There is a possibility that the resin weld between the fuel tank and the fuel inlet pipe may be insufficient because the fuel tank and fuel inlet pipe were misaligned during the manufacturing process.
On certain vehicles, the electrical power cords of some dealer installed block heaters may have been improperly manufactured, causing the wires to contact each other, resulting in a short circuit. A short circuit could lead to a fire which would increase the risk of injury and/or damage to property. Correction: For vehicles where the subject block heater was approved for installation, the dealer will replace the block heater assembly with a new one of an improved design. For vehicles where the subject block heater was not approved for installation, dealers will remove the block heater assembly. In the interim, until the remedy can be performed, dealers will cut the plug end from the block heater cord to disable the block heater's operation.
null A crack could develop in the fuel evaporative emission control unit which is attached to the fuel tank. When the fuel tank is full, fuel could leak from the crack which, in the presence of an ignition source, could lead to a vehicle fire.
null Welded parts of the inflator in each of the curtain shield air bags could have a minute crack. If the crack propagates over time, part of the inflator could separate causing compressed gas to escape. This would result in partial inflation of the curtain shield air bag, and, in limited circumstances, one or both sections of the inflator could enter the interior of the vehicle. If an occupant is present in the vehicle, this could lead to injuries.
On certain vehicles, a defect in the curtain shield airbags could cause the inflator to fail, releasing pressurized gas into the airbag, partially inflating it. If this occurs, parts of the inflator could also separate from the vehicle structure, entering the interior of the vehicle. Should this occur when occupants are in the vehicle, unintended airbag deployment could startle the driver, and airbag inflator parts could come into contact with the occupants, increasing the risk of injury and a crash. Correction: Dealers will install a retention bracket which will prevent the inflator parts from entering the vehicle interior.
出典:NHTSA(米国、パブリックドメイン)、カナダ運輸省(Open Government Licence – Canada)、DVSA(英国、Open Government Licence v3.0)、RappelConso および EU Safety Gate(フランス、Licence Ouverte 2.0)。