Issue: On certain vehicles, the plastic emblem on the steering wheel airbag cover could detach and become a projectile when the airbag inflates in a crash. Note: This recall is for certain vehicles that had the steering wheel airbag replaced. Safety Risk: Projectiles in the occupant compartment could increase the risk of an injury. Corrective Actions: Nissan will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the steering wheel airbag cover.
Transport CanadaFeb 10, 20232023053Model years 2004–2008View details →
Issue: On certain vehicles, the plastic emblem on the steering wheel airbag cover could detach and become a projectile when the airbag inflates in a crash. Safety Risk: Projectiles in the occupant compartment could increase the risk of an injury. Corrective Actions: Nissan will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the steering wheel airbag cover.
Transport CanadaFeb 10, 20232023052Model years 2008–2009View details →
On certain vehicles, the brake pedal pivot pin end was not properly manufactured. As a result, the pin may not remain in place, causing the brake pedal to partially disengage from the brake pedal bracket. If this occurs, the driver will experience unusual and noticeable looseness in the pedal and a reduction in braking force. A reduction in braking force may lead to increased stopping distances and the risk of a crash causing property damage, personal injury or death. Correction: Owners of all potentially affected vehicles will be contacted and their brake pedal assembly will be inspected and replaced if necessary.
Transport CanadaMar 3, 20102010062Model years 2008–2009View details →
Certain vehicles may have been assembled with faulty seat track assemblies. Specifically, the driver's inboard, and the passenger's outboard seat tracks, may have undersized slots in two locations. This may result in the manual seat pawl not fully engaging in those slots. Should the vehicle be involved in a crash, occupants of front seats with affected seat tracks would be exposed to an increased risk of personal injury or death. Correction: Dealers will inspect and, if necessary, replace the entire seat assembly.
Transport CanadaApr 17, 20082008129Model years 2008View details →
On certain vehicles, the transverse link attachment to the front suspension may not have received adequate tightening torque during vehicle assembly process. A loose transverse link bolt may cause a rattling noise and a vibration. If the bolt comes off completely, the driver may experience difficulty maintaining vehicle control. This could result in a vehicle crash causing injury or death. Correction: Dealers will replace attachment bolts and torque new fasteners to specified value.
Transport CanadaMay 31, 20072007170Model years 2007View details →
On certain vehicles, the 3rd-row curtain side-impact airbag on the driver's side may have been installed slightly out of position during vehicle assembly. This could cause the airbag to inflate in a manner different than designed or not inflate at all. The most likely result of this mis-installation is a delayed deployment. Nissan testing has determined that the delay would be about 20 msc compared with the design intent, and the bag will still be inflated before a 3rd-row occupant might interact with it in a side impact crash. Testing also determined that in the event of a non-deployment, the vehicle still exceeds all safety requirements in the third row seats. Correction: Dealers will inspect and, if required, reposition the 3rd-row curtain side-impact airbag. This action is deemed a voluntary service campaign and is not being conducted under the Motor Vehicel Safety Act.
Transport CanadaSep 18, 20062006230Model years 2005–2006View details →
On vehicles equipped with the automatic airbag suppression feature option, the front passenger seat is equipped with a seat cushion bladder and sensors used for occupant detection. When a certain child dummy is placed in the required positions for US Government tests, automatic suppression may not occur. Correction: Dealers will inspect the front passenger seat cushion/sensor assembly. If the seat cushion/sensor is found to be operating improperly, the seat will be removed and recalibrated. Nissan in the United States is conducting this safety recall campaign to correct an out of compliance condition with US regulations. While there are approximately 1,524 vehicles in Canada affected by this condition, Canadian regulations in this area differ from those in the United States and thus Canadian vehicles are not out of compliance. However, in the interest of customer satisfaction, Nissan Canada Inc., will be conducting a Voluntary Customer Satisfaction Initiative to have owners of affected Canadian vehicles return to their dealers for inspection and recalibration if required.
Transport CanadaMar 5, 20042004084Model years 2004View details →
On certain vehicles, cracks could develop in the fuel tank vent hose. If (1) the fuel tank is overfilled, not allowing excess fuel in the vent hose to flow back into the tank, (2) the vehicle is driven only a short distance after refueling and, (3) there is subsequently significant heating of the fuel tank, the fuel in the tank can expand into the vent hose and leak fuel. Fuel leakage in the presence of an ignition source can result in a fire. Correction: Vent hose will be replaced with a new one with different material specifications.
Transport CanadaJan 16, 20012001011Model years 1993–1998View details →
Vehicle description: Minivans. The fuel tank vent hose allows air to vent from the fuel tank during refueling. Cracks have developed in the vent hose. If (1) the fuel tank is overfilled, not allowing excess fuel in the vent hose to flow back into the tank, (2) the vehicle is driven only a short distance after refueling and, (3) there is subsequently significant heating of the fuel tank, the fuel in the tank can expand into the vent hose and leak fuel.
