Lecture libre · compte gratuit pour contribuerSuccesseur d’Anticars (2000)

Ford Probe

1988–1997 · 2 générations · 24 défauts documentés · 1 marchés
Générations

Les bulletins techniques (TSB) sont des instructions de réparation que les constructeurs envoient à leurs concessionnaires sur des problèmes connus. Ce ne sont pas des rappels de sécurité, mais ils confirment souvent un défaut.

Année modèle
MarchéTousNA
Probe II (1993) · 1992–1997
BulletinModéréMoteurNA

Bulletin

Revised oil pump installation procedure. Yd

NHTSA · bulletin constructeur609549Années modèle 1997Affiché en anglais d’origine · traduction en attenteVoir le détail →
Probe I (1989) · 1988–1992
BulletinModéréMoteurNA

Bulletin

Improper rtv application at the front/rear lower intake manifold end seals & side gaskets may cause an oil/coolant leak. *tt

NHTSA · bulletin constructeur50536Affiché en anglais d’origine · traduction en attenteVoir le détail →
Probe I (1989) · 1988–1992
BulletinModéréMoteurNA

Bulletin

Engine oil leak at the oil pan, front cover &/or the front & rear crankshaft oil seal. *tt

NHTSA · bulletin constructeur50459Affiché en anglais d’origine · traduction en attenteVoir le détail →
Probe I (1989) · 1988–1992
BulletinModéréMoteurNA

Bulletin

Information on correcting an oil pan gasket leak. *tt

NHTSA · bulletin constructeur50460Affiché en anglais d’origine · traduction en attenteVoir le détail →
Probe II (1993) · 1992–1997
BulletinMineurMoteurNA

Bulletin

A clunk on left hand turns while accelerating. This may be caused by improper alignment of the #1 engine mount. *jd

NHTSA · bulletin constructeur51038Années modèle 1997Affiché en anglais d’origine · traduction en attenteVoir le détail →
Probe II (1993) · 1992–1997
BulletinMineurMoteurNA

Bulletin

Clunk on left hand turns while accelerating on 1997 probe 2.0l cd4e vehicles. May be caused by improper alignment of the engine mount. *jd

NHTSA · bulletin constructeur51190Années modèle 1997Affiché en anglais d’origine · traduction en attenteVoir le détail →
Probe II (1993) · 1992–1997
BulletinMineurMoteurNA

Bulletin

An oil pump to cylinder block alignment concern on vehicles built between 9/5/96 and 12/9/96 with engine serial number fs200304 through fs209265. *jd

NHTSA · bulletin constructeur51485Années modèle 1997Affiché en anglais d’origine · traduction en attenteVoir le détail →
Probe II (1993) · 1992–1997
BulletinMineurMoteurNA

Bulletin

Oil pump to cylinder block alignment concern on vehicle built between 9/5/96 and 12/9/96 with engine serial number fs200304 through fs209265. Jd

NHTSA · bulletin constructeur51549Années modèle 1997Affiché en anglais d’origine · traduction en attenteVoir le détail →
Probe I (1989) · 1988–1992
BulletinMineurMoteurNA

Bulletin

Electronic automatic temperature control (eatc) invalid diagnostic codes u1235 & 155 may be stored if the ignition switch is cycled from 'off' to 'run' extremely slowly. *tt

NHTSA · bulletin constructeur50553Affiché en anglais d’origine · traduction en attenteVoir le détail →
Probe II (1993) · 1992–1997
BulletinMineurMoteurNA

Bulletin

2.5l duratec engine exchanges no longer include front end accessory drive component, oil level indicator, water pump belt/tensioner, egr tube, linkshaft bracket or exhaust manifolds. *tt

NHTSA · bulletin constructeur50527Années modèle 1997Affiché en anglais d’origine · traduction en attenteVoir le détail →
Probe I (1989) · 1988–1992
BulletinMineurMoteurNA

Bulletin

Connection between the sender (9a299) & the fuel pump (9350) changed from the existing spade terminal to an eyelet terminal which is secured under the top sender mount screw. *tt

NHTSA · bulletin constructeur50455Affiché en anglais d’origine · traduction en attenteVoir le détail →
Probe I (1989) · 1988–1992
BulletinMineurMoteurNA

Bulletin

On various 4.0l applications the oil indicator tube (dip stick) is coming into contact w/ the crankshaft. *tt

NHTSA · bulletin constructeur50452Affiché en anglais d’origine · traduction en attenteVoir le détail →
Probe II (1993) · 1992–1997
BulletinMineurMoteurNA

Bulletin

The fresh air intake duct on some of these vehicles do not provide adequate sealing to prevent water from being ingested into the engine. *tw

NHTSA · bulletin constructeur39320Années modèle 1995Affiché en anglais d’origine · traduction en attenteVoir le détail →
Probe I (1989) · 1988–1992
BulletinMineurMoteurNA

Bulletin

Les véhicules peuvent rejeter des émissions d'échappement qui dépassent les normes fédérales et canadiennes. *tw

NHTSA · bulletin constructeur39267Années modèle 1990Traduit automatiquement · original : anglaisVoir le détail →

Sources : NHTSA (États-Unis, domaine public), Transports Canada (Licence du gouvernement ouvert – Canada), DVSA (Royaume-Uni, Open Government Licence v3.0), RappelConso et Safety Gate de l'UE (France, Licence Ouverte 2.0), MLIT (Japon, licence de données publiques 1.0) et MOLIT (Corée du Sud, car.go.kr).