イグニッションシステム
点火スイッチが内部で短絡(ショート)を起こす可能性があります。
🔔 無料アカウントを作成して Ford EXP (すべての世代) のメール通知を受け取る
点火スイッチが内部で短絡(ショート)を起こす可能性があります。
イグニッションスイッチ内で短絡が発生し、過熱、発煙、そして最悪の場合ステアリングコラム内での火災につながるおそれがあります。この状態は、車両の使用中にも、無人の駐車中にも発生するおそれがあります。 是正措置:イグニッションスイッチを改良設計のスイッチに交換します。
1984年式では、シリンダーヘッドの外側に亀裂が生じることがあり、その結果、排気マニホールドへオイルが漏れるおそれがあります。1985年式では、エンジンのロッカーカバーガスケットが裂けることがあり、その場合も排気マニホールドへオイルが漏れるおそれがあります。これらいずれの状態も、オイルに引火してエンジンフード内火災が発生する可能性を生じさせます。 是正措置:1984年式では、シリンダーヘッドを点検し、外側に亀裂が見つかった場合は交換します。1985年式では、より新しい設計のものでない限り、ロッカーカバーガスケットを点検し、交換します。
1984年式では3番シリンダーの上部に外側の亀裂が入る場合があり、1985年式ではロッカーアームカバーガスケットが裂けることがあります。いずれもオイルが排気マニホールドに漏れる原因となる可能性があります。
車両によっては、右前ブレーキチューブと、エンジンに取り付けられたブラケットとの間のクリアランスが不十分な場合があります。特定の条件下では、ブラケットが金属製のブレーキチューブに接触し、チューブが摩耗する可能性があります。その結果、ブレーキフルードが漏れ、ブレーキ性能の一部が失われるおそれがあります。これにより制動距離が長くなります。
The front sleeve bushings of the cooling fan motors are susceptible to excessive corrosion in areas of high road salt use. This may increase the rotational friction of the fan motor or result in seizure of the armature shaft to the bushing. Either condition may draw current in excess of that of a normally operating motor but less than required to operate the fuse link. This could overheat the motor wiring circuitry and possibly result in an underhood or instrument panel fire. Vehicles affected: Cars not equipped with factory air conditioning. Quebec and atlantic provinces only.
These vehicles may not comply with C.M.V.S.S. 1103 - 排気ガス規制. The central fuel injector (CFI) may operate rich during certain operating conditions. 是正措置: 改良型CFIフューエルインジェクターを取り付け、アイドル回転数を調整します。
These vehicles do not comply with cmvss 1103 - exhaust emissions. Vehicles affected: 1.6 l engine and atx transmissions
The bolts that attach the d-shaped ring for the shoulder belt are inadequately supported by the material in which they are mounted. The attachment does not comply with the requirements of federal motor vehicle safety standard no. 210, "seat belt assembly anchorages".
The upper torso restraint d-ring which attaches the shoulder belt to the b pillar, under certain test conditions, separated from its anchorage, and may not comply with cmvss 210 - belt anchorage.
These vehicles may not comply with cmvss 1103 - exhaust emissions.
Two door models. Fatigue cracks may occur in the door lock pillars at the front door latch striker reinforcement attachment locations. The fatigue cracks may propogate to the extent that the structural integrity of the door latch striker attachment may be significantly reduced creating the possibility that the door may not be securely retained. This condition is observable by visibly noticeable cracks on the door lock pillar adjacent to the striker assemblies.
Door lock pillars could develop fatigue cracks from normal usage of door, at the point where door latch striker reinforcements are attached.
On the involved vehicles, a thermal limiter in the blower motor resistor circuit of the air conditioner/heater assembly may not function as intended. If the blower motor becomes jammed when the system is operating in the medium-low blower speed, the resistor coils can overheat causing melting and possible ignition.
Vehicles with optional air conditioning. The air conditioner blower motor thermal limiter may not operate as intended when there is a motor blockage or malfunction. Thus, if the blower motor becomes jammed when the system is operating in the medium-low blower speed mode, the resistor coils may overheat causing melting and possible ignition of the polyproplene evaporator housing with associated vehicle damage.
Vehicles equipped with power brakes. Power brake boosters may have bewen improperly assembled by supplier. Mis-indexing of rear shell of some boosters relative to the front shell may have resulted in inadequate crimping of the two shells. If booster were to separate during vehicle operation, complete loss of service brakes would result.
Some vehicles equipped with power brake boosters have front and rear shells that may have been improperly joined. Improperly joined booster shells may separate either partially or completely during brake application.
Vehicle may not meet the fuel spillage requirements of cmvss 301 - fuel system integrity.
Certain vehicles may not meet applicable minimum fuel spillage requirements of federal motor vehicle safety standard no. 301, "fuel system integrity". During a 30 mph rear impact test, fuel spillage limits were exceeded by vehicle.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。