Free to read · free account to contributeSuccessor to Anticars (2000)

SaabSaab 9-3

1998–2014 · 3 generations · 35 documented defects · 2 markets
Generations

Service bulletins (TSBs) are repair instructions manufacturers send to their dealers about known problems. They are not safety recalls, but they often confirm a defect.

Model year
MarketAllEUNAUK
9-3 I · 2002–2012
BulletinModerateOtherNA

Bulletin

This service bulletin provides technicians with updated information to help identify the differences between what is considered a fluid leak, and what is considered fluid seepage.

NHTSA · manufacturer bulletin10213765Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateElectricalNA

Bulletin

This Preliminary Information communication provides information to the technician about vehicles that have an intermittent no crank, no start, or start stall concern with the security light coming on. Technician may find Diagnostic Trouble Codes B3055, B3060, and/or B3935. Technician should not replace any parts for this concern. If unable to duplicate the concern ask if the customer uses any Radio Frequency Identification Devices when the concern is present. Dealer should also direct their customers to the appropriate section in the Owner manuals that references that the device complies.

NHTSA · manufacturer bulletin10201176Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateOtherNA

Bulletin

This service bulletin provides information to dealership personnel on diagnosis and replacement of shock absorber and strut due to fluid leak.

NHTSA · manufacturer bulletin10195128Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateSuspensionNA

Bulletin

This service bulletin provides a procedure inspecting for excess grease or Sealant on the Exterior of the steering gear due to seeing grease or sealant on certain locations on the gear.

NHTSA · manufacturer bulletin10191163Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateBodyNA

Bulletin

This Preliminary Information communication advises the technician the steps on diagnosing the concern. Customer's sunroof operation intermittent, bind, noise, auto-reverse, and/or water leaks.

NHTSA · manufacturer bulletin10190431Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateEngineNA

Bulletin

This Preliminary Information communication provides information to the technician about engine block of possible cylinder bore damage, scoring or out of round as the possible cause of engine oil consumption, misfire, cylinder leakage or blow by. Technician will need to inspect the engine for Cylinder damage or scoring, An out of round cylinder bore, Dirt intrusion, and Catalytic Converter failure.

NHTSA · manufacturer bulletin10190437Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateOtherNA

Bulletin

This service bulletin provides technicians with updated information to help identify the differences between what is considered a fluid leak, and what is considered fluid seepage.

NHTSA · manufacturer bulletin10188403Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateElectricalNA

Bulletin

This Preliminary Information communication provides information to the technician about vehicles that have an intermittent no crank, no start, or start stall concern with the security light coming on. Technician may find Diagnostic Trouble Codes B3055, B3060, and/or B3935. Technician should not replace any parts for this concern. If unable to duplicate the concern ask if the customer uses any Radio Frequency Identification Devices when the concern is present. Dealer should also direct their customers to the appropriate section in the Owner manuals that references that the device complies.

NHTSA · manufacturer bulletin10178384Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateElectricalNA

Bulletin

This Preliminary Information communication provides information to the technician about vehicles that have an intermittent no crank, no start, or start stall concern with the security light coming on. Technician may find Diagnostic Trouble Codes B3055, B3060, and/or B3935. Technician should not replace any parts for this concern. If unable to duplicate the concern ask if the customer uses any Radio Frequency Identification Devices when the concern is present. Dealer should also direct their customers to the appropriate section in the Owner manuals that references that the device complies.

NHTSA · manufacturer bulletin10174861Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateOtherNA

Bulletin

This Preliminary Information communication provides information to the technician about installing General Motors Accessory parts/kits. Technicians shouldrefer to Service Information for information regarding most accessories. Technicians mayalso contact PARTECHand/orthe Techline Customer Support Center for additional support.

NHTSA · manufacturer bulletin10172305Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateEngineNA

Bulletin

This informational bulletin advises of a new fuel injection cleaner kit used for decarbonizing the intake valves to correct conditions of rough idle, Crank no start, extended crank or misfire, MIL with DTCs, and explains how Top Tier fuels should be used to reduce carbon build-up.

NHTSA · manufacturer bulletin10171878Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateElectricalNA

Bulletin

No Crank/No Start, Dead Battery Due to Parasitic Drain/Discharge.