NHTSA · United StatesDec 15, 200000V419001Model years 1993–1998View details →
Certain vehicles do not comply with the requirements of CMVSS 209 - Seat Belt Assemblies. The seat belt assemblies may not withstand the force requirements of the standard. In a crash, if the belt buckle fails, there is an increased risk of injury to the occupant. Correction: Belt buckle assemblies will be inspected and replaced if necessary.
Transport CanadaOct 26, 20002000253Model years 2000View details →
On certain vehicles, the seat belt assemblies may not withstand the force requirements of the standard. In a crash, if the belt buckle fails, there is an increased risk of injury to the occupant. Correction: Dealer will replace the seat belt buckle assembly.
Transport CanadaSep 15, 20002000197Model years 2000View details →
Vehicle description: Passenger mini vans equipped with automotive batteries supplied by gnb technologies. These batteries have a defective negative post that can cause acid leakage and related corrosion damage.
NHTSA · United StatesOct 28, 199797V184002Model years 1997View details →
These vehicles may have been manufactured with defective batteries. The batteries may have negative terminals that could fracture causing acid leakage and related corrosion damage which could lead to an engine fire or battery explosion. Correction: Defective batteries will be replaced.
Transport CanadaOct 27, 19971997185Model years 1998View details →
The cowl screen for the heater/air conditioner blower housing may not prevent, in some cases, the entry of small leaves and foreign material into the blower housing. If this material enters the blower housing and accumulates at the blower motor resistor, it may be ignited and could result in a vehicle fire. Correction: A secondary air inlet screen will be installed on affected vehicles. Any debris present in the blower assembly will be removed.
Transport CanadaDec 7, 19951995218Model years 1993View details →
Leaves and other foreign material can enter through the cowl panel air intake during operation of the front heater and/or air conditioning system resulting in a build-up of material in the plenum. This can lead to noise, odors, or in some cases, ignition of these materials.
NHTSA · United StatesNov 22, 199595V222002Model years 1993View details →
The wall of the filler hose, which connects the fuel tank to a metal tube, may have been partially sliced or completely cut through during assembly. This could result in fuel leakage and the risk of a fire. Correction: A new filler hose will be installed on affected vehicles.
Transport CanadaNov 27, 19921992152Model years 1993View details →
The service brake master cylinder was not properly assembled or could have been damaged by the evacuation and filling of the brake system at the assembly plant.
NHTSA · United StatesSep 21, 199292V132001Model years 1993View details →
Nissan North America, Inc. (Nissan) is recalling certain 2008-2011 Titan, Frontier, Xterra, Pathfinder, Armada, and 2008-2009 Quest vehicles. The resin emblem on the driver's air bag cover may develop cracks and detach during air bag deployment.
NHTSA · United StatesFeb 10, 202323V067000Model years 2008–2009View details →
On certain vehicles, when driving at low speeds or idling on a downward grade, with ¼ tank or less of fuel, an error in the fuel pump control program may restrict fuel supply to the engine, which could cause the engine to stall. Engine stalling would result in lost vehicle propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will reprogram the Engine Control Module.
Transport CanadaFeb 29, 20122012083Model years 2011–2012View details →
Nissan is recalling certain model year 2011-2012 nissan quest vehicles, manufactured from july 29, 2010, through february 21, 2012. Due to software programming, while driving at slow speeds or idling on a decline with â¼ tank fuel or less, there may be an insufficient supply of fuel to the engine. As a result, the engine may stall.
NHTSA · United StatesFeb 29, 201212V076000Model years 2011–2012View details →
Nissan is recalling certain model year 2008-2010 titan, armada, and infiniti qx56, and model year 2008-2009 nissan quest vehicles. The brake pedal pivot pin end was not spin-formed to specification during the manufacturing process of the brake pedal assembly. The pivot pin could slide and cause the brake pedal to partially disengage from the brake pedal bracket.
NHTSA · United StatesMar 2, 201010V072000Model years 2008–2009View details →
Nissan is recalling 1,126 my 2008 quest, titan and armada vehicles equipped with manual adjustment front seats. These vehicles fail to comply with the requirements of federal motor vehicle safety standard no. 207, "seating systems." the seat track assembly may have been manufactured out of specification.
NHTSA · United StatesApr 24, 200808V187000Model years 2008View details →
On certain mini vans equipped with a folding third row rear seat, when the third row seat is raised from its stowed position, it engages striker brackets, one on each side of the seat cushion. The fold-away striker loop is welded to a mounting bracket. The striker may become detached from its mounting bracket due to a broken weld at the point of attachment to the bracket.
NHTSA · United StatesOct 17, 200505V480000Model years 2004–2005View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).