Bulletin
On some Model 3 and Model Y vehicles, the upper steering column bolt may not be installed according to internal specifications, which could cause excessive play between the steering wheel and steering column.
🔔 Créez un compte gratuit pour recevoir les alertes e-mail sur Tesla 3 (toutes les générations)
Les bulletins techniques (TSB) sont des instructions de réparation que les constructeurs envoient à leurs concessionnaires sur des problèmes connus. Ce ne sont pas des rappels de sécurité, mais ils confirment souvent un défaut.
On some Model 3 and Model Y vehicles, the upper steering column bolt may not be installed according to internal specifications, which could cause excessive play between the steering wheel and steering column.
On some Model 3 and Model Y vehicles, the brake caliper bolts may not have been torqued to internal specifications.
On some Model 3 and Model Y vehicles, the brake caliper bolts may not have been torqued to internal specifications.
Certain Model 3 vehicles might have too few HV battery positive contactor mounting nuts installed, which can allow movement that might affect the conductivity of the contactor terminals.
Certain Model 3 vehicles might have too few HV battery positive contactor mounting nuts installed, which can allow movement that might affect the conductivity of the contactor terminals.
Certain Model 3 vehicles might have too few HV battery positive contactor mounting nuts installed, which can allow movement that might affect the conductivity of the contactor terminals.
Certain Model 3 vehicles might have too few HV battery positive contactor mounting nuts installed, which can allow movement that might affect the conductivity of the contactor terminals.
On a certain few Model 3 vehicles, the steering shaft sleeve diameter is too large, and might preload the steering shaft boot bearing so as to cause a squeaking noise to come from the steering shaft boot when the steering wheel is turned. The squeaking noise is most prevalent at lower ambient temperatures, and might diminish as the temperature rises. This is exclusively an NVH issue and does not affect steering functionality.
On some Model 3 vehicles, the push rivets, nuts, and bolts that attach the underbody aero panels might have been improperly installed. Consequently, fasteners might be missing, and underbody panels might be damaged or missing.
Certain Model 3 vehicles might have too few HV battery positive contactor mounting nuts installed. Too few mounting nuts allow movement that might affect the conductivity of the contactor terminals.
On certain Model 3 vehicles, coolant might leak from the rear drive unit inverter 55 degree fluid coupling. This could result in a low coolant alert in the vehicle.
On some Model 3 vehicles, water might leak inside the motors of both front window motor/regulator assemblies. This might cause the motors to fail and potentially make the front windows inoperable.
On some Model 3 vehicles, water might leak inside the motors of both front window motor/regulator assemblies. This might cause the motors to fail and potentially making the front windows inoperable.
On some Model 3 vehicles, one of the bolts that helps to secure the rear drive unit inverter coolant manifold to the inverter housing might not have been installed. Consequently, coolant might leak from the manifold.
On certain Model 3 vehicles, the rear drive unit gearbox fluid might leak into the printed circuit board cavity of the oil pump, causing the vehicle to go into limp mode.
On some Model 3 vehicles, the brake booster clevis pin might make a knock or rattle sound when the brakes are used. Vehicle braking is not affected.
On some Model 3 vehicles, a pre-production LH upper trough plug is installed. The pre-production plug is completely functional, however, it does not cosmetically match the grommet on the RH upper trough.
Sur certains véhicules Model 3 et Model Y, la batterie du capteur du système de surveillance de la pression des pneus (TPMS) peut se décharger à un rythme accéléré. Identifiez et remplacez le capteur TPMS concerné.
Certain Model 3 and Model Y vehicles were manufactured with High Voltage (HV) batteries containing cell modules that do not meet Teslas internal quality standards, potentially resulting in a reduction of range.
On some Model 3 vehicles, the RH front Wheel Speed Sensor (WSS) might have been misrouted, which may cause damage to the WSS harness.
Some Performance Model 3 vehicles might experience minor oil loss through the Rear Drive Unit (RDU) breather during high lateral acceleration cornering maneuvers.
On some Model 3 vehicles, the RH front Wheel Speed Sensor (WSS) might have been misrouted, which may cause damage to the WSS harness.
On some 2024+ Model 3 vehicles built at Fremont, a rattling noise may be noticed from the driver and/or front passenger instrument panel air vent while the face-level air vents are directed to straight ahead air flow.
On some 2024+ Model 3 built at Fremont, a rattling noise may be noticed from the driver and/or front passenger instrument panel air vent while the face-level air vents are directed to straight ahead air flow.
On certain Model 3 vehicles, the rear drive unit HV header bolts and the positive contactor bolt within the High Voltage (HV) battery ancillary bay were insufficiently torqued to internal specifications during manufacturing.
Sources : NHTSA (États-Unis, domaine public), Transports Canada (Licence du gouvernement ouvert – Canada), DVSA (Royaume-Uni, Open Government Licence v3.0), RappelConso et Safety Gate de l'UE (France, Licence Ouverte 2.0), MLIT (Japon, licence de données publiques 1.0) et MOLIT (Corée du Sud, car.go.kr).