Free to read · free account to contributeSuccessor to Anticars (2000)

SaabSaab 9-3

1998–2014 · 3 generations · 35 documented defects · 2 markets
Generations
Model year
MarketAllJPNAUK
9-3 I · 2002–2012
RecallCriticalInteriorNA

Airbag

On certain vehicles, the driver frontal airbag inflator could produce excessive internal pressure during airbag deployment. Increased pressure may cause the inflator to rupture, which could allow fragments to be propelled toward vehicle occupants, increasing the risk of injury. This could also damage the airbag module, which could prevent proper deployment. Failure of the airbag to fully deploy during a crash (where deployment is warranted) could increase the risk of personal injury to the seat occupant. Correction: Dealers will replace the driver airbag inflator on Saab 9-3 and 9-5 vehicles and replace the driver airbag module on Saturn Astra vehicles.

Transport CanadaFeb 3, 20162016052Model years 2006–2011View details →
9-3 I · 2002–2012
RecallCriticalInteriorNA

Air bags:Frontal:Driver side:Inflator module

General Motors LLC (GM) is recalling certain model year 2006-2011 Saab 9-3 vehicles manufactured May 31, 2002, to February 15, 2011, 2006-2009 Saab 9-5 vehicles manufactured June 7, 2005, to May 28, 2009, and 2008-2009 Saturn Astra vehicles manufactured April 11, 2007, to July 24, 2008. Upon deployment of the driver's frontal air bag, excessive internal pressure may cause the inflator to rupture.

NHTSA · United StatesFeb 3, 201616V063000Model years 2006–2011View details →
9-3 I · 2002–2012
RecallCriticalInteriorNA

Seats And Restraints

On certain convertible model vehicles, the tensioning cable in the driver's seat belt retractor may break, causing the belt to fail to retract. If a crash were to occur with a seat belt in this condition, it could increase the risk of injury to the driver. Correction: Dealers will replace seat belt retractor assemblies.

Transport CanadaJun 12, 20142014228Model years 2004–2011View details →
9-3 Aero MY14 · 2013–2014
RecallCriticalInteriorUK

Right hand front seat may not lock correctly

It has been established that due to a process problem at a sub supplier the right hand side front seat recliner mechanism may fail. This will result in that the back-rest can't be moved back into the locking position. The condition is very obvious but if ignored and the vehicle is involved in a crash the seat belt which is integral to the seat structure will not restrain the occupant as designed.

DVSA · United KingdomDec 3, 2010R/2010/213View details →
9-3 I · 2002–2012
RecallCriticalInteriorNA

Seat belts:Front:Retractor

General motors is recalling certain model year 2004 saab 9-3 sedans. Some of these vehicles were produced with front seat belt retractors that, over time, could fail to retract.

NHTSA · United StatesFeb 18, 201010V043000Model years 2004View details →
9-3 I · 2002–2012
RecallCriticalInteriorNA

Seats And Restraints

On certain vehicles, the Automatic Tensioning System (ATS) cable of the seatbelt retractors could fail. Should this occur, the webbing spooled out by the user would not retract. If the spool cable were to break while the belt is being worn, the belt would function normally in a crash. It would then be obvious to the occupant that the belt needs repair as soon as possible. Correction: Dealers will replace the driver's seatbelt retractor.

Transport CanadaFeb 10, 20102010039Model years 2004View details →
9-3 I · 1998–20039-3 I · 2002–2012
RecallCriticalEngineJP

燃料ホース/パイプ

燃料ホースと燃料ポンプの組付けが不適切なものがあり、燃料ホース取付け部に応力がかかるものがある。そのため、そのままの状態で使用を続けると、最悪の場合、車両の振動等により当該取付け部が折損し、燃料が漏れるおそれがある。

MLIT · JapanMay 29, 20071214060Model years 1999–2007Shown in the original Japanese · translation pendingView details →
9-3 I · 1998–2003
9-3 I · 1998–2003
RecallCriticalEngineJP

燃料ホース/パイプ

燃料ホースと燃料ポンプの組付けが不適切なものがあり、燃料ホース取付け部に応力がかかるものがある。そのため、そのままの状態で使用を続けると、最悪の場合、車両の振動等により当該取付け部が折損し、燃料が漏れるおそれがある。 (備考)本届出は、平成17年4月5日付「外-1217」にてリコール届出を行ったものですが、対象車両の選定に一部誤りがあることが判明したため、対象車両を追加し、新たに届け出るものです。

MLIT · JapanJul 21, 20061213210Model years 2000–2001Shown in the original Japanese · translation pendingView details →
9-3 I · 1998–2003
9-3 Aero MY14 · 2013–2014
RecallCriticalSuspensionUK

Rear axle hub may not be to specification

The hardening process applied to the rear wheel bearing inner ring may be incorrect. There is a possibility that a rumbling noise may become apparent which if not checked could in extreme circumstances result in the detachment of the hub and severely impaired road holding/handling.