NHTSA · manufacturer bulletin10254206Model years 2011View details →
9-3 I · 2002–2012
BulletinModerateElectricalNA

Bulletin

No Crank/No Start, Dead Battery Due to Parasitic Drain/Discharge.

NHTSA · manufacturer bulletin10254207Model years 2011View details →
9-3 I · 2002–2012
BulletinModerateSuspensionNA

Bulletin

This technical bulletin provides a procedure on how to clean and resurface aluminum wheel bead seats for vehicles that have the condition of Tire Slowly Goes Flat, Tire Air Loss, Low Tire Pressure Warning Light Illuminated, Aluminum Wheel Bead Seat Corrosion.

NHTSA · manufacturer bulletin10169356Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateBrakesNA

Bulletin

This Preliminary Information communication provides information to the technician about changing the tire and wheel size on vehicles. General Motors will only support a tire calibration for tires that have been sized, tested and designed for the vehicle in question and its applications. Technician should not use the information that is provided by the antilock braking system tire size selection.

NHTSA · manufacturer bulletin10168960Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateOtherNA

Bulletin

This Preliminary Information communication provides information to the technician about installing General Motors Accessory parts/kits. Technicians shouldrefer to Service Information for information regarding most accessories. Technicians mayalso contact PARTECHand/orthe Techline Customer Support Center for additional support.

NHTSA · manufacturer bulletin10165874Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateSuspensionNA

Bulletin

This technical bulletin provides a procedure inspecting for excess grease or Sealant on the Exterior of the steering gear due to seeing grease or sealant on certain locations on the gear.

NHTSA · manufacturer bulletin10165079Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateOtherNA

Bulletin

This Preliminary Information communication provides information to the technician about installing General Motors Accessory parts/kits. Technicians shouldrefer to Service Information for information regarding most accessories. Technicians mayalso contact Partechand/orthe Techline Customer Support Center for additional support.

NHTSA · manufacturer bulletin10163659Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateBodyNA

Bulletin

This Preliminary Information communication advises the technician the steps on diagnosing the concern. Customer's sunroof operation intermittent, bind, noise, auto-reverse, and/or water leaks.

NHTSA · manufacturer bulletin10160682Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateOtherNA

Bulletin

This Preliminary Information communication provides information to the technician about installing General Motors Accessory parts/kits. Technicians should refer to Service Information for information regarding most accessories. Technicians may also contact Partech and/or the Techline Customer Support Center for additional support.

NHTSA · manufacturer bulletin10156990Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateEngineNA

Bulletin

This preliminary information document communicates a tip on the way to diagnose possible induction or exhaust air leaks using the evaporative emission cart smoke machine and ultrasonic leak detectortools.

NHTSA · manufacturer bulletin10154552Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateEngineNA

Bulletin

This Preliminary Information communication provides information to the technician about engine block of possible cylinder bore damage, scoring or out of round as the possible cause of engine oil consumption, misfire, cylinder leakage or blow by. Technician will need to inspect the engine for Cylinder damage or scoring, An out of round cylinder bore, Dirt intrusion, and Catalytic Converter failure.

NHTSA · manufacturer bulletin10144451Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateBodyNA

Bulletin

This Preliminary Information communication advises the technician the steps on diagnosing the concern. Customer's sunroof operation intermittent, bind, noise, auto-reverse, and/or water leaks.

NHTSA · manufacturer bulletin10143752Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateSuspensionNA

Bulletin

This technical bulletin provides a procedure inspecting for excess grease or Sealant on the Exterior of the steering gear due to seeing grease or sealant on certain locations on the gear.

NHTSA · manufacturer bulletin10138025Model years 2009View details →
9-3 I · 2002–2012
BulletinModerateEngineNA

Bulletin

This Preliminary Information communication provides information to the technician about engine block of possible cylinder bore damage, scoring or out of round as the possible cause of engine oil consumption, misfire, cylinder leakage or blow by. Technician will need to inspect the engine for Cylinder damage or scoring, An out of round cylinder bore, Dirt intrusion, and Catalytic Converter failure.

NHTSA · manufacturer bulletin10137727Model years 2009View details →
Older →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).