Vehicle description: Passenger vans and wagons equipped with compressed natural gas (cng). The fuel hose that connects the left and right fuel rails may shrink and leak fuel if exposed to high engine operating temperatures.
Vehicle description: Vans equipped with compressed natural gas (cng) fuel tanks. Incorrect fuel tank straps were installed on the small fuel tank. As a result, the fuel tank may not be securely attached to the vehicle.
On certain vehicles, the low pressure diesel fuel supply tube located in the engine compartment between the filter and the high pressure pump may fracture and leak, possibly resulting in an engine compartment fire. Correction: The steel low pressure diesel fuel supply tube will be replaced with a rubber isolated tube.
Vehicle description: Light duty pickup trucks equipped with 5.9l - 24 valve diesel engine. The low pressure diesel fuel supply tube located in the engine compartment between the filter and the high pressure pump can fracture.
On certain vehicles, an exhaust system heat shield attaching screw is too close to the underbody fuel line. Vibration and vehicle motion during normal vehicle operation may cause the fuel line to rub against the screw eventually resulting in fuel leakage. Correction: Heat shield attaching screw will be removed and replaced with a butyl rubber adhesive. Fuel tubes showing any signs of abrasion damage will be replaced.
Vehicle description: Light duty trucks equipped with either a 8.0l v-10 engine or a 5.9l v-8 heavy duty gasoline engine. An exhaust system heat shield attaching screw is too close to the underbody fuel line. The line can rub against the screw, possibly causing fuel leakage.
On certain vehicles, the fuel tank mounted rollover valve may allow liquid fuel to leak onto the ground under certain conditions. In the presence of an ignition source, a fire could occur. Correction: The fuel tank rollover valve will be replaced with a float type rollover valve.
Vehicle description: Light duty pickup trucks equipped with gasoline engines. The fuel tank mounted rollover valve can allow liquid fuel to leak onto the ground under certain vehicle operating conditions.
These vehicles do not comply with c.M.V.S.S. 301 - fuel system integrity. A routine rear impact compliance test resulted in fuel leakage during rollover stage in excess of that allowed by the standard. Correction: A rail reinforcement bracket will be installed to the undercarriage to prevent damage to the fuel tank filler nipple and hose.
Vehicle description: Pickup trucks equipped with diesel engines. The throttle cable could unravel (fray) or break resulting in loss of throttle control.
Certain vehicles equipped with the 5.9L Heavy Duty gasoline engine do not comply with the requirements of CMVSS 1101 - Emission Device. The emission system was not correctly programmed within the Powertrain Control Module (PCM) and the Emission Maintenance Reminder Light (EMR) does not illuminate as required. Correction: The PCM will be reprogrammed (reflashed) with the proper EMR light calibrations.
Certain full size pickups equipped with the Cummins Encore 24 valve diesel engine do not comply with the requirements of CMVSS 1103 - Exhaust Emissions. The fuel management system which advances fuel injector timing for better steady highway fuel economy, also increases the NOx emissions. Correction: Engine controller software will be reprogrammed.
On certain vehicles, a malfunction of the vehicle speed sensor can result in an intermittent high idle condition with speeds higher than expected by the operator. This could result in loss of vehicle control. Correction: The engine controller software will be changed to correct for erroneous speed sensor signals.
Vehicle description: Light duty pickup trucks equipped with 5.9l - 24 valve diesel engine. An intermittent high engine idle condition can occur due to a malfunction of the vehicle speed sensor.
Certain vehicles may not comply with CMVSS 1105 - evaporative emissions. The evaporative canister may allow migration of its contents (charcoal) through the purge system and into the engine. Missing charcoal may cause the vehicle to fail evaporative emissions testing. Correction: An improved evaporative canister and purge solenoid will be installed.
Certain Ram 3500 vehicles do not comply with CMVSS 1101 - emission device. The Vehicle emission warranty statement in the engine warranty manuals does not include the powertrain control module and the catalyst in the list of warranted emission control components. Correction: Owners will be sent a warranty manual insert with the correct information.
Certain vehicles do not comply with CMVSS 1103 - exhaust emissions. The elbow containing the crankcase ventilation orifice was installed on the wrong valve cover resulting in improper metering of crankcase gases being returned to the combustion chamber. Correction: Breather elbows will be reversed from one side of the engine to the other side.
Certain vehicles do not comply with CMVSS 1103 - exhaust emissions. The Emission Maintenance Reminder (EMR) light in the climate control module is either non-functional (will not illuminate) due to missing power and ground circuits to the bulb or, is missing entirely. Correction: Jumper cables will be installed and the climate control module will be replaced where necessary.
Certain vehicles do not comply with CMVSS 1103 - exhaust emissions. Vehicle emission control information label specifies an incorrect spark plug for this application. Correction: Correct label and installation instructions will be mailed to owners.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。