ステアリング:ステアリングホイール/ハンドルバー
亜鉛めっき処理を施したアッパーステアリングコラムシャフトのカップリングボルトに水素脆性が生じ、ボルトが破断した。
🔔 無料アカウントを作成して Chrysler ルバロン (すべての世代) のメール通知を受け取る
亜鉛めっき処理を施したアッパーステアリングコラムシャフトのカップリングボルトに水素脆性が生じ、ボルトが破断した。
ステアリングコラムのカップリングボルトが水素脆化により破断し、ステアリングコラムシャフトのカップリングにおける締結力が失われ、その結果ステアリング操作が効かなくなるおそれがあります。 是正措置:亜鉛メッキされたステアリングコラムカップリングボルトは、リン酸塩被膜処理されたボルトに交換されます。
Air bag inflator modules may not contain diffuser holes between the ignitor and propellant chambers.
エンジンのバルブカバーガスケットがずれて(脱落して)、ガスケット部分からエンジンオイルが漏れる場合があります。
車両が2.2リッターまたは2.5リッターEFI(ノンターボ)エンジンを搭載している場合、ヘッドカバーガスケットからオイルが漏れ、エンジンルーム内で火災が発生するおそれがあります。 是正措置:ヘッドカバーガスケットを、改良型のカバーに交換し、ガスケットの代わりにRTVシーラントを塗布します。
低温環境での運転時、エンジンルーム内の燃料供給ホースと、プレッシャーレギュレーターおよびフューエルレールとの接続部から燃料が漏れる場合があります。
A resister in the instrument cluster may be subjected to an electrical current overload due to failure of a switching transister.The overheated resister could possibly start a fire in the instrument panel.
コンビネーションメーターの電子回路内の抵抗器が、スイッチングトランジスタの故障により過大な電流にさらされる可能性があります。 不具合の結果:過熱した抵抗器が発火し、インストルメントパネルの火災を引き起こすおそれがあります。
On certain vehicles equipped with a 2.2 Litre turbo engine, an inadequately tightened fuel hose clamp at the fuel system pressure regulator could result in fuel leakage and provide the potential for an engine compartment fire.
An engine compartment fuel hose routed to the fuel system pressure regulator may have an inadequately tightened hose clamp. Consequence of defect: The fuel hose could leak and result in an engine compartment fire.
燃料漏れの可能性は、エンジンルーム内の燃料リザーバーの接合部およびそのホース接続部に存在します。燃料リザーバーは、エアクリーナーに取り付けられたシルバー色の缶状の部品です。
On certain vehicles, hydraulic brake tube may interfere with exhaust system hangar bolt and eventually result in brake fluid leakage. This could create a partial loss of braking capability. Should this occur the brake warning light on the instrument panel will warn driver.
Hydraulic brake tube routing to the rear wheels may alloow interference between the tube and the rear park brake cable. Resulting abrasion could cause tube failure and partial loss of braking capability. The instrument panel light will provide warning of the partial loss.
これらの車両はC.M.V.S.S 207(シートの取付け)に適合していない可能性があります。バケットシートを装着した一部の車両では、走行用シートバックル・ロックバー(シートベルトのアンカー)の強度が不十分な場合があり、本基準の静的荷重要件を満たさない可能性があります。是正措置:ロックバーASSYを交換します。
An improperly adjusted hood latch assembly could prevent engagement of the secondary latching mechanism. In such a case the secondary latch would not function to restrain the hood in the event that the primary latch was not engaged for any reason and hood fly-up could occur, blocking the driver's vision. Correction: Secondary hood latch will be inspected and adjusted if necessary, to ensure proper engagement.
The hood latch assembly may not have been properly installed and the secondary hood latch may be prevented from engaging when the hood is closed.
In areas of high road salt use, vehicles may experience a bonded disc brake pad separation from the front or rear brake plates. This could cause a reduction in brake performance and a possible vehicle crash. Correction: Bonded disc brake linings will be replaced on affected vehicles.
The bonded disc brake linings may separate from the shoes due to a bonding deficiency which may allow corrosion degradation of the bond attachment.
Parking brake cables may be mismatched in length resulting in reduced parking brake application on one wheel and so may not comply with c.M.V.S.S. 105-hydraulic brake systems. Correction: Vehicles will be inspected and those with mismatched cables will have the longer cable replaced with a shorter version.
On vehicles with a 50/50 bench seat, the front outboard passenger seat belt may become difficult to latch and/ or unlatch due to a belt webbing stiffener which could enter the buckle housing and dislodge the buckle latch guide. This could also result in partial latch engagement. Correction: Buckle assembly will be replaced with a revised version if necessary.
Front outboard safety belt may become difficult to latch and or unlatch due to a webbing stiffener entering the buckle housing and dislodging the buckle latch guide.
Mismatched parking brake cable lengths to the rear wheels reduces braking ability of one of the rear wheels, in violation of fmvss 105.
注意:対象車両はオンタリオ州、ケベック州、ニューブランズウィック州、ノバスコシア州、プリンスエドワード島州、ニューファンドランド州に所在する車両です。デイタイムランニングライトモジュールの腐食故障により、これらの車両はC.M.V.S.S.108(灯火装置)に適合しない可能性があります。 是正措置:DRLモジュールは、以前は露出していたすべての部品を覆う追加のポッティング材を備えたものに交換されます。
エアバッグシステムの前面衝突センサー2個が、取り付けブラケットに確実に固定されていない可能性があります。
フロントディスクキャリパーのガイドボルトが、規定のトルクで締め付けられていない可能性があります。これにより、ブレーキの作動に何らかの異常が生じるおそれがあります。 是正措置:フロントブレーキキャリパーのガイドピンボルトを規定トルクで締め付けます。
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。