定速走行装置
ブレーキのマスターシリンダーに取付けられている定速走行装置解除スイッチにおいて、当該解除スイッチ内部のシール構造が不適切なため、ブレーキ液が漏れて内部の電気端子にかかり、接点が腐食することがある。そのため、スイッチ内部の抵抗値が高くなり、スイッチが加熱されて溶解し、最悪の場合、火災に至るおそれがある。
🔔 Crea un account gratuito per ricevere avvisi via e-mail su Ford Explorer I
ブレーキのマスターシリンダーに取付けられている定速走行装置解除スイッチにおいて、当該解除スイッチ内部のシール構造が不適切なため、ブレーキ液が漏れて内部の電気端子にかかり、接点が腐食することがある。そのため、スイッチ内部の抵抗値が高くなり、スイッチが加熱されて溶解し、最悪の場合、火災に至るおそれがある。
灯火装置において、前照灯スイッチの内部構造が不適切なため、スイッチ内部の接点で電 気抵抗が増加して過熱、溶損し、前照灯が点灯しなくなるか、消灯しなくなることがあり 、最悪の場合、火災に至るおそれがる。
運転者席のドアに取り付けられている電動式ドアミラースイッチに雨水等が侵入した状態 でスイッチ操作を行うと、スイッチ内部が短絡することがあり、最悪の場合、火災に至る おそれがある。
If a short circuit occurs in the power mirror switch there is the potential risk of fire at or near the mirror switch (located in the driver's door). Overheating of the switch assembly creates the risk of an unattended vehicle fire. Correction: A fused jumper harness will be installed in the power mirror electrical circuit.
A short circuit condition can occur in the remote power mirror control switch circuit board as a result of a separated part of the contact assembly bridging the switch positive battery pad and adjacent chassis ground pad.
The hot plate weld which attaches the vapour vent valve to the top of the plastic fuel tank may partially fracture, allowing vapour or fuel to escape from the top of the tank through the fracture. In the presence of an ignition source a fire could result. Correction: Tanks will be removed and inspected for the weld integrity of the vapour vent valve carrier. Tanks with inadequate welds will be replaced.
The corner of the front heat shield may contact the upper front corner of the plastic fuel tank. This could damage the tank and allow fuel or fuel vapour to escape. In the presence of an ignition source, a fire could occur. Correction: Heat shield will be relocated and fuel tank will be inspected. Fuel tanks damaged by heat shield will be replaced.
The hot plate weld which attaches the vapor vent valve carrier to the top of the plastic fuel tank may partially fracture, allowing vapor of fuel to escape from the top of the tank.
The front heat shield may contact the front of the plastic fuel tank, causing cuts or other damage to the extent of penetration.
파워 트레인 컨트롤 모듈 리프로그래밍 업데이트 시 과정의 일부인 학습 명령이 이루어지지 않을 수 있으며 이 조건으로 인해 차량의 작동에는 이상이 없으나 OBD시스템이 정상적으로 작동하지 않을 수 있는 결함
長期間(装着から3年以上を経過している場合)使用されたタイヤにおいて、引き続き使 用を続けると、トレッド部が剥離することがあり、最悪の場合、トレッド部又はトレッド 部とその内側のアウタースチールベルトが剥がれ落ち、走行安定性が損なわれるおそれが ある。
Certain vehicles, from Ontario to Newfoundland, could experience a corrosion related failure of the spare tire winch cable. If the cable breaks while the vehicle is being driven, the spare tire could drop down, potentially creating a roadway obstacle. Correction: Owners are to inspect the cable, and if corrosion or broken wire strands are present the vehicle is to be taken to a dealer for replacement of the winch assembly. Program ends September 30, 2003.
前輪緩衝装置において、スタビライザーバーとロアアームを連結するリンクの強度が不足 しているため、そのままの状態で使用を続けると、当該リンクが折損し、最悪の場合、ス タビライザーバーがロアアームから外れ、走行安定性が損なわれるおそれがある。
Vehicle description: On certain sport utility vehicles, the hydraulic lift cylinder bracket welds could fracture.
점화케이블 불량, 부품교환
연료게이지의 계기 지시오차 발생, 수리
Vehicle description: Multi-purpose passenger vehicles equipped with factory installed sunroof. The sunroof glass panel assembly can separate while the vehicle is moving due to incorrect hinge engagement. This was caused by improper sunroof installation of the glass panel.
I componenti filettati (prigionieri) che fissano il cilindro principale del freno al gruppo servofreno a depressione possono sviluppare una fessurazione per corrosione sotto sforzo dopo un funzionamento prolungato nella zona della California meridionale.
後面扉を開けたときの支持棒を取り付けているブラケットの溶接に不適切なものがあり 、そのままの状態で使用を続けると、ブラケットが外れ、最悪の場合、後面扉が不用意に 降下するおそれがある。
Defect: The hydraulic lift cylinders on these vehicles are attached to brackets that are welded to the liftgate. Under certain conditions, the bracket welds may fracture due to the brackets being inadvertently mislocated relative to the liftgate. There may be a potential for the liftgate bracket to gradually bend inward which might allow the lift cylinder ball stud to disengage. Correction: Reinforcement brackets will be installed.
The hydraulic lift cylinders are attached to brackets that are welded to the liftgate. The bracket welds can fracture.
Note: This recall affects vehicles with manual transmission. The parking brake control self-adjust pawl may skip over one or more teeth in the self-adjust ratchet during parking brake application, which could prevent the system from achieving full tension. This could result in parking brake ineffectiveness which would allow the vehicle to roll freely if it is not left in gear. Correction: A wedge will be installed which will serve to lock the parking brake self-adjust mechanism pawl into engagement with the ratchet.
The parking brake control self-adjust pawl does not line up properly with the self-adjust rachet causing the pawl to slip over one or more teeth in the rachet.
Seat belt buckles on these vehicles may experience conditions whereby the buckle may not unlatch when the release button is depressed or may not latch, or in some cases, may latch partially but not sufficiently to provide occupant restraint in the event of a collision. Note: Only end-release buckles on "rigid" mountings are susceptible to this malfunction. Correction: Factory installed end-release seat belt buckles will be replaced with redesigned buckles.
The rigid mounted safety belt buckles are defective in three ways. First, a fastened safety belt buckle will not unlatch when the release button is depressed. This results from interference between the buckle ejector finger and the buckle tongue window. The second defect is the safety belt buckle may not latch. The third possible defect is that the tongue may be retained by the buckle, but it may not be latched sufficiently to provide occupant protection.
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).