DEFECT: THE (Takata) ABS PLASTIC FRONT SEAT BELT RELEASE BUTTONS ON THESE VEHICLES MAY BREAK ALLOWING PLASTIC PIECES TO FALL INTO THE BUCKLE ASSEMBLY. IF THIS SHOULD HAPPEN, A NO LATCH, FALSE LATCH OR FAILURE TO UNLATCH CONDITION COULD OCCUR CREATING THE RISK OF PERSONAL INJURY IN THE EVENT OF A CRASH OR SUDDEN STOP. CORRECTION: FRONT SEAT BELT BUCKLES WILL BE REPAIRED OR REPLACED AS NECESSARY.
Transport Canada5 giu 19951995107Anni modello 1987–1991Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Insufficient clearance between the relocated alternator wiring and the solenoid hose alternator wiring stay bracket can cause wire chaffing and an electrical short.
NHTSA · Stati Uniti9 mar 198888V029000Anni modello 1988Mostrato in inglese originale · traduzione in attesaVedi dettagli →
The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press." if a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.
NHTSA · Stati Uniti24 mag 199595V103006Anni modello 1987–1991Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Certain vehicles do not comply with CMVSS 108 - Lighting. The resinous reflex reflectors of the front parking/side marker lamps do not meet the photometric requirements of the Standard. Correction: Front parking/side marker lamps will be replaced on affected vehicles.
Transport Canada12 mar 19911991043Anni modello 1989–1990Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Due to the design of the transmission case dipstick and the fluid level checking method, there may be insufficient lubrication of the 4 wheel drive extension housing bearing.
NHTSA · Stati Uniti28 feb 198989V028000Anni modello 1988–1989Mostrato in inglese originale · traduzione in attesaVedi dettagli →
On vehicles with 5 speed transmission and 4wd the design of the transmission case dipstick and the fluid level checking method described in the owner's manual may result in insufficient lubrication of the 4wd extension bearing. This could lead to bearing seizure and possible rear wheel lock-up which could in turn lead to loss of vehicle control and a crash without prior warning. Correction: Vehicles will be inspected and the transmission case will be filled to the proper fluid level. A modified dipstick will be installed and an insert for the owner's manual describing the correct fluid level checking procedure will be provided.
Transport Canada8 mar 19891989031Anni modello 1988–1989Mostrato in inglese originale · traduzione in attesaVedi dettagli →
Fonti: NHTSA (Stati Uniti, pubblico dominio), Transport Canada (Open Government Licence – Canada), DVSA (Regno Unito, Open Government Licence v3.0), RappelConso e Safety Gate UE (Francia, Licence Ouverte 2.0), MLIT (Giappone, Public Data License 1.0) e MOLIT (Corea del Sud, car.go.kr).