Issue: On certain vehicles, the occupant classification system (OCS) may not work properly due to interference between seat components. As a result, the airbag system can turn off the passenger-front airbag even when a passenger is seated in the front passenger seat. Note: This recall only affects certain vehicles equipped with the Executive package. Safety Risk: An airbag system that does not work properly could increase the risk of injury in a crash. Corrective Actions: Lexus will notify owners by mail and advise you to take your vehicle to a dealership to inspect the front passenger seat. If interference is found, the dealer will adjust the seat as necessary, and re-calibrate the occupant classification system.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2019 Lexus LS500, LC500, ES300h, UX250h, LS500h, Toyota Prius, RAV4 HV, 2019-2020 Toyota Prius Prime, and 2020 Corolla HV vehicles. The brake booster pump may fail causing a deactivation of the Vehicle Stability Control system and a loss of braking assist. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 126, "Electronic Stability Control Systems."
Due to an incorrect tyre to wheel assembly process, the sidewall reinforcement layer may become damaged. Under certain driving conditions, parts of the tyre tread layer could consequently separate, causing a reduction of vehicle stability and increasing the risk of a crash.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2018 Lexus LS vehicles equipped with run-flat tires with a sidewall reinforcement layer inside the tire. The tire-on-wheel assembly process may have caused the reinforcement layer to crack, possibly resulting in the tire tread layer separating from the tire.
Toyota Motor Engineering & Manufacturing(Toyota)は、パノラミックビューモニター(PVM)システムを搭載した2022〜2026年式の一部Toyota、Lexus、Subaru Solterra車両のリコールを実施しています。対象車種の全一覧については、リコール報告書をご参照ください。ソフトウェアの不具合により、車両の後退時にバックカメラが静止したり、画面が真っ黒になったりするおそれがあります。このため、これらの車両は連邦自動車安全基準(FMVSS)第111号「後方視界(Rear Visibility)」の要件を満たしていません。
조수석 시트의 조립과정이 부적절하여 조수석 승객감지 센서와 시트 프레임이 간섭되어 조수석 승객 하중을 올바르게 감지하지 못할 수 있으며, 이런 경우 조수석 승객 하중에 따른 에어백 전개제어가 의도한대로 작동되지 않아 사고기 조수석 탑승자의 부상 위험이 증가할 수 있는 가능성에 따른 리콜
<*대상차량별 생산일자>
렉서스 LS500 AWD: 2017.07.26~2021.04.19
렉서스 LS500h AWD: 2017.10.11~2021.04.15
렉서스 LS500h 2WD: 2017.02.20
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2018-2021 Lexus LS500 and 2018-2020 Lexus LS500 Hybrid vehicles equipped with the "Executive Package." The front passenger seat may have been assembled with interference between internal parts that can cause the Occupant Classification System (OCS) sensor to incorrectly detect the occupant. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 208, "Occupant Crash Protection."
Issue: Under certain conditions, a software problem could cause a delay before the rearview camera image displays. Canadian regulations require the rearview image to display within 2 seconds of shifting the transmission into reverse gear. Safety Risk: A rearview camera image that's slow to display could reduce a driver's ability to see behind the vehicle while backing up. This could increase the risk of a crash. Corrective Actions: Lexus will notify owners by mail and advise you to take your vehicle to a dealership to update the parking assist electronic control unit software.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2023 Mirai, Lexus LS500, LS500H, 2023-2024 Lexus ES250, ES300H, ES350, 2024 Lexus LC500, and LC500H vehicles equipped with a Panoramic View Monitor (PVM) system. Due to incorrect programming of the parking-assist electronic control unit (ECU) software, the rearview camera image may not immediately display within a couple of seconds after the shifter is placed into reverse. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."
On affected vehicles there is a possibility that the DCM may not complete the shutdown process within a specific period of time when the ignition is turned off causing the DCM to not restart at the next ignition cycle and making the e-Call function unavailable. As a result the vehicles do not comply with relevant regulations.
Due to a manufacturing defect, surface cracking may occur on the impeller of the low-pressure fuel pump. Consequently, the impeller may deform, causing the fuel pump to become inoperative and the engine to stall, increasing the risk of an accident.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)、国土交通省(日本、公共データ利用規約1.0)、韓国国土交通部(car.go.kr)。