I dadi delle ruote su questi veicoli potrebbero non essere stati serrati alla coppia specificata durante il montaggio. Ciò può causare la rottura dei prigionieri delle ruote, che potrebbe provocare il distacco della ruota dal veicolo. Se ciò dovesse verificarsi mentre il veicolo è in movimento, potrebbe verificarsi un incidente senza alcun preavviso. Correzione: i dadi delle ruote saranno serrati alla coppia specificata.
Transport Canada13 dic 19961996205Anni modello 1996Tradotto automaticamente · originale: ingleseVedi dettagli →
The fuel tank attachment strap fasteners are below the specified torque. These loose fasteners could, in time, become completely detached. This could allow the fuel tank to sag down to the point of striking something in the road or the road surface resulting in a possible fuel leak and an under-vehicle fire. Correction: Fuel tank strap fasteners will be torqued to the proper specifications.
Transport Canada3 nov 19941994170Anni modello 1994Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The fuel tank attachment strap fasteners were not properly tightened. The fasteners can completely detach, eventually allowing the fuel tank to sag and the bottom of the tank to strike the roadway.
NHTSA · Stati Uniti25 ott 199494V210000Anni modello 1994Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Paint on the wheel mounting surfaces can act as a shim between the wheel and the rotor/drum. As the vehicle is driven, the wheel imbeds into the paint, loosening the lug nut and causing a loss of clamp load.
NHTSA · Stati Uniti16 apr 199494V076000Anni modello 1994Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On certain vehicles, the engine oil cooler inlet hose may contact the steering gear and wear through. This could allow engine oil to leak onto hot engine components and cause an engine compartment fire. Correction: Oil cooler hose will be repositioned and inspected. If wear is evident, the hose will be replaced.
Transport Canada25 mar 19941994064Anni modello 1994Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The engine oil cooler inlet hose may have been installed too close to the steering gear causing chafing. The chafing can eventually wear through the hose's protective sleeve resulting in engine oil leaking onto the engine.
NHTSA · Stati Uniti21 mar 199494V049000Anni modello 1994Mostrato in inglese originale · traduzione in attesaVedi dettagli →
L'modulatore ABS può corrodersi e perdere liquido dal circuito dei freni anteriori. La perdita di liquido dei freni potrebbe ridurre l'efficacia della frenata e aumentare gli spazi di arresto. Ciò potrebbe causare un incidente senza preavviso. Correzione: i concessionari rimuoveranno la corrosione esistente dal modulatore ABS e installeranno un kit per prevenire future corrosioni.
Transport Canada11 dic 19971997219Anni modello 1992Tradotto automaticamente · originale: ingleseVedi dettagli →
Nota: Include le berline della polizia Caprice, i taxi e le station wagon di servizio speciale; il carro funebre e la limousine Fleetwood. L'attacco del giunto sferico del braccio di controllo inferiore potrebbe essere allentato. Questa condizione può causare l'allentamento del giunto sferico del braccio di controllo inferiore, il suo affaticamento e il distacco dal fuso a snodo dell'sospensione anteriore. Se il distacco dovesse verificarsi con il veicolo in movimento, potrebbe verificarsi una perdita di controllo del veicolo, con conseguente possibile incidente stradale.
Correzione: I dadi di fissaggio del giunto sferico del braccio di controllo inferiore anteriore saranno ispezionati per verificarne la corretta coppia di serraggio. Se il giunto sferico si è allentato dal fuso a snodo, sia il giunto sferico sia il fuso a snodo saranno sostituiti.
Transport Canada12 feb 19961996025Anni modello 1995–1996Tradotto automaticamente · originale: ingleseVedi dettagli →
These vehicles do not comply with c.M.V.S.S. 102 - transmission shift control sequence. A misadjusted transmission shift control linkage may allow the transmission to be shifted out of the "p"(park) position with the ignition key removed. In the event of this condition occurring, the vehicle may roll from its parked position and cause potential damage and/or injury. Correction: Shift control linkage system will be adjusted.
Transport Canada29 nov 19951995211Anni modello 1995Mostrato in inglese originale · traduzione in attesaVedi dettagli →
These vehicles were produced with an improperly adjusted transmission shift control linkage. This does not meet with the requirements of fmvss no. 114, "theft protection."
NHTSA · Stati Uniti16 nov 199595V221000Anni modello 1995Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Certain vehicles do not comply with CMVSS 124 - Accelerator Control Systems. At low temperatures there may be excessive movement friction in the accelerator pedal assembly. In the event of a failure of a throttle return spring the engine speed may not decrease to the level anticipated by the driver when the foot is lifted from the accelerator pedal. Loss of accelerator control could result in a vehicle crash without prior warning. Correction: Accelerator pedal assembly will be replaced.
Transport Canada24 apr 19951995074Anni modello 1994–1995Mostrato in inglese originale · traduzione in attesaVedi dettagli →
These vehicles fail to conform to fmvss no. 124, "accelerator control systems." at low temperatures, excessive friction can occur in the accelerator pedal assembly.
NHTSA · Stati Uniti24 apr 199595V082000Anni modello 1994–1995Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Note: 1991 caprice sedans and wagons and roadmaster wagons and 1992 roadmaster sedans. The shoulder belt guide loop plastic covering may crack and expose the steel sub-plate. In the event of a severe vehicle crash, the exposed steel sub-plate may cut the safety belt webbing and result in an increased possibility and/or severity of injury to the affected seat occupant. Correction: New shoulder belt guide loops will be installed on involved vehicles.
Transport Canada29 giu 19921992076Anni modello 1991–1992Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The secondary hood latches on these vehicles can corrode causing a very high latch release effort and possibly preventing the hood from latching properly when it is closed. If the secondary hood latch is not properly engaged the hood could open unexpectedly. If this were to occur while the vehicle was in motion, the driver's forward vision would be impaired possibly resulting in a vehicle crash. Correction: A new scondary hood latch assembly with improved corrosion resistance will be installed on affected vehicles.
Transport Canada31 ott 19911991147Anni modello 1991–1992Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Secondary hood latch assemblies can corrode, causing a high latch release effort and possibly preventing the hood from latching properly when it is closed.
NHTSA · Stati Uniti29 ott 199191V186000Anni modello 1991–1992Mostrato in inglese originale · traduzione in attesaVedi dettagli →
These vehicles were shipped with both the supplemental inflatable restraint caution label and a roof rack caution label installed on the same side of the sun visor. This does not meet the requirements of fmvss no.208, "occupant crash protection."
NHTSA · Stati Uniti3 nov 199595V215000Anni modello 1995–1996Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0).