Seats:Front assembly:Recliner
The power seat or recliner wiring harness can be pinched or can chafe on the seat frame or spring support rod, wearing through the wire insulation and causing an electrical short.
🔔 Crea un account gratuito per ricevere avvisi via e-mail su Pontiac 6000
The power seat or recliner wiring harness can be pinched or can chafe on the seat frame or spring support rod, wearing through the wire insulation and causing an electrical short.
The fuel feed hose could leak at the coupling on the engine end of the hose assembly. This condition could allow fuel to leak into the engine compartment and possibly result in an engine compartment fire. Correction: Fuel feed hose assembly will be inspected and replaced if necessary with a new hose assembly.
Fuel feed hose could leak at the coupling on the engine end of the hose assembly.
Front suspension lower control arm bracket could develop metal cracks.
Sui veicoli con motori da 2.5 l. Il sistema di alimentazione del carburante può perdere in corrispondenza del collegamento del tubo di alimentazione del carburante per l'iniezione nel corpo farfallato, con il possibile rischio di incendio nel vano motore.
Il sistema di alimentazione del carburante potrebbe presentare una perdita in corrispondenza del raccordo del tubo di alimentazione del carburante all'iniettore del corpo farfallato. Conseguenza del difetto: questa perdita potrebbe causare un incendio nel vano motore, che potrebbe propagarsi all'abitacolo e causare ustioni agli occupanti.
Le valvole dosatrici del freno possono rompersi e staccarsi dal cilindro principale durante la frenata. Ciò causerà una perdita di liquido dei freni e una perdita parziale dell'azione frenante.
The rear brake hoses were not fully seated into their fittings when the fittings were crimped onto the hose at the time of manufacture. Hose failure would cause loss of brake fluid and partial loss of braking action thereby increasing stopping distance.
Under certaain conditions, the hose clamps on the fuel tank filler pipe and fuel tank filler vent pipe could fracture. The fracture of these clamps could cause fuel leakage at any of the four pipe to hose connections. Leakage can occur during refueling, or while driving, if the fuel tank is above 3/4 full.
Under certain conditions the hose clamps on the fuel filler pipe and fuel tank filler vent pipe could fracture. This could cause seepage of fuel at any one of the four pipe to hose connections when the fuel tank is above 3/4 full creating the possibility of fire.
These vehicles were assembled with rear outboard safety belt anchorages that may not withstand the required load. This does not comply with fmvss no.210, "seat belt assembly anchorages."
On certain vehicles, the power seat or recliner wiring harness may become pinched or chafed causing possible short circuits. These short circuits may then cause the circuit breaker to weld closed and the unprotected short circuit could overheat and possibly ignite the seat cushion materials. Correction: Wiring harness will be inspected and harness rerouted using a wiring harness clip.
The anti lock brake system (abs) pressure/warning switch may exhibit brake fluid seepage which eventually can lead to loss of the brake system hydraulic pump motor. Additionally, the hydraulic pump motor and abs electrical relays may have been exposed to water contamination during vehicle assembly. This condition can cause loss of the hydraulic pump motor and/or loss of the abs function.
6000 ste models only. On vehicles with anti-lock brakes, the abs relay and/or the hydraulic pump motor relay may become inoperative due to corrosion. An inoperative abs relay could cause the loss of the abs function. Also, a loss of the hydraulic pump motor relay could cause the loss of the rear brakes as well as power assist to the front brakes. This could result in increased stopping distances and vehicle crash without prior warning. Correction: Relays will be replaced.
These vehicles do not comply with c.M.V.S.S. 212 - windshield mounting. - poor bond adhesion between windshield glass and mounting. Correction: Windshields will be removed and reinstalled on all affected vehicles.
Poor bond adhesion between the windshield glass and mounting could allow the windshield to separate during a 30 mph frontal barrier test required by fmvss 212.
Il commutatore dei fari a tiro-spinta può presentare contatti elettrici che consentono un circuito dei fari intermittente, causando lo sfarfallio dei fari o lo spegnimento improvviso. Conseguenza del difetto: la perdita improvvisa dei fari in condizioni meteorologiche avverse o durante la guida notturna può ridurre la visibilità del conducente, con il possibile rischio di un incidente stradale senza preavviso.
On certain vehicles, the push-pull headlight switch may have been manufactured with electrical contacts which allow an intermittent headlight circuit. An intermittent circuit could cause the headlights to suddenly go out. Under severe weather or nighttime driving conditions, driver visibility could be reduced, possibly resulting in a vehicle crash.
The push-pull headlight switch may have electrical contacts which allow an intermittent headlight circuit causing headlight to flicker or suddenly go out. Consequence of defect: Sudden loss of the headlights under severe weather or nighttime driving conditions could reduce driver visibility which might result in a vehicle crash without prior warning. Note: Also, see nhtsa campaign number 86v131000.
These vehicles may not comply with c.M.V.S.S. 1103 - exhaust emissions.
The throttle linkage may bind because during normal operation, the throttle body case may interfere with the linkage. This interference could prevent the throttle from closing even though the driver has removed his foot from the accelerator pedal.
THE THROTTLE LINKAGE RETAINING CLIP MAY INTERFERE WITH THE THROTTLE BODY CASTING DURING NORMAL ROTATION OF THE THROTTLE LEVER. THIS COULD ALLOW THE ACCELERATOR LINKAGE TO BIND AND PREVENT THE THROTTLE FROM CLOSING. iF THIS WERE TO OCCUR, VEHICLE SPEED WOULD REMAIN CONSTANT EVEN THOUGH THE DRIVER HAS REMOVED HIS FOOT FROM THE ACCELERATOR PEDAL. LOSS OF ACCELERATOR CONTROL COULD RESULT IN A VEHICLE CRASH WITHOUT PRIOR WARNING.
Station wagons only. The remote tailgate lock release on these vehicles is designed so that the tailgate lock can be released only when the transmission is in park. Due to an electrical wiring error the remote release button can be activated while the vehicle is moving, allowing the tailgate to open. This might result in injuries to passengers in the rear compartment area.
Vehicles may have been wired improperly so that the tailgate lock can be released when the vehicle is not in park or is in motion.
Su alcuni veicoli, i meccanismi di bloccaggio dello schienale dei sedili anteriori potrebbero non bloccarsi in condizioni di carico frontale e pertanto non sono conformi alla norma CMVSS 207 - Ancoraggi dei sedili.
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).