The pressure regulator installed in the fuel supply plumbing system may be the source of fuel leakage which can cause an engine compartment fire. Correction: Fuel supply system pressure regulator and associated plumbing will be replaced with components of another configuration.
On certain vehicles equipped with a 2.2 Litre turbo engine, an inadequately tightened fuel hose clamp at the fuel system pressure regulator could result in fuel leakage and provide the potential for an engine compartment fire.
An engine compartment fuel hose routed to the fuel system pressure regulator may have an inadequately tightened hose clamp. Consequence of defect: The fuel hose could leak and result in an engine compartment fire.
Rear suspension trailing arm-to-hanger bracket pivot bolts may fail from stress corrosion cracking possibly caused by processing deviations in the construction of the pivot bolt.
These vehicles may experience a rear suspension trailing arm to hangar bracket pivot bolt failure, which could result in partial separation of the rear suspension from the vehicle. This could result in loss of vehicle control and a vehicle crash without prior warning. Correction: Involved vehicles will have both trailing arm pivot bolts replaced with properly processed bolts.
Battery cap vents may be partially or completely blocked with plastic flashing. Consequence of defect: A build up of internal gas pressure could occur which could result in case rupture, particularly during post charging. Should a person be in the vicinity of the battery when the case ruptures, they may be injured by the released gases and/or acid.
An emissions system valve may allow an overly rich mixture (excessive fuel) in the engine during deceleration. The mixture of air and excessive fuel can cause the engine to stall while stopping, coasting, or turning.
Involved vehicles may have been built with improperly forged or heat treated bolts used to attach the front suspension ball joints to the steering knuckles. Some of the bolts may eventually fail which could result in ball joint separation and affect vehicle directional controllability.
Clamp bolts installed on certain vehicles may contain cracks. Eventually these bolts may break through, causing separation of the ball joint from the steering knuckle.
On the involved vehicles, the bolts used to attach the front suspension ball joints to the control arms may fail due to a bolt section crack condition. The ball joint may separate from the arm possibly affecting vehicle directional control.
The engine compartment fuel line hoses installed on certain vehicles were fabricated from a defective rubber compound. When subjected to continuous high underhood temperatures, these hoses may become brittle and crack.
The hood secondary latch on the involved vehicles may be subject to binding due to variations in the latch and its mounting base assembly. A problem could occur if the primary latch became inoperative or was not properly engaged.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。