null Faulty crimping of the micro-gas generator for the seat belt tensioner means that, in the event of deployment of the seat belt tensioner, parts of the seat-belt pre-tensioner could detach causing injuries to the occupants.
null Faulty crimping of the micro-gas generator for the seat belt tensioner means that, in the event of deployment of the seat belt tensioner, parts of the gas generator could detach causing injuries to the occupants of the car.
De ABS-bedrading is ter plaatse van de acculade niet voldoende beschermd tegen beschadiging. Hierdoor ontstaat de kans dat de bedrading beschadigd raakt.
The layout of the ABS wiring maybe incorrect in the area of the battery holding unit. The wiring may on some vehicles maybe trapped and pinched exposing wiring in some area. this may cause damage and in extreme cases a potential risk of fire.
It has been identified that the tightening torque of the steering shaft upper fixing bolt may not be correct. This may result in the emission of noise and in extreme cases breakage of the shaft which will result in loss of steering control.
It has been identified that the tightening torque of the steering shaft upper fixing bolt may not be correct. This may result in the emission of noise and in extreme cases breakage of the shaft which will result in loss of steering control.
Prolonged exposure to the effects of road salt corrosion may result in perforation of the metal brake pipes and a consequential loss of braking efficiency.
The fuel vapour re-circulation pipe could foul against the air-conditioning compressor pulley resulting in possible damage to the pipe and the risk of fire.
On some Punto vehicles it has been found that the seat belt pre-tensioners may fail to activate although normal activation of the seat belt is assured.
On ABS equipped Punto vehicles contact may take place between the brake compensator springs and the rear (metal) brake pipes. This could damage the pipes causing loss of brake fluid and reducing the efficiency of the service brake.
It has been identified that the hand brake lever may not have been manufactured to the correct specification. It could result in the vehicle rolling away.
null The brake servo connector may not comply with the manufacturer's requirements, which could affect the braking ability of the vehicle, leading to the risk of an accident.
Fuel may leak as on some engines the fuel manifolds may not be to specification. If the fuel manifold leaks it is possible that a loss of power could occur and the engine cut out.
It has been identified that the possibility exists of interference between the heater/climate control wiring and a dashboard bracket due to a missing retainer clip. In this condition abrasion of the wiring may occur with the attendant risk of an electrical short circuit
Due to the possibility of a fault in the production process the flexible rubber brake hoses may not have been correctly vulcanised. As a consequence may partially or totally restrict the internal flow of the brake hydraulic fluid. Should this happen a reduction in efficiency during braking would occur.
Incorrect profile (flaring) of the end of the steering shaft at the upper steering column universal joint. This may give the possibility of the steering column becoming disconnected from the universal joint with a consequent loss of vehicle steering.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。