Bentley is recalling 14 my 1980-1982 bentley t2, my 1980-1987 continental, and mulsanne, my 1980-1982 rolls-royce silver shadow ii, my 1980 silver wraith ii, my 1980-1987 corniche, silver spirit and my 1981-1987 silver spur passenger vehicles. A fuel hose assembly, available as a replacement part, has been found to have a defect in the material specification of the rubber hose. The hose may degrade under certain operating conditions resulting in a fuel leak.
NHTSA · United StatesNov 7, 200808V585000Model years 1980–1987View details →
In the fuel system, because the structure and routing of the piping between the fuel tank and the canister are inappropriate, if fuel is added beyond the specified quantity, fuel may flow into the canister. The inflowing fuel may overflow from inside the canister, and there is a risk that fuel may leak from the vent filter.
Remarks: This recall notification adds new applicable vehicles to the recall notification "Gai-920" dated December 12, 2001.
Some vehicles have a steering shaft joint bolt in the steering gear that interferes with the brake pipe. If the vehicle continues to be used in this condition, in the worst case the brake pipe may be damaged, causing brake fluid to leak and reducing braking force.
High under-hood and under-floor temperatures may cause failure of some hydraulic brake hoses. This condition will cause a loss of hydraulic fluid from the dual hydraulic system and impair braking efficiency. A potential fire hazard also exists.
Transport CanadaJan 20, 19801980092Model years 1980View details →
On certain vehicles, fuel vapors stored in the vehicle's evaporative emission control system could enter a body cavity behind the rocker panel on the driver's side. If vapor is emitted and collects in the cavity, the resulting air/vapor mixture could be ignited if the central window operating mechanism is activated. Correction: Dealers will install a plated mild steel extension pipe to the leak detection filter of the vehicle which will ensure that any vapor emanating from the evaporative emission control system is vented to the outside.
Transport CanadaApr 18, 20012001151Model years 2000–2001View details →
Vehicle description: Passenger vehicles. Fuel vapors stored in the vehicle's evaporative emission control system could enter a body cavity behind the rocker panel on the driver's side.
NHTSA · United StatesApr 16, 200101V096000Model years 2000–2001View details →
Vehicle description: Passenger vehicles. The bolts attaching the lower steering column to the intermediate steering coupling can contact the brake hydraulic system pipes located in the engine compartment.
NHTSA · United StatesAug 4, 199797V122000Model years 1994–1998View details →
A wire inside the electric motor driven gearbox actuator may come into contact with the inner face of the assembly case, causing fretting of the wire and also causing the fuse protecting the circuit to blow if this occurs it would not be possible to engage the desired gear range and may not be possible to restart the vehicle after the engine has been switched off. If "park" is not engaged and the driver does not apply the parking brake, a roll away could occur. Correction: Affected wire will be repositioned.
Transport CanadaSep 28, 19951995169Model years 1992–1996View details →
An incorrectly positioned wire within the electrically operated gearbox actuator can chafe against the cover causing the transmission selector fuse to blow.
NHTSA · United StatesAug 17, 199595V159000Model years 1992–1996View details →
The lower steering column linkage heat shield can come in contact with a brake hydraulic system pipe mounted to the engine assembly, eventually resulting in a hydraulic fluid leak.
NHTSA · United StatesApr 3, 199595V070000Model years 1995View details →
There is a possibility of a foul condition between the lower steering linkage heatshield and a high pressure hydraulic pipe that feeds the front brakes on left hand drive naturally aspirated cars.
DVSA · United KingdomMar 31, 1995R/1995/027Model years 1994–1995View details →
The micro-switch for the stop lamps may fail, causing the lamps to remain continuously illuminated or to fail to illuminate. If this occurs, application of the brakes would not be signalled to following vehicles, creating the potential for a collision. Correction: Stop lamp switch will be replaced with an improved switch.
Transport CanadaApr 7, 19891989049Model years 1986–1989View details →
Heat generated by catalytic converters may cause deterioration of hydraulic brake hoses on certain vehicles. Brake hose may fail, resulting in loss of hydraulic fluid from the dual hydraulic system.
NHTSA · United StatesMay 30, 198080V066000Model years 1980View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).