These vehicles may not comply with c.M.V.S.S. 301 - fuel system integrity. Some welds in the left rear quarter panel may have been missed during assembly. In the event of a vehicle crash, the vehicle sheet metal structure may not perform as designed. This could result in unexpected damage to the fuel tank or fuel lines and leakage of fuel. If there is a fuel leak and an ignition source, a fire could occur. Correction: Dealers will inspect for missing welds and, if necessary, place three welds between the involved panels.
During assembly of the left rear quarter panel, some welds were missed. This does not comply with the requirements of fmvss no. 301, "fuel system integrity."
These vehicles were constructed with welds in the rear compartment pan assembly that are not sufficient to comply with the requirements pertaining to fuel tank leakage in the event of a rear impact collision. The fuel tank assemblies do not comply with fmvss no. 301, "fuel system integrity."
Vehicles may have improperly torqued connections of the front fuel feed/return hoses to the fuel pipes at the body rail. A fitting may loosen enough to leak fuel into the underhood area, and, in the presence of an ignition source, a fire could result. Correction: Front fuel feed/return hose fittings will be properly torqued.
On vehicles with quad 4 engines, the front fuel feed assembly could crack or separate at the coupling on the engine end of the assembly, allowing fuel to leak into the underhood area. This would create the possibility of an engine compartment fire. Correction: Front fuel feed hose assembly will be replaced on affected vehicles.
Front fuel feed hose assembly could crack or separate at the coupling on the engine end of the hose assembly, allowing fuel to leak into the engine compartment.
Under certaain conditions, the hose clamps on the fuel tank filler pipe and fuel tank filler vent pipe could fracture. The fracture of these clamps could cause fuel leakage at any of the four pipe to hose connections. Leakage can occur during refueling, or while driving, if the fuel tank is above 3/4 full.
These vehicles do not comply with c.M.V.S.S. 301 - fuel system integrity. Rear compartment pan welds may not meet manufacturing standards. Correction: Dealers are to install rivets adjacent to the locations where suspect welds may have occurred.
The vehicles were assembled with an incorrect suspension upper spring seat at the right-rear position. If the vehicle is involved in a rear impact accident, the right-hand rear wheel house flange could sever the fuel tank filler pipe and spill fuel.
Certain vehicles may not comply with CMVSS 1103 - Exhaust Emissions. Cracks may develop in the casing of the integrated direct ignition coil. Correction: Ignition coils will be inspected and replaced if necessary.
These vehicles do not comply with c.M.V.S.S. 1103 - exhaust emissions. - mass airflow sensor failure - note : Vehicles with 3.0 litre and 3.8 litre engines.
Fuel hoses may be incorrectly positioned and contact the right front drive axle boot during vehicle operation. After a period of time, the rotating boot could wear a hole in the fuel hose, resulting in fule leakage.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。