技術通報
This bulletin contains repair instructions for when an oil leak is present around the ATF sump. 2018 A5 Sportback
🔔 無料アカウントを作成して Audi A5 (すべての世代) のメール通知を受け取る
技術サービス通報(TSB)は、既知の不具合についてメーカーが販売店に送る修理指示です。安全リコールではありませんが、不具合の裏付けになることがよくあります。
This bulletin contains repair instructions for when an oil leak is present around the ATF sump. 2018 A5 Sportback
本技術情報には、ATFサンプ周辺にオイル漏れがある場合の修理手順が記載されています。2018年式 A5 Sportback も対象に含まれます。
この技術情報には、ATFサンプ周辺でオイル漏れが発生した場合の修理手順が記載されています。
This bulletin contains repair instructions for when an oil leak is present around the ATF sump.
リフト上点検セクション: 取り外し 「ELSAで冷却水リザーバーキャップの圧力試験を実施する -> VIN番号を入力 -> 修理マニュアル Engine -> 4-Cylinder Direct Injection 1.8L; 2.0L 4V TFSI Engine (Generation III) -> 19 Cooling System -> Coolant System/Coolant -> Cooling System, Checking for Leaks -> Pressure Relief Valve in Cap, Checking」。文書「Cooling System, Checking for Leaks」では、手順「Pressure Relief Valve in Cap, Checking」のみを実施すること。
Supersedes Technical Service Bulletin Group 87 number 14-56 dated September 12, 2014. The air conditioning does not cool, or the cooling performance is very weak. The air conditioning system cools, but the compressor is noisy. The noise is characterized as a grinding or groaning noise. Either symptom may be intermittent . No DTCs are stored. The condition may be caused by a faulty N280 valve. The internal components of the valve can be obstructed and incapable of full function. This loss of refrigerant regulation from N280 can cause noise from the A/C compressor and/or affect the HVAC cooling. The Denso A/C compressor is currently being installed in production. An improved N280 valve for the Sanden A/C compressor is in development, as the installation of Sanden compressors for production will resume in the future.
MIL on. DTCs for the cam actuators are stored in ECM memory. After the activation of the cam actuator to change to the other cam profile, the pin of the actuator is pushed back in by the cam. This is confirmed by a voltage impulse, which is registered by the engine control unit and confirms the operation. If this does not happen, or not at the right time, a DTC "implausible signal" is saved in ECM memory. Check the distance of the pin tip of the cam actuator for valve lift system to the camshaft when it is not operated with a gauge. The measurement of the tip to the basic camshaft circle outside of the groove must be taken. If this measurement is 0.9mm, the actuator 06E103697J must be installed. The actuator 06E103697J must only be used, if the measurement is 0.9mm or bigger.
Audi: エンジン上部からエンジンオイルが漏れている可能性があります。カムキャリアの鋳造部品に気孔(ポロシティ)があるため、オイルがカムボルトのねじ山に流れ込み、エンジン外部からの漏れを引き起こすことがあります。すべてのボルトはロックタイト(Loctite)で取り付けられています。*pe
This bulletin provides information regarding the oil change necessary when replacing an engine control unit.
This TSB provides information about engine control unit drive system faults P060C00 and U041600.
This bulletin provides information for when there is an Engine Start system warning, or Power Unit start system warning, B200047.
Under extreme driving conditions (e.g. long idle periods or extended stop and go traffic), high temperatures build up in the rail system and can lead to steam bubbles in the fuel.
This bulletin advises on the repair recommendation for a squeaking, grinding, or tweeting noise coming from the engine compartment. DTC P2BA300 may be stored.
Under extreme driving conditions (e.g. long idle periods or extended stop and go traffic), high temperatures build up in the rail system and can lead to steam bubbles in the fuel.
Under extreme driving conditions (e.g. long idle periods or extended stop and go traffic), high temperatures build up in the rail system and can lead to steam bubbles in the fuel.
This bulletin advises to replace the fuel tank in instances where the fuel filler neck has a ridge or obstruction preventing filling the tank.
One or more fuel injectors may be stuck open, allowing fuel to enter the combustion chamber when the engine is hot. Drop in fuel pressure may cause delayed restart of the engine (?long crank?) and/or rough idle after startup.
A highly sporadic startup timing issue can cause a message "CNG inspection Due! CNG Mode not available. Please contact workshop". This is a normal condition which can be resolved by recycling the ignition and repairs are not needed.
A highly sporadic startup timing issue can cause a message "CNG inspection Due! CNG Mode not available. Please contact workshop". This is a normal condition which can be resolved by recycling the ignition and repairs are not needed.
OIL CHART SECTION: CHANGED - Castrol Oil to 'Audi approved XXXX-Refer to the Parts Catalog' for all models.
OIL CHART SECTION: CHANGED - Castrol Oil to 'Audi approved XXXX-Refer to the Parts Catalog' for all models.
This bulletin contains repair instructions for when the fuel pump shuts off while refueling before the tank is full.
OIL CHART SECTION: Changed oil viscosities: 502.00 - Castrol EDGE Professional 5W-40 and 504.00 / (507.00 Diesel) - Castrol EDGE Professional 0W-30 LL03 (Updated from 5W-30) TTRS
Vehicle Emissions Control Information Label
Oil Capacity Table: Changed Oil Specs for all models
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。