技術通報
特定の車両に不良の電気補助ヒーターが設置されている可能性があります。これにより、車内で使用される電気補助ヒーターの故障につながる可能性があります。
🔔 無料アカウントを作成して BMW i4 (すべての世代) のメール通知を受け取る
技術サービス通報(TSB)は、既知の不具合についてメーカーが販売店に送る修理指示です。安全リコールではありませんが、不具合の裏付けになることがよくあります。
特定の車両に不良の電気補助ヒーターが設置されている可能性があります。これにより、車内で使用される電気補助ヒーターの故障につながる可能性があります。
A faulty electric auxiliary heater may have been installed in the certain vehicles. This could result in the failure of the electric auxiliary heater.
A faulty electric auxiliary heater may have been installed in the certain vehicles. This could result in the failure of the electric auxiliary heater.
There is coolant leaking from under the car Low heater output Possible Check Control message Drive, you can continue driving (ID49) Possible fault codes stored in these BEV vehicles: 224163 Electric auxiliary heater for the high-voltage battery unit: Undervoltage or internalcommunication fault 8049AA - Coolant level sensor, expansion tank: Coolant level low or short circuit to ground or linedisconnection 80124F Electric auxiliary heater: Communication in electric auxiliary heater faulty 224F60 - Coolant level sensor, expansion tank: Coolant level low or short circuit to ground or linedisconnection 224111 - Cooling system for power electronics: Coolant loss detected 224107 - Cooling system for high-voltage battery unit, component protection: Detection of coolantloss
A manufacturing defect in high-voltage cells of the high-voltage battery can result in electrolyte leakage which might result in a conductive connection with surrounding components. Depending on the contact resistance, a yellow or red Check Control message will then be displayed; it is permitted for you to continue driving, but this will result in a charging interruption during charging.
The customer states that the hazard warning lights flash and cannot be switched off.
制御メッセージを確認してください:「運転を続けてください。駆動系(00029)が表示されます。以下の故障コードがCCUの故障メモリに保存されています:224188 アクセルペダルモジュール、ペダルセンサー、センサー1、センサー2:信号が不自然。故障に関連する走行性に関する苦情がある場合もあれば、そうでない場合もあります。
A whistling noise is heard from the centerconsole/instrument panel when using theheating and air conditioning (HVAC) system. Heard with the blower motor set tospeed 2 or above Noise goes away on high blower speed Noise is loudest with the vents on theback of the center console in the closedposition Noise is heard the most near thecharging tray (where center consolemeets instrument panel)
Charging sessions cannot be started or they are interrupted while using a Level 2 AC high-power chargingstation, or with a Level 3 DC charging station. Charging may start normally but can interrupt after some time. Level 2 (240 V) Flex Charger and Wall boxmay also be affected. The red or white LED is displayed on the high-voltage charging socket; however, no associated fault codesare stored.
Gen 5 BEV/PHEV vehicles may set the Combined Charging Unit (CCU) in programming abort due to no communication to the HV charge socket electronics.
Charging sessions cannot be started or they are interrupted while using a Level 2 AC high-power charging station, or with a Level 3 DC charging station. Charging may start normally but can interrupt after some time. Level 2 (240 V) Flex Charger and Wall box may also be affected. The red or white LED is displayed on the high-voltage charging socket; however, no associated fault codes are stored.
A manufacturing defect in a bearing of the electronic drive unit could result in bearing damage. This is caused by an unusual acoustic signal in the area of the drive unit. The bearing could fail completely at a later stage, which will be displayed to you by means of a red Check Control message. In this case, the driver is asked to call BMW Roadside Assistance.
The Combined Charging Unit (CCU) may not have been built to specifications.
Inspection and Return - Linkage for Wiper System
Delivery Stop Electric Auxiliary Heater
The Check Control message (CCM): "You can continue driving. Drivetrain (00029) is displayed, togetherwith the following fault code: 224188 Accelerator pedal module, pedal sensor, sensor 1, sensor 2: Signals implausible Note: There may or may not be a drivability complaint associated with this fault.
BMW AG has issued a Delivery Stop (effective December 19, 2023) on certain Model Year 2023 BMW vehicles that were produced between February 10, 2023, and June 23, 2023. The Combined Charging Unit(CCU) may not have been built to specifications.
The Combined Charging Unit (CCU) may be affected by a manufacturing defect.
BMW AG has issued a Delivery Stop (effective December 1, 2022) on certain Model Year 2023 BMW i4 andi7 vehicles that were produced between October 5, 2022 and November 10, 2022. A bearing in the front electric drive unit could fail due to a manufacturing defect, resulting in a noise while driving.
The climate control system may be inoperative or perform irregularly. There may be: Lack of or irregular cooling power or air conditioning, No or poor heater output, Difference between left and right vent temperatures in the passenger area, Interference noises (clattering noise) coming from the electric A/C compressor (EKK).
Vehicle cannot be charged with either AC or DC, vehicle does not detect a charging cable. Charging indicator LED on the high voltage charging socket is permanently white. Check Control message "Charging not possible" is displayed sporadically. The following fault code stored in the CCU: 031B97 - AC charging, charging interface, charging plug detection: Electrical error.
The Sirius(r) Satellite Radio is inoperative.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。