations (Mazda) is recalling certain model year 1989-1998 MPV, 1990-1995 323, 1990-1998 Protege, 1992-1993 MX-3, 1993-1995 929, 1993-1997 MX-6, and 1993-1998 626 vehicles. In the affected vehicles, grease applied to the contact points inside the ignition switch may become conductive and overheat.

NHTSA · United StatesOct 19, 201515V674000Model years 1993–1997View details →
MX-6 I · 1987–1997
RecallCriticalElectricalJP

Miscellaneous (Electrical Equipment)

The ignition switch may have excessive grease applied to its internal contacts. The heat from the arc discharge generated when the switch is operated can carbonize the grease, causing it to accumulate between the movable and fixed contacts and reducing the insulation inside the switch. If use continues in this condition, the contacts may become conductive, causing the switch to overheat and emit smoke. In the worst case, this could lead to a fire.

MLIT · JapanOct 16, 20151136430Model years 1989–1998Auto-translated · original: JapaneseView details →
MX-6 I · 1987–1997
RecallCriticalEngineJP

燃料タンク

燃料タンクの上部に取り付けられている樹脂製のロールオーバーバルブ取付用部品に成 形不良のものがあり、このままの状態で使用を続けると、当該部品と燃料タンクの間に隙 間が発生し、燃料が漏れるおそれがある。

MLIT · JapanJul 18, 19961104620Model years 1994–1995Shown in the original Japanese · translation pendingView details →
MX-6 I · 1987–1997MX-6 II · 1991–1997
RecallCriticalInteriorNA

Seats And Restraints

THE (Takata) ABS PLASTIC FRONT SEAT BELT RELEASE BUTTONS ON THESE VEHICLES MAY BREAK ALLOWING PLASTIC PIECES TO FALL INTO THE BUCKLE ASSEMBLY. IF THIS SHOULD HAPPEN, A NO LATCH, FALSE LATCH OR FAILURE TO UNLATCH CONDITION COULD OCCUR CREATING THE RISK OF PERSONAL INJURY IN THE EVENT OF A CRASH OR SUDDEN STOP. CORRECTION: FRONT SEAT BELT BUCKLES WILL BE REPAIRED OR REPLACED AS NECESSARY.

Transport CanadaMay 24, 19951995085Model years 1988–1991View details →
MX-6 II · 1991–1997
RecallCriticalSuspensionNA

Suspension:Front:Control arm

The lower arm ball joints on both sides of the front suspension may not have been torqued to specification.

NHTSA · United StatesApr 2, 199292V045000Model years 1993View details →
MX-6 I · 1987–1997
RecallCriticalBodyNA

Structure

The fuel tank straps may not be properly tightened and may rub against the fuel tank. This could cause the tank's protective coating to wear through resulting in surface damage and eventual tank perforation and fuel leakage. Correction: Rubber insulator will be placed between the tank straps and the tank and the tank straps will be properly tightened. Also, a new protective coating will be applied where required. V.I.N. Range: Jm1gd3120j1500014 to jm1gd2210j1537936

Transport CanadaDec 8, 19871987133Model years 1988View details →
MX-6 I · 1987–1997
MX-6 II · 1991–1997
RecallModerateElectricalNA

Exterior lighting:Headlights:Switch

Vehicle description: Passenger vehicles. The headlight wire that runs through the turn signal lever can fail at the point where it is soldered to the headlight switch.

NHTSA · United StatesDec 17, 199999V358000Model years 1994View details →
MX-6 II · 1991–1997
RecallModerateEngineNA

Emissions

Certain vehicles do not comply with the requirements of CMVSS. 1103 - Exhaust Emissions. The average CO of the subject vehicles may exceed the standard due to insufficient robustness of emission control logic, and calibration of emission parts with extended usage. Correction: Dealers will install an engine intake kit, which will allow additional air to enter the engine, improving combustion efficiency and lowering the levels of carbon monoxide.

Transport CanadaNov 30, 19991999220Model years 1995View details →
MX-6 II · 1991–1997
RecallModerateEngineNA

Fuel System

Certain vehicles do not comply with the requirements of CMVSS 1105 - Evaporative Emissions. Fuel vapour may leak from between the fuel cap and the fuel filler pipe. The gap could be generated by improper dimensions between the top ends of the inner and outer pipe of the fuel filler pipe. In some cases, raw fuel would be released into the atmosphere. Correction: Dealers will install a modified fuel cap o-ring.

Transport CanadaApr 14, 19991999057Model years 1995–1997View details →
MX-6 II · 1991–1997
RecallModerateInteriorNA

Seats And Restraints

On certain vehicles, minor undercarriage impacts can result in unnecessary air bag deployment. This could result in personal injury and/or loss of vehicle control. Correction: Dealers will reprogram the sas unit to reduce the possibility of unnecessary deployments in low speed undercarriage impacts.

Transport CanadaOct 21, 19981998203Model years 1995–1996View details →
MX-6 II · 1991–1997
MX-6 II · 1991–1997
RecallModerateEngineNA

Engine

On certain vehicles, an external spring in the timing belt auto tensioner may break. The broken spring may get caught in the timing belt, resulting in possible engine stalling. Correction: Vehicles will be inspected and affected tensioners will be replaced.

Transport CanadaSep 11, 19981998178Model years 1997View details →
MX-6 II · 1991–1997
RecallModerateEngineNA

Engine and engine cooling:Engine

Vehicle description: Passenger vehicles. An external spring in the timing belt tensioner can break and get caught in the timing belt.

NHTSA · United StatesSep 8, 199898V206001Model years 1997View details →
MX-6 I · 1987–1997
RecallModerateInteriorNA

Seat belts:Front:Buckle assembly

The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press." if a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.

NHTSA · United StatesMay 24, 199595V103005Model years 1988–1989View details →
MX-6 I · 1987–1997
MX-6 I · 1987–1997
RecallModerateEngineNA

Engine

At ambient temperatures below -18 degrees celsius, frost may accumulate within the throttle body under conditions of extended constant speed operation. This could result in a heavy accelerator pedal and cause uneven throttle valve return. Correction: The single stage engine coolant thermostat will be replaced with a dual stage thermostat equipped with a subvalve to increase the temperature within the throttle body. V.I.N. Range: Jm1gd3120j1500014 to jm1gd2226j1573252.

Transport CanadaFeb 18, 19881988021Model years 1988View details →
MX-6 I · 1987–1997
MX-6 I · 1987–1997
RecallModerateBrakesNA

Brakes

Transportation by rail could cause the rear brake shoe web to come off the wheel cylinder piston groove. This condition will cause damage to the wheel cylinder dust boot and may cause dust and water intrusion into the wheel cylinder resulting in piston corrosion. This would inhibit rear brake effectiveness. Correction: Vehicles will be inspected and wheel cylinder dust boot will be replaced where required. All involved vehicles will have lubricant applied to the wheel cylinder piston groove. V.I.N. Range: Jm1gd3120j1500014 to jm1gd2218j1541323

Transport CanadaDec 16, 19871987138Model years 1988View details →
MX-6 I · 1987–1997

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).