The fuel tank attachment strap fasteners are below the specified torque. These loose fasteners could, in time, become completely detached. This could allow the fuel tank to sag down to the point of striking something in the road or the road surface resulting in a possible fuel leak and an under-vehicle fire. Correction: Fuel tank strap fasteners will be torqued to the proper specifications.
On certain vehicles, the engine oil cooler inlet hose may contact the steering gear and wear through. This could allow engine oil to leak onto hot engine components and cause an engine compartment fire. Correction: Oil cooler hose will be repositioned and inspected. If wear is evident, the hose will be replaced.
The engine oil cooler inlet hose may have been installed too close to the steering gear causing chafing. The chafing can eventually wear through the hose's protective sleeve resulting in engine oil leaking onto the engine.
Note: Police and taxi vehicles only these vehicles have plastic fuel filter assemblies which may develop leaks. Such a leak could result in a fire due to static charge buildups found in the plastic fuel lines and filter which may act as an ignition source. Correction: A metal fuel filter and filter bracket will be installed on all involved vehicles.
The fuel feed and fuel return pipe assemblies includes a hose which may contact the pointed end of the radiator shroud attaching screw. This could cause a gasoline leak. Consequence of defect: If fuel leak develops it could result in an underhood fire and burn injuries to occupants.
Certain vehicles do not comply with CMVSS 124 - Accelerator Control Systems. At low temperatures there may be excessive movement friction in the accelerator pedal assembly. In the event of a failure of a throttle return spring the engine speed may not decrease to the level anticipated by the driver when the foot is lifted from the accelerator pedal. Loss of accelerator control could result in a vehicle crash without prior warning. Correction: Accelerator pedal assembly will be replaced.
These vehicles fail to conform to fmvss no. 124, "accelerator control systems." at low temperatures, excessive friction can occur in the accelerator pedal assembly.
A cruise control servo bail (bracket) 内の小さなナイロン製ブッシュが位置からずれることがあり、その結果、エンジン回転数の断続的な上昇やディーゼリング(エンジン停止後の異常燃焼による回転継続)が起こる可能性があります。この状態では、サーボロッドアセンブリがボールを摩耗させて他の部品に引っかかり、スロットルが固着する可能性もあります。その結果、車両の制御を失い、衝突事故につながるおそれがあります。
対策: クルーズコントロールのサーボバイルにブッシュキットを取り付けます。
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。