When in the secondary latched position, the driver door latches may open when subjected to transverse loads less than that specified in fmvss no. 206, "door locks and door retention components."
The semi-automatic temperature control module may malfunction and cause erratic blower operation, high blower or no blower regardless of control position. Should the no blower condition occur, the vehicle's defroster may not clear the windshield of frost/fog. Correction: Dealers will inspect and if necessary, replace the semi-automatic temperature control module with a revised design module.
Under certain conditions, the climate control blower does not operate as intended. The blower could (1) stick on "high;" (2) operate erratically with blower output varying between no blower and maximum blower; or (3) not operate at all due to malfunction of the temperature control module.
Note: Thunderbird super coupe and cougar xr7 equipped with manual transmission and 3.8 litre supercharged engine. These vehicles may not comply with c.M.V.S.S. 1103 - exhaust emissions. Higher than anticipated exhaust system temperatures may cause damage to the exhaust system catalyst thereby increasing exhaust emission levels in excess of the standard. Correction: Dealers will replace exhaust system catalyst assembly and powertrain control module.
Note: This recall supersedes recall 91066 (91s32). A cable in the tension reliever mechanism in either the safety belts provided in the kits for recall 91066 (91s32) or the factory installed front safety belt assemblies may break or bind causing a malfunction in the retractor mechanism. Should this occur, the front safety belts may not retract after full extension. In this condition, the belted occupant will not be properly restrained if the vehicle is involved in a collision. Correction: Driver and front passenger safety belt assemblies will be replaced on affected vehicles.
Note: Vehicles equipped with 3.8 litre engines. These vehicles may not comply with c.M.V.S.S 1105 - evaporative emissions. Fuel vapour hose may not be connected at the fuel tank vapour valve. Correction: Vehicles will be inspected and fuel tank vapour hose will be reconnected where necessary.
The nuts which hold the wiper motor to the wiper module may not have been adequately tightened and may loosen or come off. If this happens, the wiper pattern may shift or, in some cases, the wiper may jam of two of the three nuts have come off. Jammed wipers could result in reduced driver visibility during inclement weather conditions. Correction: Mounting nuts/studs will be inspected for loctite and will be reinstalled and torqued with loctite if required.
The nuts which hold windshield wiper motor to the wiper module may not have been sufficiently tightened and may loosen or come off. This causes changed wiper patterns, or the wipers may jam if two of the three nuts come off.
Note: This recall superseded by recall 92-108. The front seat belts may not retract after extension due to a broken tension eliminator cable which is too long and prone to breakage. This could result in the seat occupant being inadequately restrained in the event of a collision. Correction: New front seat lap-shoulder belt assemblies that have a shorter tension eliminator cable will be installed on affected vehicles.
The automatic overdrive transmissions on these vehicles may be equipped with a park rod assembly that includes a park cam with inadequate surface hardness. This could result in high park disengagement forces or in no park engagement when the shift lever is placed in the park position. This in turn could result in an unpowered vehicle roll-away if the vehicle is parked on an incline with the parking brake off. Correction: Park rod assembly will be replaced on affected vehicles.
The park rod assembly contains a park cam with inadequate surface hardness, which could lead to park disengagement or no park engagement when the lever is placed in park.
Note: Vehicles equipped with automatic transmission and 3.8l supercharged engine. These vehicles do not comply with c.M.V.S.S. 1101- emission device. Incorrect decals, vehicle emission and control information.
Improperly heat treated rear suspension knuckles on these vehicles could experience high mileage fatigue cracks and eventual fracture. Should a fracture occur, the rear suspension at that wheel would not remain intact and vehicle control could be adversely affected. Correction: Vehicles will be inspected and suspect rear suspension knuckles will be replaced.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。