Bulletin
Tube - brake
Les bulletins techniques (TSB) sont des instructions de réparation que les constructeurs envoient à leurs concessionnaires sur des problèmes connus. Ce ne sont pas des rappels de sécurité, mais ils confirment souvent un défaut.
Tube - brake
The front heated seat control modules may cause the seat elements to overheat under certain operating conditions. Customer satisfaction notification e12 - heated seat control modules. *tt
Rear drum brake clunk sound. *tt
Malfunction indicator lamp illumination / transmission limp-in condition. *tt
Vehicles may experience an interior gurgling sound, overheating and/or poor interior heating at idle. *slc
Experiencing steering column click sound when the steering wheel is turned. *tt
Information on new power steering fluid.*slc
Advance service information regarding steering column click sound. *tt
Subject regarding steering column click sound. *tt
This bulletin states that all factory installed equipment, such as a sunroof, meet the upper interior head protection requirements of fmvss 201. *tt
This advance service bulletin states that some vehicles may experience an intermittent reduction of power steering assist due to a sticking flow control valve in the power steering pump. *tt
Some vehicles may experience a no start condition in cold temperatures due to 5 volt regulator failure in the sbec pcm module. *jb
Subject regarding non-deployed airbag handling procedures. *tt
Informations sur le mode de test concessionnaire de la pompe de détection de fuites (ldp). *nlm
Informations sur le diagnostic d'absence de démarrage, capteur d'arbre à cames/vilebrequin, $01 et $28. *nlm
Brief information on the use of asbestos fiber brake linings. *tt
Informations sur le programme de retour rapide de flotte : installation des transmissions transaxle 41TE de l'année modèle 2000. *tt
A new power steering fluid. *yc
Some vehicles were shipped with the steering wheels off-center due to a steering wheel angle sensor problem at the assembly plant. *yc
Excessive cold crank time with a no start condition caused by no/low compression due to loose carbon holding valves opening/sags/stumbles/hesitates after cold start. *ak
Condition with clunking or rattling in steering/wheel column. *yc
Conditions with steering wheel shake at idle. *yc
Steering wheel shake at idle. *tw
Power steering system change. *tw
Vehicles equipped with speed proportioning steering are experiencing shuuder in steering when making slow speed turns. *tw
Sources : NHTSA (États-Unis, domaine public), Transports Canada (Licence du gouvernement ouvert – Canada), DVSA (Royaume-Uni, Open Government Licence v3.0), RappelConso et Safety Gate de l'UE (France, Licence Ouverte 2.0), MLIT (Japon, licence de données publiques 1.0) et MOLIT (Corée du Sud, car.go.kr).