閲覧無料 · 投稿は無料アカウントでAnticars(2000年)の後継

Honda プレリュード

1978– · 6 世代 · 不具合16件 · 1市場
世代
年式
プレリュード II · 1982–1987プレリュード III · 1987–1991
リコール重大エンジンNA

Fuel system, gasoline

If the plastic coating of the fuel filler and/or breather pipe is damaged, salt water may accumulate between the plastic coating and the steel pipes, and the accumulation could cause corrosion which would eventually rust through the affected pipes, allowing gasoline fumes and fuel to leak.

NHTSA · 米国1993年4月15日92V028001モデルイヤー 1983–1987原文(英語)で表示中 · 翻訳待ち詳細を見る →
プレリュード II · 1982–1987プレリュード III · 1987–1991
リコール重大エンジンNA

Fuel System

On certain vehicles, road salt may cause the fuel filler and/or breather pipe to rust through, resulting in fuel leakage. In the presence of an igntion source a vehicle fire could occur. Correction: Vehicles will be inspected and repaired if necessary.

カナダ運輸省1992年3月6日1992025モデルイヤー 1983–1987原文(英語)で表示中 · 翻訳待ち詳細を見る →
プレリュード I · 1978–1982
リコール中程度エンジンUK

Ignition switch may fail

Electrical contacts within the ignition switch wear prematurely. This can eventually cause the engine to stall without warning.

DVSA · 英国2002年8月6日R/2002/071原文(英語)で表示中 · 翻訳待ち詳細を見る →
プレリュード V · 1996–2001
リコール中程度エンジンJP

始動装置

原動機の始動装置において、イグニッションスイッチの接点部に流れる電流値が大きい ため、主電源を入れる瞬間に大きなアーク放電が生じ、始動操作の繰り返しにより接点が 過度に摩耗して接触圧力が低下するため、走行時の振動等で接点が動き、炭化物に乗り上 げ導通不良となることがあり、最悪の場合、突然原動機が停止するおそれがある。 なお、始動操作で、接点が摺動し炭化物を除去するため、再始動は可能である。

国土交通省 · 日本2002年5月24日1108420モデルイヤー 1996–1999詳細を見る →
プレリュード IV · 1991–1996
リコール中程度エンジンJP

エンジン本体

原動機において、バランサーシャフトのオイルシールの組付け指示が不適切なため、その ままの状態で使用を続けると、シールの保持力が低下し、最悪の場合、当該シールが抜け 出し、エンジンオイルが漏れるおそれがある。

国土交通省 · 日本2000年9月19日1106710モデルイヤー 1993–1995詳細を見る →
プレリュード III · 1987–1991
リコール中程度エンジンNA

Engine

On certain vehicles, the accelerator pedal stopper may be bent when excessive downward force is applied after the pedal has contacted the stopper. In the worst case, the edge of the pedal can be caught and held down by the bent stopper. This could result in loss of vehicle control and a crash without prior warning. Correction: A support will be installed to prevent the stopper from bending.

カナダ運輸省1989年6月12日1989085モデルイヤー 1988原文(英語)で表示中 · 翻訳待ち詳細を見る →
プレリュード III · 1987–1991
リコール中程度エンジンNA

Engine

On certain Prelude SI vehicles, throttle body castings may contain slight porosity. During vehicle usage, coolant seepage may occur and eventually residue may accumulate on the throttle valve. The residue could cause the throttle valve to return slowly from the slightly open position to the idle position when the accelerator pedal is released. Correction: The throttle body assembly will be replaced.

カナダ運輸省1987年8月5日1987080モデルイヤー 1988原文(英語)で表示中 · 翻訳待ち詳細を見る →
プレリュード III · 1987–1991
リコール中程度エンジンNA

Vehicle speed control

A small amount of coolant seepage may occur, and eventually residue may accumulate on the throttle valve.

NHTSA · 米国1987年8月4日87V122000モデルイヤー 1988原文(英語)で表示中 · 翻訳待ち詳細を見る →

出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。