燃料ホース/パイプ
燃料パイプのナイロンチューブの材質が不適切なため、経時変化により当該チューブに 亀裂が発生することがある。そのため、当該パイプからから燃料が吹き出し、最悪の場合 、火災に至るおそれがある。
🔔 無料アカウントを作成して Cadillac エルドラド (すべての世代) のメール通知を受け取る
燃料パイプのナイロンチューブの材質が不適切なため、経時変化により当該チューブに 亀裂が発生することがある。そのため、当該パイプからから燃料が吹き出し、最悪の場合 、火災に至るおそれがある。
燃料システムのコモンレールの材質が劣化して亀裂が入り、その結果、燃料がエンジンルーム内に漏れる可能性があります。発火源が存在する場合、この状況は火災につながるおそれがあります。
燃料コモンレールへのナイロン製燃料チューブは劣化してひび割れを起こす場合があります。その結果、燃料漏れが発生し、最悪の場合は火災に至るおそれがあります。
いくつかの乗用車では、4.0L V8エンジンを搭載しており、フューエルレールの構造に使われているナイロン製チューブが劣化してひび割れる場合があります。さらに、1995年式では、エンジンフード下に独自の燃料リターンラインを採用しており、これにひび割れが生じる可能性があります。フューエルレールまたはリターンラインのチューブにひび割れが生じると、燃料がエンジンコンパートメント内に漏れ出すおそれがあります。
These vehicles may experience inadvertent deployment of one or both front air bags if the vehicle interior has been exposed to enough water to soak the carpet and enter the sdm (which is located under the driver's seat). Correction: Dealers will apply a sealer to the sdm to prevent water intrusion.
エンジン・オイル・クーラのアウトレット・ホースの配管が不適切なため、エア・コン ディショナ用コンプレッサのクラッチと干渉するものがあり、このままの状態で使用を続 けると、当該ホースが損傷し、最悪の場合、エンジン・オイルが漏れ、火災に至るおそれ がある。
もしエアコンコンプレッサーのクラッチ組立品が補助エンジンオイルクーラーの出口ホースに接触すると、ホースが摩耗して破れ、エンジンオイルがエンジンルーム内に漏れるおそれがあります。点火源が存在する場合、エンジンルームで火災が発生するおそれがあります。 是正措置:出口ホースを入口ホースに固定し、エアコンコンプレッサーのクラッチ組立品との十分なクリアランスを確保するため、タイラップを取り付けます。
エアコンのコンプレッサーのクラッチASSYが補助エンジンオイルクーラーのアウトホースに接触すると、ホースが摩耗して穴が開き、エンジンオイルがエンジンルーム内に漏れるおそれがあります。
原動機室内にある樹脂製燃料パイプ(供給側及び戻り側)の継手部において、当該燃料 パイプと金属製燃料パイプとの接続(はめ込み式)に不確実なものがあり、このままの状 態で使用を続けると、当該継手部から燃料が漏れ、最悪の場合、火災に至るおそれがある 。
On vehicles with the 4.6 litre gas engine, the fuel feed and return lines to the engine fuel injection system may not be fully assembled and locked. The lines may work loose with time and mileage causing a fuel leak in the engine compartment. If an ignition source is present, an engine compartment fire may occur. Correction: Dealers will inspect and, if necessary, adjust or replace the fuel feed and return lines to the engine fuel injection system.
The fuel feed and return lines to the engine fuel injection system were not fully assembled and locked. The lines can work loose, causing a fuel leak in the engine compartment.
中間シャフトからステアリングラック下側カップリングへのピンチボルトが欠落している可能性があります。これによりシャフトが外れ、ステアリング操作を失うおそれがあります。対策:車両を点検し、必要に応じてピンチボルトを取り付けます。
The intermediate shaft to steering rack lower coupling pinch bolt may be missing.
In the event of an accident requiring deployment of the driver's side air bag, the inflator module could separate and the air bag will not inflate as intended. In addition, separation of the inflator module may result in hot gases escaping into the occupant compartment, presenting the possibility of burn injury to vehicle occupants. Correction: The air bag inflator modules will be replaced.
On vehicles equipped with anti-lock brakes (abs), one or both abs hydraulic unit mounting bolts may not be properly seated. This could cause increased pedal travel and/or poor pedal feel if the attachment loosens. Also, the abs hydraulic unit could separate from its mounting bracket resulting in loss of brakes and a possible vehicle crash without prior warning. Correction: Abs hydraulic unit mounting bolts will be replaced.
One or both abs hydraulic unit mounting bolts may not be properly seated and could loosen.
Fluid intrusion into the driver's side window switch assemblies may cause an electrical short which can potentially cause the switches to overheat. This could result in a fire in the door panel area. Correction: Two window switch assemblies will be replaced with assemblies of a new design. In addition, 1984 models will have the window switch connectors replaced with connectors made of a flame retardant material. Note: Convertibles only are affected.
Water or snow dripping onto drivers side window switch assemblies may cause an electrical short and switches to overheat.
On certain vehicles, the crankshaft position sensors may fail and cause an intermittent engine chuggle, stall or possible long starting crank time and/or a no-start condition, as well as illumination of the Malfunction Indicator Lamp (MIL). Correction: Dealers will replace both crankshaft position sensors.
On certain vehicles, the inner tie rod nuts may be loose, which could result in separation of a tie rod. Separation of a tie rod could cause unexpected steering input in some maneuvers and could cause a crash without prior warning. Correction: Dealers will check the torque of the inner tie rod nuts and if necessary, adjust the vehicle toe-in and tighten the inner tie rod nuts to the specified torque.
Vehicle description: Passenger vehicles. The inner tie rod nuts are loose and can result in separation of a tie rod.
エアバッグの展開を制御するコンピュータの防水加工が不適切なため、車室内に大量の水 が浸入した場合、当該コンピュータ内部の電気回路が短絡し、エアバッグが展開するおそ れがある。
Vehicle description: Passenger vehicles. Inadvertent deployment of the air bags can occur due to water intrusion.
制動装置のコンピュータのプログラムの一部が不適切なため、ABSの作動が不要な通常 の制動時にABSが作動し、最悪の場合、制動距離が伸びるおそれがある。
The canister purge evaporative emissions harness on these vehicles may be misrouted. Under certain conditions the harness may interfere with the cruise control and throttle linkage. This could prevent return to closed throttle when the accelerator pedal is released, and could result in a vehicle crash without prior warning. Correction: Vehicles will be inspected for the correct harness routing and a plastic tie strap will be installed to positively locate the harness.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。