null Cracks may develop over time in the right-hand drive shaft. In the worst case, the drive shaft may break, leading to a sudden loss of drive. This may lead to an unsafe traffic situation.
EU Safety GateApr 19, 2013A12/0501/13Model years 2010–2013View details →
It is possible that the right hand driveshaft may not have been manufactured to the correct specification. This can ultimately result in the failure of the drive shaft. This will be identified to the driver by noise and the loss of drive.
DVSA · United KingdomApr 8, 2013R/2013/046Model years 2011–2012View details →
A number of Volvo C30S40V50 and C70 may experience a problem with washer fluid leaking inside the washer pump unit through the wires into the central control electronic module. This can impact on a number of different features of the vehicle but in the worst case it may lead to a fire.
DVSA · United KingdomDec 1, 2011R/2011/163View details →
Volvo quality follow-up procedures have identified an issue on a number of model year 2007 C30 S40 and V50s relating to the engine cooling fan control module. Under certain operating conditions water intrusion could occur into the control module causing a short circuit which in very rare instances could result in a fire in the engine compartment.
DVSA · United KingdomFeb 18, 2011R/2011/019View details →
On certain five cylinder engines it is possible that the high pressure fuel pipes may not have been correctly installed and may leak. This should be identified by a smell of fuel from the engine bay. However it is possible that in extreme cases an engine bay fire could occur.
DVSA · United KingdomDec 3, 2010R/2010/224View details →
Volvo is recalling certain vehicles equipped with garmin 760 portable global positioning system (gps) units because the batteries on those units may overheat.
NHTSA · United StatesNov 8, 201010V566000Model years 2007–2010View details →
It has been identified that on subject vehicles the engine cooling fan module could under certain operating conditions develop a short circuit caused by water intrusion. This in rare circumstances could result in an engine bay fire.
DVSA · United KingdomMar 6, 2009R/2009/024View details →
On certain vehicles, rubber seals inside the brake master cylinder assembly may suffer premature wear, causing internal fluid leakage. This could result in reduced braking performance, that may gradually deteriorate over time. Eventually, this could cause a complete loss of brake functionality, increasing the risk of a crash with property damage, and/or personal injury or death. Correction: Dealers will inspect and, if necessary, replace the brake master cylinder and fluid reservoir.
Transport CanadaMar 1, 20082008083Model years 2007View details →
Bij voertuigen met een 1.6 dieselmotor en een 6-traps handgeschakelde versnellingsbak kan in de rechter aandrijfas scheurvorming ontstaan. Hierdoor kan de aandrijfas breken.
rdwMay 2, 2013MGP130036Model years 2011Shown in the original Dutch · translation pendingView details →
The rod connecting the clutch master cylinder and the clutch pedal may break. It may not be possible to disengage the clutch. In worst cases this may happen suddenly with no warning to the driver. If this happens bring the car to a safe stop using the engine and switch off the ignition.
DVSA · United KingdomSep 7, 2011R/2011/127View details →
The cover on the top of the engine cover could chafe against the brake vacuum hose. If this occurs it may lead to a vacuum leak in the brake booster system and a gradual reduction of brake booster assistance. The will lead to the brake pedal becoming harder to push than normal and increased force would be required to stop the car.
DVSA · United KingdomJun 28, 2011R/2011/075View details →
It is possible that stress cracks may occur in the offside main support member within the engine bay which could affect the vehicle structural performance if it is involved in an accident.
DVSA · United KingdomMar 23, 2011R/2011/031View details →
It is possible that the hose connection between the coolant expansion tank and the bleed hose can work loose. If this should occur then coolant will leak and air will enter the system. Under these conditions the low coolant level warning light will not function. If the vehicle is driven in this condition it will cause engine damage and in the extreme possible failure.
DVSA · United KingdomSep 21, 2010R/2010/144View details →
A section of the gear shift mechanism may over time become loose and cause the mechanism to become jammed. If this was to occur it might not be possible to change gear or select neutral.
DVSA · United KingdomJun 11, 2010R/2010/071View details →
Volvo is recalling certain model year 2010-2011 c30, model year 2010 s40 and v50 vehicles equipped with 6 speed manual transmissions. The gearshift lever stud assembly may not have been tightened to the correct specification during assembly. If the gearshift lever cable or stud assembly becomes loose, it may not be possible to engage, disengage or shift gears.
NHTSA · United StatesJun 8, 201010V255000Model years 2010–2011View details →
The engine oil level may rise. This situation may lead to the engine speed being maintained or possibly increased after the throttle pedal is released. In an extreme situation the engine may continue to run after it has been switched off.
DVSA · United KingdomMay 12, 2010R/2010/051View details →
Brake assistance from the vacuum pressure pump may be reduced under certain cold start conditions. The brakes will still function but more pressure on the pedal will be required than normal.
DVSA · United KingdomMay 8, 2009R/2009/052View details →
Volvo is recalling my 2008-2009 vehicles. A section of the power steering return line hose was not properly vulcanized (cured) and does not meet specifications. If the power steering return hose fails, a sudden rupture of the hose can occur.
NHTSA · United StatesJul 23, 200808V329000Model years 2008–2009View details →
It has been identified that on the subject vehicles the rear wheel studs may be of an incorrect size. This in rare cases may during particular forms of low speed manoeuvring result in the wheel becoming loose.
DVSA · United KingdomApr 25, 2008R/2008/066View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).