Bollettino
wiTECH Small Leak Verification Test (SLVT) - P0456-EVAP SYSTEM SMALL LEAK
🔔 Crea un account gratuito per ricevere avvisi via e-mail su Dodge Nitro (tutte le generazioni)
I bollettini tecnici (TSB) sono istruzioni di riparazione che i costruttori inviano ai concessionari su problemi noti. Non sono richiami di sicurezza, ma spesso confermano un difetto.
wiTECH Small Leak Verification Test (SLVT) - P0456-EVAP SYSTEM SMALL LEAK
Issue involves overheating, running hot, coolant leaks and related symptoms after a Mopar replacement engine has been installed in the vehicle.
Issue involves overheating, running hot, coolant leaks and related symptoms after a Mopar replacement engine has been installed in the vehicle.
Part Description: 5.7L Long Block Issue Description: This 5.7L Long Block Assembly is compatible with both EGR and Non-EGR applications. An EGR Block-Off Plate (53032739AA) must be ordered when installing this Long Block Assembly in a Non-EGR application. Unless, the EGR Block-Off Plate is being transferred from the old engine.
Service - Four Piece Oil Pan Gasket All Cummins Equipped Vehicles ONLY - The replacement oil pan gasket can be a four piece gasket rather than a single piece gasket. This applies to Cummins 5.9L and 6.7L engines only. Installation: 1. Clean the oil pan T-joints.~ 2. Fill the T-joint between the pan rail/gear housing and pan rail/rear seal retainer with sealant. Use Mopar Silicone Rubber Adhesive Sealant or equivalent. 3. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the oil pan flange.~ 4. The four piece gasket will need to be assembled to make a complete oil pan gasket. 5. Lay the oil pan gasket(s) onto the oil pan flange.~ 6. Ensure the oil pan gasket segment joints are properly aligned. 7. Apply a 2-mm [0.063-in] bead of Mopar Engine Sealant RTV Silicone Rubber Adhesive, to the top of the oil pan gasket.~ 8. Install the oil pan. Starting from the center and working outward, tighten the oil pan bolts to 28 Nm [21 ft. lbs.].
Adaptive Cruise Control Sensor 1) If you are replacing this part due to the cluster displaying Clean Radar Sensor in Front of Vehicle or DTC C1266 ACC Sensor Blinded, please verify that there is no blockage in front of the sensor. Blockage can occur from mud, ice, snow, front end damage, bracket damage, the sensor not attached to the bracket properly or an aftermarket fascia installed. This fault can occur intermittently in muddy or icy/snowy conditions and is considered normal operation. Under some circumstances, a misaligned sensor can also cause the C1266 DTC, please complete an alignment procedure. No replacement is required.~ 2) If you are replacing this part due to the cluster displaying ?ACC/FCW Unavailable Service Required?, please check the DTC fault codes. This will indicate which module needs to be serviced (TCM, PCM, ESP/ABS, etc). This fault is not due to the ACC Sensor. No sensor replacement is required.~ 3) If you have fault code DTC C125E ACC Sensor Adjustment Required, please verify that the radar sensor is fully seated in the clips and there is no damage (if clips are damaged on a 2013 or earlier vehicle, order P/N 68085813A$, otherwise please replace the module), please verify there is no blockage to the sensor due to mud, ice, snow, front end damage, bracket damage or the sensor not attached to the bracket properly. Perform the Vertical Alignment and the Electronic Horizontal Alignments procedure as stated in the service manual. Please note, if the horizontal alignment procedure will not complete, check the vertical alignment and confirm that the sensor is seated properly. Rerun the horizontal alignment procedure. No sensor replacement is required. **Hints for running Horizontal Alignment procedure: A) Verify speed is between 45 and 75 mph, B) verify the road is relatively straight with signs, poles, guard rails, etc C) Do not tail a vehicle too closely this inhibits the learning procedure
Ram/dodge\jeep service campaign: See document search button for owner letter. The engine water pump on certain vehicles may leak coolant. Engine operation with a low coolant level could cause engine damage or low cabin heater output. Csc letter was rec'd. *pe
Chrysler\dodge service campaign: See document search button for owner letter. An incorrect positive crankcase ventilation (pcv) valve may have been installed. An incorrect pcv valve can cause excessive exhaust emissions. Csc letter was received. *pe
Emissions recall g45--veci label - an incorrect vehicle emission control information (veci) label was installed on about ten thousand vehicles. The originally installed veci label does not display the correct spark plug information. *nj
Slight play in steering/stiff/choppy/bumpy ride. *nj
Steering angle sensor - not initialized/internal. *kb
LIFTER, Hydraulic Roller Deactivating Non sostituire i punterie MDS perché il perno di disinnesto non è allineato: questo è normale e non è un difetto.