DVSA · United KingdomJan 3, 2006R/2005/167View details →
9-3 I · 1998–2003
RecallCriticalElectricalNA

Electrical

Certain 2000-2002 Saab 9-3 and 9-5 model vehicles equipped with 4-cylinder gasoline engines, and 2001-2003 9-5 models equipped with 6-cylinder gasoline engines may experience overheating and burnout of the Isolated Gated Bipolar Transistor (IGBT) within the Ignition Discharge Module (IDM) due to increased susceptibility to electrical loads. Overheating of the IGBT occurs most often at engine start-up but may also occur while the engine is running. When the IDM fails on a 4-cylinder while it is running, the engine may stall without warning, with no ability to be restarted. When the IDM fails on a 6-cylinder engine while it is running, the driver will initially experience reduced power and rough operation because the engine will only be running on three cylinders. The check engine light will flash. If the driver continues, unburnt fuel in the exhaust can cause thermal damage to the catalytic converter. The engine may stall and not restart. Correction: Dealers will inspect and, if required, replace the IDM.

Transport CanadaSep 20, 20052005271Model years 2000–2002View details →
9-3 I · 1998–2003
RecallCriticalElectricalNA

Electrical system:Ignition:Module

Certain passenger vehicles equipped with b205/b235 4-cylinder gasoline engines and b308 6-cylinder gasoline engines may experience overheating and burnout of the isolated gated bipolar transistor (igbt) within the ignition discharge module (idm) due to increased susceptibility to electrical loads.

NHTSA · United StatesSep 14, 200505V399000Model years 2000–2002View details →
9-3 I · 1998–20039-3 I · 2002–2012
RecallCriticalBrakesJP

圧力制御伝達部

制動倍力装置とインテークマニホルド間に装着されているチェックバルブの材質が不適切なため、外気温度が高い条件下で高負荷運転を繰り返すと原動機の温度が上昇し、当該チェックバルブが熱影響により損傷することがある。そのため、そのままの状態で使用を続けると、倍力装置の機能が低下し、最悪の場合、制動力が低下するおそれがある。

MLIT · JapanJul 26, 20051212460Model years 2003–2005Shown in the original Japanese · translation pendingView details →
9-3 I · 1998–2003
9-3 I · 1998–2003
RecallCriticalEngineJP

燃料ホース/パイプ

燃料ホースと燃料ポンプの組付けが不適切なものがあり、燃料ホース取付け部に応力がかかるものがある。そのため、そのままの状態で使用を続けると、最悪の場合、車両の振動等により当該取付け部が折損し、燃料が漏れるおそれがある。

MLIT · JapanApr 15, 20051212170Model years 2000–2002Shown in the original Japanese · translation pendingView details →
9-3 I · 1998–2003
RecallCriticalEngineNA

Fuel System

On certain Saab 9-3 convertible and 9-3 Viggen vehicles, the fuel pump retaining tabs holding the fuel lines were damaged during production. Over time, this could cause the fuel lines to loosen from the pump resulting in fuel leakage. If an ignition source were present, the fuel may ignite resulting in a vehicle fire. Correction: Dealers will install a bracket that will secure the fuel lines to the fuel pump even if the plastic retaining tabs should break.

Transport CanadaDec 8, 20042004427Model years 2001–2002View details →
9-3 I · 1998–2003
9-3 Aero MY14 · 2013–2014
9-3 I · 1998–2003
RecallCriticalSuspensionNA

Steering:Linkages:Tie rod assembly

Vehicle description: Passenger vehicles. The tie rod end retaining nuts may not have been properly tightened at the factory.

NHTSA · United StatesOct 3, 200101V314000Model years 2002View details →
9-3 I · 1998–2003
RecallCriticalSuspensionNA

Steering

Certain passenger vehicles the tie rod end retaining nuts may not have been properly tightened at the factory. The nuts could loosen and fall off resulting in a sudden reduction or loss of steering control. Correction: All vehicles will be inspected and corrected prior to customer delivery . No owner notification will be required.

Transport CanadaMar 10, 20012001235Model years 2002View details →
9-3 I · 1998–2003
RecallCriticalEngineJP

潤滑装置

原動機において、潤滑油の油圧センサに一部製造不良のものがあり、そのままの状態で 使用を続けると、当該油圧センサに亀裂が生じ、潤滑油が漏れ、最悪の場合、火災に至る おそれがある。

MLIT · JapanJan 20, 20001207800Model years 1998–1999Shown in the original Japanese · translation pendingView details →
9-3 I · 2002–2012
RecallModerateInteriorNA

Seat belts:Front:Retractor

General Motors LLC (GM) is recalling certain model year 2004-2011 Saab 9-3 Convertible vehicles manufactured July 30, 2003, to February 15, 2011. In the affected vehicles, the driver's side front seat belt retractor may break, causing the seat belt webbing not to retract.

NHTSA · United StatesJun 12, 201414V318000Model years 2004–2011View details →
9-3 I · 2002–2012
RecallModerateEngineJP

燃料ポンプ

燃料タンク内の燃料ポンプにおいて、当該ポンプに不良部品が組み込まれている場合がある。そのため、そのままの状態で使用を続けると、最悪の場合、当該ポンプが動かなくなり、エンジンが停止して再始動ができなくなるおそれがある。

MLIT · JapanMay 18, 20111217500Model years 2010Shown in the original Japanese · translation pendingView details →
9-3 I · 2002–2012
RecallModerateEngineNA

Fuel System

On certain vehicles, the fuel pump may seize, which would stop fuel flow to the engine and cause it to stall. Engine stalling would result in lost propulsion which, in conjunction with traffic and road conditions, and the driver's reactions, could increase the risk of a crash causing property damage and/or personal injury. Correction: Dealers will inspect and, if necessary, replace the fuel pump assembly.

Transport CanadaJan 21, 20112011029Model years 2011View details →
Older →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).