閲覧無料 · 投稿は無料アカウントでAnticars(2000年)の後継

BMW 7シリーズ E32

1986–1994 · 不具合5件 · 4市場
年式
リコール重大エンジンNA

Fuel System

On certain 318I, 318IC, 318IS, 325IC, 325IS, 325IX, 525I, 535I, 735I and 735IL vehicles, the fuel feed hose could harden and "set" over time due to engine compartment temperatures. If this "setting" occurs, it is possible that seepage between the hose and fitting could result because the clamp cannot provide sufficient sealing force to compensate for the hardening of the hose. Fuel seepage, in the presence of an ignition source, could result in an engine compartment fire. Correction: fuel feed hoses and associated clamps will be replaced with ones of a new design.

カナダ運輸省1994年5月30日1994096モデルイヤー 1989–1993原文(英語)で表示中 · 翻訳待ち詳細を見る →
リコール重大エンジンNA

Fuel system, gasoline:Delivery:Hoses, lines/piping, and fittings

Feed fuel hoses can harden and "set" over time, allowing a seepage of fuel at the connection between the hose and the engine fitting. The clamp used to hold the hose to the fitting is unable to compensate for the hardening of the feed fuel hose.

NHTSA · 米国1994年4月11日94V066000モデルイヤー 1989–1993原文(英語)で表示中 · 翻訳待ち詳細を見る →
リコール中程度エンジンNA

Engine and engine cooling:Cooling system

Vehicle description: Passenger vehicles. A malfunction or failure of a coolant system component, such as a thermostat, water pump, or fan belt, can result in significantly increased coolant temperature and system pressure. If the indications of a critical overheating condition is not noticed by the driver, it is possible that damage to, or failure of, a coolant system component could occur.

NHTSA · 米国1998年8月4日98V178000モデルイヤー 1988–1993原文(英語)で表示中 · 翻訳待ち詳細を見る →
リコール中程度エンジンNA

Engine

On certain 318IC, 318IS, 318TI, 325I, 325IC, 325IS, 525I, 525IT, 530I, 530IT, 540I, 740I, 740IL, 840CI and M3, the cruise control and throttle cable are attached to the same throttle valve actuating lever at the throttle housing. It is possible that the plastic bushing on either cable could break causing the outer cable housing to separate from the bushing. Throttle pedal application without cruise control engagement could cause the outer tube to catch on the edge of the broken bushing resulting in the throttle valve remaining partially open. If this were to occur, the car might not decelerate as expected and a crash could occut. Correction: A spring clip will be installed on the outer tube of each cable to prevent dislodgment from the bushing.

カナダ運輸省1997年10月9日1997173モデルイヤー 1993原文(英語)で表示中 · 翻訳待ち詳細を見る →
リコール中程度エンジンNA

Vehicle speed control

The cruise control and throttle cables are attached to the same throttle valve actuating lever at the throttle housing. It is possible that the plastic bushing on either cable could break due to environmental influences coupled with vibration. If the bushing breaks, the outer cable housing can separate from the bushing. In this case, during application of the throttle pedal without cruise control being engaged, the outer tube could catch on the edge of the broken bushing.

NHTSA · 米国1997年8月19日97V131000モデルイヤー 1993原文(英語)で表示中 · 翻訳待ち詳細を見る →
リコール中程度エンジンNA

Engine

On certain 740IA and 740ILA vehicles, the inner throttle cable could break due to a smaller than specification bend in the cable tube. If this were to occur, throttle control would be lost and the engine would return to or remain at idle. Correction: Throttle cable will be replaced with one meeting BMW specifications.

カナダ運輸省1994年4月25日1994081モデルイヤー 1993原文(英語)で表示中 · 翻訳待ち詳細を見る →
リコール中程度エンジンNA

Vehicle speed control:Cables

The throttle cable's tube (outer casing) contains a bend that leads to increased loading of the inner cable, causing it to break.

NHTSA · 米国1994年1月3日94V022000モデルイヤー 1993原文(英語)で表示中 · 翻訳待ち詳細を見る →
リコール中程度エンジンNA

Engine

On certain 535I, 535IA, 735IA, 735ILA vehicles, the nut which secures the throttle valve shaft may not have been tightened with sufficient torque. If the nut were to loosen, it is possible that movement of the throttle valve might be impaired. If this should occur, the vehicle might not decelerate as expected after the gas pedal is released and loos of vehicle control could result. Correction: Vehicles will be inspected and affected throttle housings with undertorqued throttle valve retaining nuts will be replaced.

カナダ運輸省1992年10月13日1992129モデルイヤー 1991原文(英語)で表示中 · 翻訳待ち詳細を見る →
リコール中程度エンジンNA

Vehicle speed control

Some of these vehicles are equipped with a throttle housing on which the throttle valve shaft retaining nut was not sufficiently tightened.

NHTSA · 米国1992年7月10日92V101000モデルイヤー 1991原文(英語)で表示中 · 翻訳待ち詳細を見る →
リコール中程度エンジンNA

Emissions

Certain 750IL vehicles fail to comply with the requirements of CMVSS 1103 - Exhaust Emissions.

カナダ運輸省1989年5月2日1989063モデルイヤー 1988–1989原文(英語)で表示中 · 翻訳待ち詳細を見る →
リコール中程度エンジンNA

Emissions

Certain 750IL vehicles fail to comply with the requirements of CMVSS 1103 - Exhaust Emissions

カナダ運輸省1989年5月2日1989062モデルイヤー 1988–1989原文(英語)で表示中 · 翻訳待ち詳細を見る →
リコール中程度エンジンNA

Engine

On certain 750IL vehicles, during the assembly process, the gas pedal may not have been properly attached to the floor pan. If the gas pedal is operated in a rough or erratice manner, it may become stuck between the gas pedal stop (on the floor pan) and the carpeting on the transmission tunnel. If this occurs, the pedal might not return fully to the idle position when the driver's foot is removed and loss of control could result. Application of the brake pedal will close the throttle on this model of vehicle. Correction: Accelerator pedal will be inspected and tightened to the floor is required. Also, a modified pedal stop will be installed.

カナダ運輸省1989年4月6日1989046モデルイヤー 1988–1989原文(英語)で表示中 · 翻訳待ち詳細を見る →

出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。