**PUNTERIA, a rullo idraulica con disattivazione** Si prega di non sostituire le punterie MDS se il perno di disinserimento non è allineato: si tratta di una condizione normale e non di un difetto.
KEY, Master Se sostituisci la chiave/FOBIK su un CRUISER WJ, KJ, TJ o PT, usa il numero di parte del livello NIC "AC". Il livello NIC "AB" non viene programmato su queste piattaforme. Per tutte le altre piattaforme, se il livello NIC "AB" non si programma sul veicolo, usa il componente a livello NIC "AC" e invia una garanzia del pezzo.
Customer Satisfaction Notification V51 Reprogram Powertrain Control Module
Warranty Bulletin D-20-17 (X85) Active Head Restraint - Select 2012-2013 Jeep Liberty (KK) and 2012 Dodge Nitro (KA) (Rev. A)
KEY, Master Se sostituisci la chiave/FOBIK su un CRUISER WJ, KJ, TJ o PT, usa il numero di parte del livello NIC "AC". Il livello NIC "AB" non viene programmato su queste piattaforme. Per tutte le altre piattaforme, se il livello NIC "AB" non si programma sul veicolo, usa il componente a livello NIC "AC" e invia una garanzia del pezzo.
Gear Ratio DTC?s, Transmission Shift Concerns, Does Not Shift At Times, Shudders
Kit trasmissione con convertitore di coppia 1. Tutti i veicoli dotati di Promaster (VF) 3.6L/62TE. Se durante la manutenzione viene rimossa la staffa del cambio ai fissaggi della cassa del cambio, questi (numero di parte 06511385A$) sono ad uso una tantum. I veicoli costruiti prima del 23/10/2015 richiedono il kit di assistenza PN 68461214AA; include l'isolatore di trasmissione PN 68264483AA, la staffa di adattamento 68264479AA e il kit di assistenza fissaggio PN 68329056AA I veicoli costruiti dopo il 23/10/2015 richiederanno solo il kit di assistenza con fissaggi PN 68329056AA. 2. Tutti i veicoli equipaggiati con 3.6L/62TE. Se il veicolo che stai riparando ha una crepa nella piastra flessibile o un bushing della pompa guasto, ispeziona e conferma che entrambi i perni del perno siano presenti nel blocco motore, allineando la linea centrale della trasmissione con il centro dell'albero motore e ispezionando visivamente i fori di allineamento del perno. Se i fori sono danneggiati o allungati, la trasmissione deve essere sostituita per evitare ulteriori danni al cambio/pistone flexo o al bush della pompa dovuti all'incapacità di allineare correttamente il motore durante la riparazione. 3. Tutti i veicoli dotati di 62TE. Se il sensore TCC è a posto, i codici indicano un guasto del convertitore di coppia. Sostituisci il convertitore di coppia.
Warranty Bulletin D-20-21 (X91) Active Head Restraint - Select 2010 Dodge Journey (JC), Dodge Avenger/Chrysler Sebring (JS), Dodge Nitro (KA), Jeep Liberty (KK), Jeep Compass/Jeep Patriot (MK), Dodge Caliber (PM), Dodge Caravan (RT)
Warranty Bulletin D-20-22 (X92) Active Head Restraint - Select 2011 Dodge Journey (JC), Dodge Avenger/Chrysler 200 (JS), Dodge Nitro (KA), Jeep Liberty (KK), Jeep Compass/Jeep Patriot (MK), Dodge Caliber (PM), Dodge Caravan (RT), Dodge Durango (WD), Jeep Grand Cherokee (WK)
Warranty Bulletin D-20-17 (X85) Active Head Restraint - Select 2012-2013 Jeep Liberty (KK) and 2012 Dodge Nitro (KA) (Rev. B)
Warranty Bulletin D-20-21 (X91) Active Head Restraint - Select 2010 Dodge Journey (JC), Dodge Avenger/Chrysler Sebring (JS), Dodge Nitro (KA), Jeep Liberty (KK), Jeep Compass/Jeep Patriot (MK), Dodge Caliber (PM), Dodge Caravan/Chrysler Town & Country (RT) (Rev. A)
Active Head Restraint (AHR) Inadvertent Deployment - X92 Warranty Extension This bulletin involves inspecting the sled bracket striker pin and possibly replacing a front seat AHR that has inadvertently deployed. Customers may comment on the following:The AHR is deployed on one or both front seats and will not reset.
Active Head Restraint (AHR) Inadvertent Deployment - X91 Warranty Extension This bulletin involves inspecting the sled bracket striker pin and possibly replacinga front seat AHR that has inadvertently deployed. Customers may comment on the following: The AHR is deployed on one or both front seats and will not reset.
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0).